TI,TI公司,TI代理商
TI(德州仪器)| TI产品型号搜索
专营TI元器件,强大的现货交付能力,解决您的采购难题
全流程提供TI现货供应链服务
当前位置:TI公司 > > TI芯片 >> UCC28514
UCC28514技术文档下载:
UCC28514技术文档产品手册下载
UCC28514 - 产品图解:
UCC28514-高级 PFC/PWM 组合控制器
承诺原装正品
专营TI,真正优化您的供应链
TI产品 - UCC28514介绍
UCC28514 - 高级 PFC/PWM 组合控制器

UCC28514是TI公司的一款功率因数校正产品,UCC28514是高级 PFC/PWM 组合控制器,本页介绍了UCC28514的产品说明、应用、特性等,并给出了与UCC28514相关的TI元器件型号供参考。

UCC28514 - 高级 PFC/PWM 组合控制器 - 功率因数校正 - 离线隔离型DC/DC控制器和转换器 - TI公司(Texas Instruments,德州仪器)

产品描述

The UCC28510 series of combination PFC/PWM controllers provide complete control functionality for any off-line power system requiring compliance with the IEC1000–3–2 harmonic reduction requirements. By combining the control and drive signals for the PFC and the PWM stages into a single device, significant performance and cost benefits are gained. By managing the modulation mechanisms of the two stages (leading-edge modulation for PFC and trailing-edge modulation for PWM), the ripple current in the boost capacitor is minimized.

Based on the average current mode control architecture with input voltage feedforward of prior PFC/PWM combination controllers, these devices offer performance advantages. Two new key PWM features are programmable maximum duty cycle and the 2x PWM frequency options to the base PFC frequency. For the PFC stage, the devices feature an improved multiplier and the use of a transconductance amplifier for enhanced transient response.

The core of the PFC section is in a three-input multiplier that generates the reference signal for the line current. The UCC28510 series features a highly linearized multiplier circuit capable of producing a low distortion reference for the line current over the full range of line and load conditions. A low-offset, high-bandwidth current error amplifier ensures that the actual inductor current (sensed through a resistor in the return path) follows the multiplier output command signal. The output voltage error is processed through a transconductance voltage amplifier.

The transient response of the circuit is enhanced by allowing a much faster charge/discharge of the voltage amplifier output capacitance when the output voltage falls outside a certain regulation window. A number of additional features such as UVLO circuit with selectable hysteresis levels, an accurate reference voltage for the voltage amplifier, zero power detect, OVP/enable, peak current limit, power limiting, high-current output gate driver characterize the PFC section.

The PWM section features peak current mode control (with a ramp signal available to add slope compensation), programmable soft-start, accurate maximum duty cycle clamp, peak current limit and high-current output gate driver. The oscillator for the combination controller is available in two versions. In UCC28510, UCC28511, UCC28512, and UCC28513, the PWM and the PFC circuits are switched at the same frequency. In the UCC28514, UCC28515, UCC28516, and UCC28517, the PWM stage frequency is twice that of the PFC frequency. The PWM stage is suppressed until the PFC output has reached 90% of its programmed value during startup. During line dropout and turn off, the device allows the PWM stage to operate until the PFC output has dropped to 47% (UCC28512, UCC28513, UCC28516, and UCC28517) or 71% (UCC28510, UCC28511, UCC28514, and UCC28515) of its nominal value. See available options table on page 1 for a summary of options.

The UCC28510 family also features leading-edge modulation for the PFC stage and trailing-edge modulation for the PWM stage in order to reduce the ripple current in the boost output capacitor. The current amplifier implementation associated with this scheme also results in better noise immunity.

Available in 20-pin N and DW packages.

产品特性

  • Provides Control of PFC and PWM Power Stages In One Device
  • Leading-Edge PFC, Trailing-Edge PWM Modulation for Reduced Ripple
  • Built-In Sequencing of PFC and PWM Turn-On
  • 2-A Source and 3-A Sink Gate Drive for Both PFC and PWM Stages
  • Typical 16-ns Rise Time and 7-ns Fall Time into 1-nF Loads
  • PFC Features
    • Average-Current-Mode Control for Continuous Conduction Mode Operation
    • Highly-Linear Multiplier for Near-Unity Power Factor
    • Input Voltage Feedforward Implementation
    • Improved Load Transient Response
    • Accurate Power Limiting
    • Zero Power Detect
  • PWM Features
    • Peak-Current-Mode Control Operation
    • 1:1 or 1:2 PFC:PWM Frequency Options
    • Programmable maximum duty cycle
    • Programmable Soft-Start
    • Two Hysteresis Options for Differing Hold-Up Time Requirements

下面可能是您感兴趣的TI公司功率因数校正元器件
  • LMK04806 - 具有双级联 PLL 和集成 2.5 GHz VCO 的低噪声时钟抖动消除器
  • SN74LVC1T45-Q1 - SN74LVC1T45-Q1
  • SN74HC174 - 具有清零功能的十六路 D 类触发器
  • ADS8324 - 14 位 50kSPS ADC,具有串行输出和 1.8V 工作电压
  • CD74HCT112 - 具有设置和复位功能的高速 CMOS 逻辑双路下降沿 J-K 触发器
  • MSP430F5504 - 混合信号微处理器
  • ADS4222 - 12 位 65MSPS 双路低功耗 ADC
  • DRV8805 - 具有片上分度器的 2.0A 单极步进电机驱动器(Step/Dir 控制器)
  • DAC2904 - 14 位 125MSPS 双路通信 DAC
  • ADS7865 - 双路、2MSPS、12 位、3+3 或 2+2 通道、同步采样 ADC
  • 节约时间成本,提高采购效率,TI官网授权代理
    TI公司|TI德州仪器|德州仪器TI公司代理商|TI芯片代理商
    TI公司产品现货专家,订购TI公司产品不限最低起订量,TI产品大陆现货即时发货,香港库存3-5天发货,海外库存7-10天发货
    寻找全球TI代理商现货货源 - TI公司(德州仪器)电子元件在线订购