CD4541B-MIL - CMOS 可编程定时器 - 高电压类型（额定 20V）

CD4541B-MIL是TI德州仪器公司的一款比率乘法器/分频器/定时器产品，CD4541B-MIL是CMOS 可编程定时器 - 高电压类型（额定 20V），本站介绍了CD4541B-MIL的封装应用图解、特点和优点、功能等，并给出了与CD4541B-MIL相关的TI元器件型号供参考。

CD4541B-MIL - CMOS 可编程定时器 - 高电压类型（额定 20V） - 比率乘法器/分频器/定时器 - 特殊逻辑 - 德州仪器

产品描述

CD4541B programmable timer consists of a 16-stage binary counter, an oscillator that is controlled by external R-C components (2 resistors and a capacitor), an automatic power-on reset circuit, and output control logic. The counter increments on positive-edge clock transitions and can also be reset via the MASTER RESET input.

The output from this timer is the Q or Q\ output from the 8th, 10th, 13th, or 16th counter stage. The desired stage is chosen using time-select inputs A and B (see Frequency Select Table).

The output is available in either of two modes selectable via the MODE input, pin 10 (see Truth Table). When this MODE input is a logic "1", the output will be a continuous square wave having a frequency equal to the oscillator frequency divided by 2N. With the MODE input set to logic "0" and after a MASTER RESET is initiated, the output (assuming Q output has been selected) changes from a low to a high state after 2N-1 counts and remains in that state until another MASTER RESET pulse is applied or the MODE input is set to a logic "1".

Timing is initialized by setting the AUTO RESET input (pin 5) to logic "0" and turning power on. If pin 5 is set to logic "1", the AUTO RESET circuit is disabled and counting will not start until after a positive MASTER RESET pulse is applied and returns to a low level. The AUTO RESET consumes an appreciable amount of power and should not be used if low-power operation is desired. For reliable automatic power-on reset, VDD should be greater than 5V.

The RC oscillator, shown in Figure 2, oscillates with a frequency determined by the RC network and is calculated using:

Where f is between 1kHz and 100kHz and RS and 2RTC.

产品特性

Low Symmetrical Output Resistance, Typically 100 at VDD = 15V
Built-In Low-Power RC Oscillator
Oscillator Frequency Range . . . DC to 100kHz
External Clock (Applied to Pin 3) can be Used Instead of Oscillator
Operates as 2 N Frequency Divider or as a Single-Transition Timer
Q/Q\ Select Provides Output Logic Level Flexibility
AUTO or MASTER RESET Disables Oscillator During Reset to Reduce Power Dissipation
Operates With Very Slow Clock Rise and Fall Times
Capable of Driving Six Low Power TTL Loads, Three Low-Power Schottky Loads, or Six HTL Loads Over the Rated Temperature Range
Symmetrical Output Characteristics
100% Tested for Quiescent Current at 20V
5V, 10V, and 15V Parametric Ratings
Meets All Requirements of JEDEC Standard No. 13B, "Standard Specifications for Description of ’B’ Series CMOS Devices"

Data sheet acquired from Harris Semiconductor

下面可能是您感兴趣的TI德州仪器公司比率乘法器/分频器/定时器元器件

TI公司产品现货专家，订购TI公司产品不限最低起订量，TI芯片大陆现货即时发货，香港库存3-5天发货，海外库存7-10天发货

寻找全球TI代理商现货货源 - TI公司（德州仪器）电子元件在线订购