

- AFE159P4RGZR - 集成电路(IC) > 数据采集 > 模拟前端(AFE)
- DS90LV017ATMX - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- LM3530UME-25A/NOPB - 集成电路(IC) > 电源管理(PMIC) > LED 驱动器
- SN74LV541ATDGVR - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- BQ27532EVM-656 - 开发板,套件,编程器 > 评估板 > 评估和演示板及套件
- LP3905SDX-30 - 电源管理IC - 电源管理 - 专用型
- TPS65921B1ZBHR - 集成电路(IC) > 电源管理(PMIC) > 电源管理 - 专用
- TPS77101QDGKRQ1 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- TPS22968NQDMGTQ1 - 集成电路(IC) > 电源管理(PMIC) > 配电开关,负载驱动器
- LM3S9B96-IBZ80-C5 - 集成电路(IC) > 嵌入式 > 微控制器
- MC3303PWR - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- LMV931MG-NS - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- LM74CIM-5 - 传感器,变送器 > 温度传感器 > 模拟和数字输出
- SN74ALS32NS - 集成电路(IC) > 逻辑 > 门和反相器
- UCC3961DTR - 集成电路(IC) > 电源管理(PMIC) > DC-DC 开关控制器
- BQ3285P-SB2 - 集成电路(IC) > 时钟/定时 > 实时时钟
- TPS2058AEVM-295 - 评估和演示板及套件
- ADS7841PB - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- SN74ALVC16244AGQLR - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- DRV5056Z1QDBZT - 传感器,变送器 > 磁性传感器 > 线性、罗盘(IC)



CD74HCT423 - 具有复位功能的高速 CMOS 逻辑双路可重触发单稳多频振荡器
CD74HCT423是TI德州仪器公司的一款单稳多频振荡器产品,CD74HCT423是具有复位功能的高速 CMOS 逻辑双路可重触发单稳多频振荡器,本站介绍了CD74HCT423的封装应用图解、特点和优点、功能等,并给出了与CD74HCT423相关的TI元器件型号供参考。
CD74HCT423 - 具有复位功能的高速 CMOS 逻辑双路可重触发单稳多频振荡器 - 单稳多频振荡器 - 特殊逻辑 - 德州仪器
The HC123, HCT123, CD74HC423 and CD74HCT423 are dual monostable multivibrators with resets. They are all retriggerable and differ only in that the 123 types can be triggered by a negative to positive reset pulse; whereas the 423 types do not have this feature. An external resistor (RX) and an external capacitor (CX) control the timing and the accuracy for the circuit. Adjustment of Rx and CX provides a wide range of output pulse widths from the Q and Q\ terminals. Pulse triggering on the A\ and B inputs occur at a particular voltage level and is not related to the rise and fall times of the trigger pulses.
Once triggered, the output pulse width may be extended by retriggering inputs A\ and B. The output pulse can be terminated by a LOW level on the Reset (R) pin. Trailing edge triggering (A)\ and leading edge triggering (B) inputs are provided for triggering from either edge of the input pulse. If either Mono is not used each input on the unused device (A\, B, and R\) must be terminated high or low.
The minimum value of external resistance, Rx is typically 5k. The minimum value external capacitance, CX, is 0pF. The calculation for the pulse width is tW = 0.45 RXCX at VCC = 5V.
- Overriding Reset Terminates Output Pulse
- Triggering From the Leading or Trailing Edge
- Q and Q\ Buffered Outputs
- Separate Resets
- Wide Range of Output-Pulse Widths
- Schmitt Trigger on Both A\ and B Inputs
- Fanout (Over Temperature Range)
- Standard Outputs . . . . . . . . . . . . . . . 10 LSTTL Loads
- Bus Driver Outputs . . . . . . . . . . . . . 15 LSTTL Loads
- Wide Operating Temperature Range . . . 55°C to 125°C
- Balanced Propagation Delay and Transition Times
- Significant Power Reduction Compared to LSTTL Logic ICs
- HC Types
- 2V to 6V Operation
- High Noise Immunity: NIL = 30%, NIH = 30% of VCC at VCC = 5V
- HCT Types
- 4.5V to 5.5V Operation
- Direct LSTTL Input Logic Compatibility, VIL = 0.8V (Max), VIH = 2V (Min)
- CMOS Input Compatibility, Il 1µA at VOL, VOH
- ISO7131CC - 4242-VPK 小封装低功耗三通道数字隔离器
- LM5001 - 宽输入电压 1A 开关模式稳压器
- CSD19537Q3 - CSD19537Q3,100V N 沟道 NexFET(TM) 功率 MOSFET
- TLC5947 - 24-Channel, 12-Bit PWM LED Driver with Internal Oscillator
- TPS54350 - 具有低侧栅极驱动器的 4.5V 至 20V 输入、3A 同步降压 SWIFT? 转换器
- SN74LVC2G53 - 单极、双闸 (SPDT) 模拟开关或 2:1 模拟多路复用器/多路解复用器
- LMC555 - 用于生成准确延时和振荡的低功耗 555 定时器
- SN5402 - 四路 2 输入正或非门
- TPS62304 - 采用 QFN 或芯片级封装的 1.2V 500mA 输出的 3MHz 降压转换器
- SN65HVD53 - 带使能信号的高输出全双工 RS-485 驱动器和接收器



