• Drives an External MOSFET With PWM to Control Solenoid Current
  • External Sense Resistor for Regulating Solenoid Current
• Fast Ramp-Up of Solenoid Current to Guarantee Activation
• Solenoid Current is Reduced in Hold Mode for Lower Power and Thermal Dissipation
• Ramp Peak Current, Keep Time at Peak Current, Hold Current, and PWM Clock Frequency Can Be Set Externally. They Can Also Be Operated at Nominal Values Without External Components.
• Internal Supply Voltage Regulation
  • 15-V Nominal MOSFET Gate Drive Voltage
  • External Pullup Resistor to Solenoid Supply Voltage
• Protection
  • Thermal Shutdown
  • Undervoltage Lockout (UVLO)
  • Maximum Ramp Time
  • Optional STATUS Output
• Operating Temperature Range: –40ºC to 105 ºC
• 8-Pin and 14-Pin TSSOP Package Options

• Electromechanical Drivers: Solenoids, Valves, Relays
• White Goods, Solar, Transportation

The DRV110 device is a PWM current controller for solenoids. The device is designed to regulate the current with a well-controlled waveform to reduce power dissipation. The solenoid current is ramped up fast to ensure opening of the valve or relay. After initial ramping, the solenoid current is kept at peak value to ensure the correct operation, after which it is reduced to a lower hold level in order to avoid thermal problems and reduce power dissipation.

The peak current duration is set with an external capacitor. The current ramp peak and hold levels, as well as PWM frequency can independently be set with external resistors. External setting resistors can also be omitted, if the default values for the corresponding parameters are suitable for the application.

The DRV110 limits its own supply at VIN to 15 V and uses the same voltage level for the gate drive voltage of the external switching device. Typical application uses a MOSFET to drive the solenoid load.