• Highest Integration Controller for Small Form Factor, High-Density Power Converters
• High-Voltage Start-Up Regulator
• Intelligent Sync Rectifier Start-Up Allows Linear Turnon Into Prebiased Loads
• Synchronous Rectifiers Disabled in UVLO mode and Hiccup Mode
• Two Independent, Programmable Synchronous Rectifier Dead-Time Adjustments
• Four High-Current 2-A Bridge Gate Drivers
• Wide-Bandwidth Optocoupler Interface
• Configurable for Either Current Mode or Voltage Mode Control
• Dual-Mode Overcurrent Protection
• Resistor Programmed 2-MHz Oscillator
• Programmable Line UVLO and OVP

• E-Bike
• Military: Radar and Electronic Warfare
• Power: Telecom DC-DC Module: Analog
• Private Branch Exchange (PBX)
• Solar Power Inverters
• Vector Signal Generators
• Microwave Ovens
• Point-to-Point Microwave Backhaul
• Power: Telecom/Server AC/DC Supply: Dual Controller: Analog
• Solar Micro-Inverters
• TETRA Base Stations
• Washing Machine: Low-End

The LM5045 PWM controller contains all of the features necessary to implement full-bridge topology power converters using either current mode or voltage mode control. This device is intended to operate on the primary side of an isolated DC-DC converter with input voltage up to 100 V. This highly integrated controller-driver provides dual 2-A high-side and low-side gate drivers for the four external bridge MOSFETs plus control signals for the secondary-side synchronous rectifier MOSFETs. External resistors program the leading and trailing edge dead-time between the main and synchronous rectifier control signals. Intelligent start-up of the synchronous rectifiers allows monotonic turnon of the power converter even with prebias load conditions. Additional features include cycle-by-cycle current limiting, hiccup mode restart, programmable soft-start, synchronous rectifier soft-start, and a 2-MHz capable oscillator with synchronization capability and thermal shutdown.