

- OPA4234UA/2K5 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TAS5352DDV6EVM - 开发板,套件,编程器 > 评估板 > 音频放大器评估板
- MSP430F5436AIPZ - 集成电路(IC) > 嵌入式 > 微控制器
- SN65LVDM180PW - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- ADS8322Y/2K - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- TL432LIBQDBZR - 集成电路(IC) > 电源管理(PMIC) > 电压基准
- LMP2232AMAE/NOPB - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TPS53511RGTT - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- AM26LS31CDE4 - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- VCA822IDRG4 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- UCC27200ADR - 集成电路(IC) > 电源管理(PMIC) > 栅极驱动器
- SNJ55LVDS31W - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- BQ29312ARTHR - 集成电路(IC) > 电源管理(PMIC) > 电池管理
- LM341T-5.0/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- LP2992AIM5X-1.5 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- SN74BCT25245NSR - 逻辑 - 缓冲器,驱动器,接收器,收发器
- CDC208NSG4 - 集成电路(IC) > 时钟/定时 > 时钟缓冲器,驱动器
- MSPM0L1105TRTRR - 集成电路(IC) > 嵌入式 > 微控制器
- ADC122S706CIMTX/NOPB - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- SN75ALS194NG4 - 集成电路(IC) > 接口 > 驱动器,接收器,收发器



MSP430F5304 - MSP430F530x 混合信号微处理器
MSP430F5304是TI德州仪器公司的一款低功耗高性能产品,MSP430F5304是MSP430F530x 混合信号微处理器,本站介绍了MSP430F5304的封装应用图解、特点和优点、功能等,并给出了与MSP430F5304相关的TI元器件型号供参考。
MSP430F5304 - MSP430F530x 混合信号微处理器 - 低功耗高性能 - 低功耗MCU - 德州仪器
The Texas Instruments MSP430 family of ultra-low-power microcontrollers consists of several devices featuring different sets of peripherals targeted for various applications. The architecture, combined with five low-power modes, is optimized to achieve extended battery life in portable measurement applications. The device features a powerful 16-bit RISC CPU, 16-bit registers, and constant generators that contribute to maximum code efficiency. The digitally controlled oscillator (DCO) allows the device to wake up from low-power modes to active mode in less than 5µs.
The MSP430F5310, MSP430F5309, and MSP430F5308 devices are microcontroller configurations with a 3.3-V LDO, four 16-bit timers, a high-performance 10-bit analog-to-digital converter (ADC), two universal serial communication interfaces (USCIs), a hardware multiplier, DMA, a real-time clock (RTC) module with alarm capabilities, and 31 or 47 I/O pins.
The MSP430F5304 device is a configuration with a 3.3-V LDO, four 16-bit timers, a high-performance 10-bit ADC, two USCIs, a hardware multiplier, DMA, an RTC module with alarm capabilities, and 31 I/O pins.
Typical applications for this device include analog and digital sensor systems, digital motor control, remote controls, thermostats, digital timers, and hand-held meters.
- Low Supply-Voltage Range: 3.6 V Down to 1.8 V
- Ultra-Low-Power Consumption
- Active Mode (AM), All System Clocks Active
- 195 µA/MHz (Typical) at 8 MHz, 3 V, Flash Program Execution
- 115 µA/MHz (Typical) at 8 MHz, 3 V, RAM Program Execution
- Standby Mode (LPM3)
- Real-Time Clock (RTC) With Crystal, Watchdog, and Supply Supervisor Operational, Full RAM Retention, Fast Wake Up: 1.9 µA (Typical) at 2.2 V, 2.1 µA (Typical) at 3 V
- Low-Power Oscillator (VLO), General-Purpose Counter, Watchdog, and Supply Supervisor Operational, Full RAM Retention, Fast Wake Up: 1.4 µA (Typical) at 3 V
- Off Mode (LPM4) Full RAM Retention, Supply Supervisor Operational, Fast Wake Up: 1.1 µA at 3 V (Typical)
- Shutdown Mode (LPM4.5) 0.18 µA at 3 V (Typical)
- Active Mode (AM), All System Clocks Active
- Wake Up From Standby Mode in Less Than 5µs
- 16-Bit RISC Architecture, Extended Memory, Up to 25-MHz System Clock
- Flexible Power Management System
- Fully Integrated LDO With Programmable Regulated Core Supply Voltage
- Supply Voltage Supervision, Monitoring, and Brownout
- Unified Clock System
- FLL Control Loop for Frequency Stabilization
- Low-Power Low-Frequency Internal Clock Source (VLO)
- Low-Frequency Trimmed Internal Reference Source (REFO)
- 32-kHz Watch Crystals (XT1)
- High-Frequency Crystals up to 32 MHz (XT2)
- 16-Bit Timer TA0, Timer_A With Five Capture/Compare Registers
- 16-Bit Timer TA1, Timer_A With Three Capture/Compare Registers
- 16-Bit Timer TA2, Timer_A With Three Capture/Compare Registers
- 16-Bit Timer TB0, Timer_B With Seven Capture/Compare Shadow Registers
- Two Universal Serial Communication Interfaces (USCIs)
- USCI_A0 and USCI_A1 Each Support:
- Enhanced UART Supports Auto-Baudrate Detection
- IrDA Encoder and Decoder
- Synchronous SPI
- USCI_B0 and USCI_B1 Each Support:
- I2C
- Synchronous SPI
- USCI_A0 and USCI_A1 Each Support:
- Integrated 3.3-V Power System
- 10-Bit Analog-to-Digital Converter (ADC) With Window Comparator
- Comparator
- Hardware Multiplier Supports 32-Bit Operations
- Serial Onboard Programming, No External Programming Voltage Needed
- Three-Channel Internal DMA
- Basic Timer With RTC Feature
- MSP430F47193 - 16 位超低功耗微处理器,具有 120KB 闪存、4KB RAM、3 个 Σ-Δ ADC 和 LCD 驱动器
- TPS62691 - 采用芯片级封装的 600mA、4MHz、2.2V 高效降压转换器
- UA78M33 - 3/4 引脚 500mA 固定 3.3V 正电压稳压器
- LP3872 - 1.5A 快速超低压降线性稳压器
- TLC3548 - 14 位、5V、200KSPS、8 通道单级性 ADC
- ADS7852 - 12 位 8 通道并行输出模数转换器
- SN75LV4737A - 3.3V/5V 多通道 RS-232 线路驱动器/接收器
- TPS51124 - 用于低压系统电源的双路同步步降控制器
- SN74AUC1G66 - 单路双向模拟开关
- CD74HC11 - 高速 CMOS 逻辑三路 3 输入与门



