

- CY74FCT2541ATQCT - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- TL064IN - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- SN74LS645-1NSR - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- LP3856ES-1.8 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- PTB48511BAZ - 板安装电源 > 直流转换器
- MSP430F2252IDAR - 集成电路(IC) > 嵌入式 > 微控制器
- DS91C180TMA/NOPB - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- TLV62566DBVR - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- LP38502TSX-ADJ/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- ADS6128IRGZ25 - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- THS4022IDGN - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- SN74AHC240DW - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- VSP3200YG4 - 线性 - 视频处理
- 74LVC1G125DBVTG4 - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- TLV1117-50CDCYG3 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- THS3092EVM - 开发板,套件,编程器 > 评估板 > 运算放大器评估板
- TLV431AIDBVT - 集成电路(IC) > 电源管理(PMIC) > 电压基准
- OPA1678IDGKT - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TPS65197RUYR - 集成电路(IC) > 线性 > 视频处理
- LM2593HVS-3.3/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器



PCA9554 - 具有中断输出和配置寄存器的远程 8 位 I2C 和 SMBus I/O 扩展器
PCA9554是TI德州仪器公司的一款I2CIO扩展器产品,PCA9554是具有中断输出和配置寄存器的远程 8 位 I2C 和 SMBus I/O 扩展器,本站介绍了PCA9554的封装应用图解、特点和优点、功能等,并给出了与PCA9554相关的TI元器件型号供参考。
PCA9554 - 具有中断输出和配置寄存器的远程 8 位 I2C 和 SMBus I/O 扩展器 - I2CIO扩展器 - I2C - 德州仪器
This 8-bit I/O expander for the two-line bidirectional bus (I2C) is designed for 2.3-V to 5.5-V VCC operation. It provides general-purpose remote I/O expansion for most microcontroller families via the I2C interface [serial clock (SCL), serial data (SDA)].
The PCA9554 consists of one 8-bit Configuration (input or output selection), Input, Output, and Polarity Inversion (active high or active low) registers. At power on, the I/Os are configured as inputs with a weak pullup to VCC. However, the system master can enable the I/Os as either inputs or outputs by writing to the I/O configuration bits. The data for each input or output is kept in the corresponding Input or Output register. The polarity of the Input Port register can be inverted with the Polarity Inversion register. All registers can be read by the system master.
The system master can reset the PCA9554 in the event of a timeout or other improper operation by utilizing the power-on reset feature, which puts the registers in their default state and initializes the I2C/SMBus state machine.
The PCA9554 open-drain interrupt (INT) output is activated when any input state differs from its corresponding Input Port register state and is used to indicate to the system master that an input state has changed.
INT can be connected to the interrupt input of a microcontroller. By sending an interrupt signal on this line, the remote I/O can inform the microcontroller if there is incoming data on its ports without having to communicate via the I2C bus. Thus, the PCA9554 can remain a simple slave device.
The device's outputs (latched) have high-current drive capability for directly driving LEDs and low current consumption.
Three hardware pins (A0, A1, and A2) are used to program and vary the fixed I2C address and allow up to eight devices to share the same I2C bus or SMBus.
The PCA9554 is pin-to-pin and I2C address compatible with the PCF8574. However, software changes are required, due to the enhancements in the PCA9554 over the PCF8574.
The PCA9554 and PCA9554A are identical except for their fixed I2C address. This allows for up to 16 of these devices (eight of each) on the same I2C/SMBus.
- I2C to Parallel Port Expander
- Open-Drain Active-Low Interrupt Output
- Operating Power-Supply Voltage Range of 2.3V to 5.5V
- 5-V Tolerant I/Os
- 400-kHz Fast I2C Bus
- Three Hardware Address Pins Allow up to Eight Devices on the I2C/SMBus
- Input/Output Configuration Register
- Polarity Inversion Register
- Internal Power-On Reset
- Power-Up With All Channels Configured as Inputs
- No Glitch On Power Up
- Latched Outputs With High-Current Drive Maximum Capability for Directly Driving LEDs
- Latch-Up Performance Exceeds 100 mA Per JESD 78, Class II
- ESD Protection Exceeds JESD 22
- 2000-V Human-Body Model (A114-A)
- 200-V Machine Model (A115-A)
- 1000-V Charged-Device Model (C101)
- ADS1218 - 具有闪存、8 个通道、参考电压、缓冲器、2 个 IDAC、串行输出和数字 I/O 的超低功耗 24 位、780SPS ADC
- TPS62134D - TPS621x4A 功能
- SN65HVD251-Q1 - 汽车类 CAN 收发器
- MSP430FR5949 - Wolverine 混合信号微控制器
- SN74ALS74A - 具有清零和预设功能的双路上升沿 D 类触发器
- TPS652510 - 4.5V 至 16V 输入、3A/2A/2A 输出、三路同步降压转换器
- ADS62C15 - 具有 SNRBoost 的双通道 11 位 125MSPS ADC
- MSP430F1610 - 16 位超低功耗 MCU,具有 32kB 闪存、5124B RAM、12 位 ADC、双 DAC、2 个 USART、I2C、HW 乘法器和 DMA
- BQ2002C - 具有负 dV 和峰值电压检测终端的镍镉电池/镍氢电池闸控充电管理 IC
- TPS62402-Q1 - 具有 1 线接口的汽车类双路可调节 400mA 和 600mA、2.25MHz 降压转换器



