The PGA308 is a programmable analog sensor signal conditioner. The analog signal path amplifies the sensor signal and provides digital calibration for offset and gain. Calibration is done via the 1W pin, a digital One-Wire, UART-compatible interface. For three-terminal sensor modules, 1W may be connected to VOUT and the assembly programmed through the VOUT pin. Gain and offset calibration parameters are stored onboard in seven banks of one-time programmable (OTP) memory. The power-on reset (POR) OTP bank may be programmed a total of four times.

The all-analog signal path contains a 2×2 input multiplexer (mux) to allow electronic sensor lead swapping, a coarse offset adjust, an auto-zero programmable gain instrumentation amplifier (PGA), a fine gain adjust, a fine offset adjust, and a programmable gain output amplifier. Fault monitor circuitry detects and signals sensor burnout, overload, and system fault conditions. Over/under-scale limits provide additional means for system level diagnostics. The dual-use DOUT/VCLAMP pin can be used as a programmable digital output or as a VOUT over-voltage clamp.

For detailed application information, see the PGA308 User's Guide (SBOU069) available for download at www.ti.com.

• Digital Calibration for Bridge Sensors
• Offset Select: Coarse and Fine
• Gain Select: Coarse and Fine
• Bridge Fault Monitor
• Input Mux for Lead Swap
• Over/Under Scale Limits
• DOUT/VOUT Clamp Function
• Seven Banks OTP Memory
• One-Wire Digital UART Interface
• Operating Voltage: +2.7V to +5.5V
• Temperature Range: –40°C to +125°C
• MSOP-10 and 3mm × 4mm DFN-10 Packages