

- TS3L100DGVR - 集成电路(IC) > 接口 > 模拟开关 - 特殊用途
- TPS79912YZUT - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- MSP430FR2353TRHAR - 集成电路(IC) > 嵌入式 > 微控制器
- BQ2002GSNTR - 集成电路(IC) > 电源管理(PMIC) > 电池充电器
- TAS2770EVM-STEREO - 开发板,套件,编程器 > 评估板 > 音频放大器评估板
- REG113EA-2.5/250 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- LM5027MH-1/NOPB - 电源管理IC - 稳压器 - DC DC 开关式控制器
- SN74LV11APWTE4 - 逻辑 - 栅极和逆变器
- TLV1117CKCSE3 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- BQ24153YFFR - 集成电路(IC) > 电源管理(PMIC) > 电池充电器
- SN74AVC2T872YFPR - 集成电路(IC) > 逻辑 > 转换器,电平移位器
- SN74F245N - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- TRF6900APTG4 - 射频收发器 IC
- SN65HVD1780DR - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- SN74ABT16833DL - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- OPA241UA - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- AMC1203BPSA - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- CSD96416RWJT - 集成电路(IC) > 电源管理(PMIC) > 全半桥驱动器
- THS4561IDGKT - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- COP8CCR9IMT8/NOPB - 集成电路(IC) > 嵌入式 > 微控制器



SN54ABT573 - 具有三态输出的八路透明 D 类锁存器
SN54ABT573是TI德州仪器公司的一款D类锁存器产品,SN54ABT573是具有三态输出的八路透明 D 类锁存器,本站介绍了SN54ABT573的封装应用图解、特点和优点、功能等,并给出了与SN54ABT573相关的TI元器件型号供参考。
SN54ABT573 - 具有三态输出的八路透明 D 类锁存器 - D类锁存器 - 触发器/锁存器/寄存器 - 德州仪器
These 8-bit latches feature 3-state outputs designed specifically for driving highly capacitive or relatively low-impedance loads. They are particularly suitable for implementing buffer registers, I/O ports, bidirectional bus drivers, and working registers.
The eight latches of the SN54ABT573 and SN74ABT573A are transparent D-type latches. While the latch-enable (LE) input is high, the Q outputs follow the data (D) inputs. When LE is taken low, the Q outputs are latched at the logic levels set up at the D inputs.
A buffered output-enable (OE)\ input can be used to place the eight outputs in either a normal logic state (high or low logic levels) or the high-impedance state. In the high-impedance state, the outputs neither load nor drive the bus lines significantly. The high-impedance state and increased drive provide the capability to drive bus lines without need for interface or pullup components.
OE\ does not affect the internal operations of the latches. Old data can be retained or new data can be entered while the outputs are in the high-impedance state.
To ensure the high-impedance state during power up or power down, OE\ should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
This device is fully specified for partial-power-down applications using Ioff. The Ioff circuitry disables the outputs, preventing damaging current backflow through the device when it is powered down.
- Typical VOLP (Output Ground Bounce) <1 V at VCC = 5 V, TA = 25°C
- High-Drive Outputs (32-mA IOH, 64-mA IOL)
- Ioff Supports Partial-Power-Down Mode Operation
- Latch-Up Performance Exceeds 500 mA Per JEDEC Standard JESD 17
- ESD Protection Exceeds JESD 22
- 2000-V Human-Body Model (A114-A)
- 200-V Machine Model (A115-A)
- TL4050C20-Q1 - 汽车类精密微功耗并联电压基准
- SN74AHCT02 - 四路 2 输入正与非门
- TPS3808G50 - 低静态电流可编程延迟监控电路
- LM20124 - 汽车级可选的 2.95-5.5V、4A、电流模式同步降压稳压器
- LM98620 - 具有 LVDS 输出的 10 位 70 MSPS 6 通道成像信号处理器
- LM34914 - 具有智能电流限制的超小型 1.25A 降压开关稳压器
- TPS769-Q1 - 汽车用低功耗 100mA 低压降线性稳压器
- TPS2013 - 2.6A 2.7 至 5.5V 单路高侧 MOSFET 开关 IC,无故障报告,工作态低电平启用
- TL3844B - TL284xB, TL384xB
- TPS77533 - 单输出 LDO、500mA、固定电压 (3.3V)、快速瞬态响应、SVS



