

- TPS71H33QPWPRG4 - 电源管理IC - 稳压器 - 线性
- MM54HC245E/883 - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- ISO7740FDBQR - 隔离器 > 数字隔离器
- LM4671ITLX/NOPB - 集成电路(IC) > 线性 > 放大器 > 音频放大器
- INA199A2RSWT - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- SN74ABT162245DGG - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- OPA1632DGN - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- SN74LS169BNG4 - 集成电路(IC) > 逻辑 > 计数器,除法器
- TLC27M2ACDR - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- SN74ALS138ANE4 - 集成电路(IC) > 逻辑 > 信号开关,多路复用器,解码器
- CC2511F16RSPRG3 - 射频和无线 > 射频收发器 IC
- BQ2092SN-A309 - 集成电路(IC) > 电源管理(PMIC) > 电池管理
- TPS59603QDSGRQ1 - 集成电路(IC) > 电源管理(PMIC) > 电源管理 - 专用
- SN74ALVCH16374DLR - 集成电路(IC) > 逻辑 > 触发器
- PCA9306DCTTG4 - 集成电路(IC) > 逻辑 > 转换器,电平移位器
- SN74HC4060NSR - 集成电路(IC) > 逻辑 > 计数器,除法器
- TMCS1133C3AQDVGRQ1 - 传感器,变送器 > 电流传感器
- TRS3223ECDBR - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- TPLD1201DGSRQ1 - 集成电路(IC) > 嵌入式 > PLD(可编程逻辑器件)
- BQ4015LYMA-70N - 集成电路(IC) > 存储器 > 存储器



SN54ACT373 - 具有三态输出的八路 D 类透明锁存器
SN54ACT373是TI德州仪器公司的一款D类锁存器产品,SN54ACT373是具有三态输出的八路 D 类透明锁存器,本站介绍了SN54ACT373的封装应用图解、特点和优点、功能等,并给出了与SN54ACT373相关的TI元器件型号供参考。
SN54ACT373 - 具有三态输出的八路 D 类透明锁存器 - D类锁存器 - 触发器/锁存器/寄存器 - 德州仪器
These 8-bit latches feature 3-state outputs designed specifically for driving highly capacitive or relatively low-impedance loads. The devices are particularly suitable for implementing buffer registers, I/O ports, bidirectional bus drivers, and working registers.
The eight latches are D-type transparent latches. When the latch-enable (LE) input is high, the Q outputs follow the data (D) inputs. When LE is taken low, the Q outputs are latched at the logic levels set up at the D inputs.
A buffered output-enable (OE)\ input can be used to place the eight outputs in either a normal logic state (high or low logic levels) or the high-impedance state. In the high-impedance state, the outputs neither load nor drive the bus lines significantly. The high-impedance state and increased drive provide the capability to drive bus lines in bus-organized systems without need for interface or pullup components.
(OE)\ does not affect the internal operations of the latches. Old data can be retained or new data can be entered while the outputs are in the high-impedance state.
To ensure the high-impedance state during power up or power down, (OE)\ should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
- 4.5-V to 5.5-V VCC Operation
- Inputs Accept Voltages to 5.5 V
- Max tpd of 10 ns at 5 V
- Inputs Are TTL-Voltage Compatible
- CSD17522Q5A - 30V N 通道 NexFET? 功率 MOSFET
- MSP430F1471 - 16 位超低功耗微控制器,具有 32kB 闪存、1KB RAM、2 个 USART 和 HW 乘法器
- TMS570LS3135 - 16/32-Bit RISC Flash Microcontroller
- DS3695 - 多点 RS-485/RS-422 收发器
- CD54HC08 - 高速 CMOS 逻辑四路 2 输入与门
- SN74LVC138A - 3 线路至 8 线路解码器/多路解复用器
- CSD95373BQ5M - 同步降压 NexFET 功率级,CSD95373BQ5M
- CD54HC20 - 高速 CMOS 逻辑双路 4 输入与非门
- LM5113 - 增强模式 GaN FET 的 5A、100V 半桥接闸极驱动器
- CDCLVP1102 - 低抖动 1:2 通用 LVPECL 缓冲器



