

- TLV2474AIDRG4 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TPS2480EVM-002 - 评估和演示板及套件
- 74FCT162543CTPVCT - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- SN75160BDWE4 - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- BQ24700PW - 集成电路(IC) > 电源管理(PMIC) > 电池充电器
- MSP430F2330TRHAR - 集成电路(IC) > 嵌入式 > 微控制器
- SN74ABT241ADWRE4 - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- TPS60500DGSG4 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- DS90UR904QSQX/NOPB - 集成电路(IC) > 接口 > 串行器,解串器
- BQ27Z561EVM-011 - 开发板,套件,编程器 > 评估板 > 评估和演示板及套件
- LM2682M/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- TM4C1231H6PMI - 集成电路(IC) > 嵌入式 > 微控制器
- LM567CN/NOPB - 集成电路(IC) > 接口 > 电信
- SN74AHC1G32DBVRG4 - 集成电路(IC) > 逻辑 > 门和反相器
- SN65HVD75DR - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- UCC5640PW24G4 - 集成电路(IC) > 接口 > 信号端接器
- TAC5112WQRTVRQ1 - 集成电路(IC) > 接口 > 编解码器
- THS1230CPWR - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- TPS3836K33DBVR - 集成电路(IC) > 电源管理(PMIC) > 监控器
- UCC3818ADR - 集成电路(IC) > 电源管理(PMIC) > PFC(功率因数校正)



SN54ACT374 - 具有三态输出的八路 D 类边沿触发触发器
SN54ACT374是TI德州仪器公司的一款D类触发器产品,SN54ACT374是具有三态输出的八路 D 类边沿触发触发器,本站介绍了SN54ACT374的封装应用图解、特点和优点、功能等,并给出了与SN54ACT374相关的TI元器件型号供参考。
SN54ACT374 - 具有三态输出的八路 D 类边沿触发触发器 - D类触发器 - 触发器/锁存器/寄存器 - 德州仪器
These 8-bit flip-flops feature 3-state outputs designed specifically for driving highly capacitive or relatively low-impedance loads. The devices are particularly suitable for implementing buffer registers, I/O ports, bidirectional bus drivers, and working registers.
The eight flip-flops of the ACT374 devices are D-type edge-triggered flip-flops. On the positive transition of the clock (CLK) input, the Q outputs are set to the logic levels set up at the data (D) inputs.
A buffered output-enable (OE)\ input can be used to place the eight outputs in either a normal logic state (high or low logic levels) or the high-impedance state. In the high-impedance state, the outputs neither load nor drive the bus lines significantly. The high-impedance state and the increased drive provide the capability to drive bus lines in bus-organized systems without need for interface or pullup components.
OE\ does not affect internal operations of the flip-flop. Old data can be retained or new data can be entered while the outputs are in the high-impedance state.
To ensure the high-impedance state during power up or power down, OE\ should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
- 4.5-V to 5.5-V VCC Operation
- Inputs Accept Voltages to 5.5 V
- Max tpd of 10 ns at 5 V
- Inputs Are TTL-Voltage Compatible
- TRF3710 - 集成直接降频转换接收器
- EMB1433Q - 具有可编程窗口比较器的 EMB1433Q 60V、14 通道电池组保护芯片
- TPS92511 - TPS92511 500mA 30W 阳极恒流降压 LED 驱动器
- DAC0832 - 8 位微处理器兼容的双缓冲 D/A 转换器
- SN65HVD21 - 扩展共模 RS-485 收发器
- UC1706 - 具有电流限制的高速 MOSFET 驱动器
- CD54HC377 - 具有数据使能端的高速 CMOS 逻辑八路 D 类触发器
- UC1854B - 增强型高功率因子前置稳压器
- DP83848VYB - PHYTER 扩展温度单端口 10/100 Mb/s 以太网物理层收发器
- CD54HCT10 - 高速 CMOS 逻辑三路 3 输入与非门



