

- SN74LS244NE4 - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- SN74AUP2G126DQER - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- UC3842J - 集成电路(IC) > 电源管理(PMIC) > DC-DC 开关控制器
- TRS3243ECPW - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- TLC27L2BCD - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TMS320SP103AZGW2 - 集成电路(IC) > 嵌入式 > DSP(数字信号处理器)
- UC3879DW - 集成电路(IC) > 电源管理(PMIC) > DC-DC 开关控制器
- SN74AUC2G80DCTR - 集成电路(IC) > 逻辑 > 触发器
- LM258APE4 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TLC27M2AIP - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TLV61047QEVM-165 - 开发板,套件,编程器 > 评估板 > DC/DC 和 AC/DC(离线)SMPS 评估板
- SN74ALS373ANS - 集成电路(IC) > 逻辑 > 锁存器
- MSP-EXP430FR4133 - 开发板,套件,编程器 > 评估板 > 嵌入式 MCU、DSP 评估板
- ADC34J42IRGZ25 - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- TPS536C9TRSLR - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- LMR43610MSC3RPERQ1 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- TL061BCPG4 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- ADS8686SEVM-PDK - 开发板,套件,编程器 > 评估板 > 模数转换器(ADC)评估板
- LM4130AIM5X-2.0 - 集成电路(IC) > 电源管理(PMIC) > 电压基准
- 74AVCB164245ZRDR - 集成电路(IC) > 逻辑 > 转换器,电平移位器



SN54HC573A-SP - 具有三态输出的八路 D 类透明锁存器
SN54HC573A-SP是TI德州仪器公司的一款D类锁存器产品,SN54HC573A-SP是具有三态输出的八路 D 类透明锁存器,本站介绍了SN54HC573A-SP的封装应用图解、特点和优点、功能等,并给出了与SN54HC573A-SP相关的TI元器件型号供参考。
SN54HC573A-SP - 具有三态输出的八路 D 类透明锁存器 - D类锁存器 - 触发器/锁存器/寄存器 - 德州仪器
These octal transparent D-type latches feature 3-state outputs designed specifically for driving highly capacitive or relatively low-impedance loads. They are particularly suitable for implementing buffer registers, I/O ports, bidirectional bus drivers, and working registers.
While the latch-enable (LE) input is high, the Q outputs respond to the data (D) inputs. When LE is low, the outputs are latched to retain the data that was set up.
A buffered output-enable (OE)\ input can be used to place the eight outputs in either a normal logic state (high or low logic levels) or the high-impedance state. In the high-impedance state, the outputs neither load nor drive the bus lines significantly. The high-impedance state and increased drive provide the capability to drive bus lines without interface or pullup components.
To ensure the high-impedance state during power up or power down, OE\ should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
OE\ does not affect the internal operations of the latches. Old data can be retained or new data can be entered while the outputs are in the high-impedance state.
- Wide Operating Voltage Range of 2 V to 6 V
- High-Current 3-State Outputs Drive Bus Lines Directly or Up To 15 LSTTL Loads
- Low Power Consumption, 80-µA Max ICC
- Typical tpd = 21 ns
- ±6-mA Output Drive at 5 V
- Low Input Current of 1 µA Max
- Bus-Structured Pinout
- DAC60096 - 96 通道、12 位低功耗、串行输入、非缓冲、高压输出 DAC
- LM4860 - 具有停机模式的 1 瓦音频功率放大器
- SN74S38 - 具有集电极开路输出的四路 2 输入正与非缓冲器
- BQ25050 - 具有 50mA LDO 的 1A、单输入、单节锂离子电池充电器
- SN74LV393A-Q1 - 汽车目录双路 4 位二进制计数器
- CDCLVC1310 - 通用输入、10 输出低阻抗 LVCMOS 缓冲器
- TMP102 - 具有 I2C/SMBus 接口且工作电压为 1.4V 的 ±1°C 温度传感器,支持报警功能
- TPS65070 - 采用 6mm x 6mm QFN 封装的 5 通道电源管理 IC (PMIC),具有 3 个 DC/DC 和 2 个 LDO
- SN74LV11A-EP - 增强型产品三路 3 输入正与门
- CD74ACT00 - 四路 2 输入与非门



