

- SN74CBTLV1G125C6 - 集成电路(IC) > 逻辑 > 信号开关,多路复用器,解码器
- SN74LVC16244ADLRG4 - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- CD4060BMW-MIL - 集成电路(IC) > 逻辑 > 计数器,除法器
- DS90CR288MTDX - 集成电路(IC) > 接口 > 专用
- LM3S5P51-IBZ80-C1 - 嵌入式 - 微控制器
- OPA357AIDBVR - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- BUF22821AIDCPR - 集成电路(IC) > 线性 > 放大器 > 视频放大器和模块
- BQ500412EVM-584 - 开发板,套件,编程器 > 评估板 > 评估和演示板及套件
- LDC1614EVM - 开发板,套件,编程器 > 评估板 > 传感器评估板
- BQ79606APHPRQ1 - 集成电路(IC) > 电源管理(PMIC) > 电池管理
- TPS61299QDRLRQ1 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- SN74ALS151NSR - 集成电路(IC) > 逻辑 > 信号开关,多路复用器,解码器
- DRV8838DSGR - 集成电路(IC) > 电源管理(PMIC) > 电机驱动器,控制器
- CDC2509PWRG4 - 时钟-定时 - 时钟发生器,PLL,频率合成器
- ADS1100A5IDBVRG4 - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- TLC69668RTWR - 集成电路(IC) > 电源管理(PMIC) > LED 驱动器
- LP2987IMMX-5.0/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- DS2003CM - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- LM4839MT/NOPB - 集成电路(IC) > 线性 > 放大器 > 音频放大器
- CD40257BF3A - 集成电路(IC) > 逻辑 > 信号开关,多路复用器,解码器



SN65C3221-Q1 - 汽车类 3V 至 5.5V 多通道 RS-232 线路驱动器/接收器
SN65C3221-Q1是TI德州仪器公司的一款无产品,SN65C3221-Q1是汽车类 3V 至 5.5V 多通道 RS-232 线路驱动器/接收器,本站介绍了SN65C3221-Q1的封装应用图解、特点和优点、功能等,并给出了与SN65C3221-Q1相关的TI元器件型号供参考。
SN65C3221-Q1 - 汽车类 3V 至 5.5V 多通道 RS-232 线路驱动器/接收器 - 无 - RS-232收发器 - 德州仪器
The SN65C3221 consists of one line driver, one line receiver, and a dual charge-pump circuit with ±15-kV ESD protection pin to pin (serial-port connection pins, including GND). This device provides the electrical interface between an asynchronous communication controller and the serial-port connector. The charge pump and four small external capacitors allow operation from a single 3-V to 5.5-V supply. This device operates at data signaling rates up to 1 Mbit/s and a driver output slew rate of 24 V/µs to 150 V/µs.
Flexible control options for power management are available when the serial port is inactive. The auto-powerdown feature functions when FORCEON is low and FORCEOFF is high. During this mode of operation, if the device does not sense a valid RS-232 signal on the receiver input, the driver output is disabled. If FORCEOFF is set low and EN is high, both the driver and receiver are shut off, and the supply current is reduced to 1 µA. Disconnecting the serial port or turning off the peripheral drivers causes the auto-powerdown condition to occur. Auto-powerdown can be disabled when FORCEON and FORCEOFF are high. With auto-powerdown enabled, the device is activated automatically when a valid signal is applied to the receiver input. The INVAILD output notifies the user if an RS-232 signal is present at the receiver input. INVAILD is high (valid data) if the receiver input voltage is greater than 2.7 V or less than 2.7 V, or has been between -0.3 V and 0.3 V for less than 30 µs. INVAILD is low (invalid data) if the receiver input voltage is between -0.3 V and 0.3 V for more than 30 µs.
- Qualified for Automotive Applications
- Operates With 3-V to 5.5-V VCC Supply
- Operates Up To 1 Mbit/s
- Low Standby Current . . . 1 µA Typical
- External Capacitors . . . 4 × 0.1 µF
- Accepts 5-V Logic Input With 3.3-V Supply
- RS-232 Bus-Pin ESD Protection Exceeds ±15 kV Using Human-Body Model (HBM)
- Auto-Powerdown Feature Automatically Disables Drivers for Power Savings
- Applications
- Battery-Powered, Hand-Held, and Portable Equipment
- PDAs and Palmtop PCs
- Notebooks, Sub-Notebooks, and Laptops
- Digital Cameras
- Mobile Phones and Wireless Devices
- SN74CBT34X245 - 32 位 FET 总线开关
- TPS24771 - 2.5V 至 18V 高性能热插拔和 ORing 控制器
- TPS3836L30-EP - 增强型产品纳瓦级功耗监控电路
- LP8860-Q1 - 汽车类低 EMI 高性能 4 通道 LED 驱动器
- RC4558 - 二路通用运算放大器
- ISO7340FC - 耐用 EMC 低功耗四通道数字隔离器
- SN74LVC1G66 - 单路模拟开关
- TPS62350 - 具有 I2C 用于动态电压调节的 1A、3MHz 降压转换器
- TPS75418 - 单输出 LDO、2.0A、固定电压 (1.8V)、电源良好 (PG) 输出、快速瞬态响应
- DS34LV86T - 3V 增强型 CMOS 四路差动线路接收器



