The transceivers in the HVD2x family offer performance far exceeding typical RS−485 devices. In addition to meeting all requirements of the TIA/EIA−485−A standard, the HVD2x family operates over an extended range of common-mode voltage, and has features such as high ESD protection, wide receiver hysteresis, and failsafe operation. This family of devices is ideally suited for long-cable networks, and other applications where the environment is too harsh for ordinary transceivers.

These devices are designed for bidirectional data transmission on multipoint twisted-pair cables. Example applications are digital motor controllers, remote sensors and terminals, industrial process control, security stations, and environmental control systems.

These devices combine a 3-state differential driver and a differential receiver, which operate from a single 5-V power supply. The driver differential outputs and the receiver differential inputs are connected internally to form a differential bus port that offers minimum loading to the bus. This port features an extended common-mode voltage range making the device suitable for multipoint applications over long cable runs.

The ‘HVD20 provides high signaling rate (up to 25 Mbps) for interconnecting networks of up to 64 nodes.

The ‘HVD21 allows up to 256 connected nodes at moderate data rates (up to 5 Mbps). The driver output slew rate is controlled to provide reliable switching with shaped transitions which reduce high-frequency noise emissions.

The ‘HVD22 has controlled driver output slew rate for low radiated noise in emission-sensitive applications and for improved signal quality with long stubs. Up to 256 ‘HVD22 nodes can be connected at signaling rates up to 500 kbps.

The ‘HVD23 implements receiver equalization technology for improved jitter performance on differential bus applications with data rates up to 25 Mbps at cable lengths up to 160 meters.

The ‘HVD24 implements receiver equalization technology for improved jitter performance on differential bus applications with data rates in the range of 1 Mbps to 10 Mbps at cable lengths up to 1000 meters.

The receivers also include a failsafe circuit that provides a high-level output within 250 microseconds after loss of the input signal. The most common causes of signal loss are disconnected cables, shorted lines, or the absence of any active transmitters on the bus. This feature prevents noise from being received as valid data under these fault conditions. This feature may also be used for Wired-Or bus signaling.

The SN65HVD2X devices are characterized for operation over the temperature range of –40°C to 85°C.

• Common-Mode Voltage Range (–20 V to 25 V) More Than Doubles TIA/EIA-485 Requirement
• Receiver Equalization Extends Cable Length, Signaling Rate (HVD23, HVD24)
• Reduced Unit-Load for up to 256 Nodes
• Bus I/O Protection to Over 16-kV HBM
• Failsafe Receiver for Open-Circuit, Short-Circuit and Idle-Bus Conditions
• Low Standby Supply Current 1-µA Max
• More Than 100 mV Receiver Hysteresis
• APPLICATIONS
  • Long Cable Solutions
    • Factory Automation
    • Security Networks
    • Building HVAC
  • Severe Electrical Environments
    • Electrical Power Inverters
    • Industrial Drives
    • Avionics

• UCC2801 - 低功耗 BiCMOS 电流模式 PWM
• CD54HC297 - 高速 CMOS 逻辑数字锁相环
• LMR62014 - 采用 SOT-23 封装的 SIMPLE SWITCHER? 2.7V 至 14V、1.4A 升压稳压器
• DS90CR285 - +3.3V 上升沿数据选通 LVDS 28 位频道 - 66 MHz
• LP2995 - DDR 终止稳压器
• TPA3110D2-Q1 - 具有 SpeakerGuardT 功能的汽车类 15W 无滤波器 D 类立体声放大器 (TPA3110)
• AMC1204-Q1 - 汽车类、1 位、20MHz、二阶隔离型 Δ-Σ 调制器
• LM4040D41 - 4.096V 精密微功耗并联电压参考，1% 精确度
• MSP430G2533 - MSP430G2x33、MSP430G2x03 混合信号微处理器
• PCF8575 - 具有中断输出的远程 16 位 I2C 和 SMBus I/O 扩展器