• LIN Physical Layer Specification Revision 2.0 Compliant and Conforms to SAEJ2602 Recommended Practice for LIN
• LIN Bus Speed up to 20-kbps LIN Specified Maximum and MOST ECL Speeds Down to 0Baud
• Supports ISO9141 (K-Line)
• Qualified for Automotive Applications
• Sleep Mode: Ultra Low Current Consumption, Allows Wake-Up Events From LIN Bus, Wake-Up Input (External Switch), or Host Microcontroller
• High-Speed Receive Capable
• ESD Protection to ±12 kV (Human Body Model) on LIN Pin
• LIN Pin Handles Voltage From –40 V to 40 V
• Survives Transient Damage in Automotive Environment (ISO 7637)
• Extended Operation With Supply From 7V to 27V DC (LIN Specification 7V to 18V)
• Interfaces to Microcontroller With 5-V or 3.3-V I/O Pins
• Wake-Up Request on RXD Pin
• Control of External Voltage Regulator (INHPin)
• Integrated Pullup Resistor and Series Diode for LIN Slave Applications
• Low Electromagnetic Emission (EME), High Electromagnetic Immunity (EMI)
• Bus Terminal Short Circuit Protected for Short-to-Battery or Short-to-Ground
• Thermally Protected
• Ground Disconnection Fail Safe at System Level
• Ground Shift Operation at System Level
• Unpowered Node Does Not Disturb the Network

• Automotive
• Industrial Sensing
• White Goods Distributed Control

The SN65HVDA195 device is the Local Interconnect Network (LIN) physical interface and MOST ECL interface, which integrates the serial transceiver with wake-up and protection features. The bus is a single-wire bidirectional bus typically used for low-speed in-vehicle networks using data rates to 20kbps. The device can transmit with an effective data rate of 0 kbps because it does not have dominant state time-out. The protocol output data stream on TXD is converted by the SN65HVDA195 into the bus signal through a current-limited wave-shaping driver as outlined by the LIN Physical Layer Specification Revision2.0. The receiver converts the data stream from the bus and outputs the data stream through RXD. The bus has two states: dominant state (voltage near ground) and the recessive state (voltage near battery). In the recessive state, the bus is pulled high by the SN65HVDA195’s internal pullup resistor and series diode, so no external pullup components are required for slave applications. Master applications require an external pullup resistor (1kΩ) plus a series diode per the LIN specification.