
- SN74LVT244BPWRG4 - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- DAC104S085EB/NOPB - 开发板,套件,编程器 > 评估板 > 数模转换器(DAC)评估板
- CDCL1810RGZT - 集成电路(IC) > 时钟/定时 > 时钟缓冲器,驱动器
- TSB12LV21BIPGF - 集成电路(IC) > 接口 > 控制器
- UA7805CKCT - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- DRV612RGTT - 集成电路(IC) > 线性 > 放大器 > 音频放大器
- SN74FB2031RCG3 - 集成电路(IC) > 逻辑 > 专用逻辑器件
- LVDSEVAL-001 - 开发板,套件,编程器 > 评估板 > 评估和演示板及套件
- SN761678DBT - 集成电路(IC) > 线性 > 视频处理
- TLC0820ACDWG4 - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- OPA2234U/2K5 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- CD74HCT86EG4 - 集成电路(IC) > 逻辑 > 门和反相器
- LM3S6C11-IBZ80-A1T - 嵌入式 - 微控制器
- TRSF3238EIDBG4 - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- TPS64200DBVR - 集成电路(IC) > 电源管理(PMIC) > DC-DC 开关控制器
- DAC70501MDQFR - 集成电路(IC) > 数据采集 > 数模转换器(DAC)
- SN74LV175ADR - 集成电路(IC) > 逻辑 > 触发器
- CD74HC125MT - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- DAC7553IRGTTG4 - 集成电路(IC) > 数据采集 > 数模转换器(DAC)
- DAC7800KUG4 - 集成电路(IC) > 数据采集 > 数模转换器(DAC)



SN74ABT16841 - 具有三态输出的 20 位总线接口 D 类锁存器
SN74ABT16841是TI德州仪器公司的一款D类锁存器产品,SN74ABT16841是具有三态输出的 20 位总线接口 D 类锁存器,本站介绍了SN74ABT16841的封装应用图解、特点和优点、功能等,并给出了与SN74ABT16841相关的TI元器件型号供参考。
SN74ABT16841 - 具有三态输出的 20 位总线接口 D 类锁存器 - D类锁存器 - 触发器/锁存器/寄存器 - 德州仪器
These 20-bit latches feature 3-state outputs designed specifically for driving highly capacitive or relatively low-impedance loads. They are particularly suitable for implementing buffer registers, I/O ports, bidirectional bus drivers, and working registers.
The 'ABT16841 can be used as two 10-bit latches or one 20-bit latch. The 20 transparent D-type latches provide true data at the outputs. While the latch-enable (1LE or 2LE) input is high, the Q outputs of the corresponding 10-bit latch follow the D inputs. When LE is taken low, the Q outputs are latched at the levels set up at the D inputs.
A buffered output-enable (1OE\ or 2OE\) input can be used to place the outputs of the corresponding 10-bit latch in either a normal logic state (high or low logic levels) or a high-impedance state. In the high-impedance state, the outputs neither load nor drive the bus lines significantly.
The output-enable input does not affect the internal operation of the latches. Old data can be retained or new data can be entered while the outputs are in the high-impedance state.
When VCC is between 0 and 2.1 V, the device is in the high-impedance state during power up or power down. However, to ensure the high-impedance state above 2.1 V, OE\ should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
The SN54ABT16841 is characterized for operation over the full military temperature range of -55°C to 125°C. The SN74ABT16841 is characterized for operation from -40°C to 85°C.
- Members of the Texas Instruments WidebusTM Family
- State-of-the-Art EPIC-II BTM BiCMOS Design Significantly Reduces Power Dissipation
- ESD Protection Exceeds 2000 V Per MIL-STD-883, Method 3015; Exceeds 200 V Using Machine Model (C = 200 pF, R = 0)
- Latch-Up Performance Exceeds 500 mA Per JEDEC Standard JESD-17
- Typical VOLP (Output Ground Bounce) < 0.8 V at VCC = 5 V, TA = 25°C
- High-Impedance State During Power Up and Power Down
- Distributed VCC and GND Pin Configuration Minimizes High-Speed Switching Noise
- Flow-Through Architecture Optimizes PCB Layout
- High-Drive Outputs (-32-mA IOH, 64-mA IOL)
- Package Options Include Plastic 300-mil Shrink Small-Outline (DL) Package and 380-mil Fine-Pitch Ceramic Flat (WD) Package Using 25-mil Center-to-Center Spacings
Widebus and EPIC-IIB are trademarks of Texas Instruments Incorporated.
- LP38869 - 具有 1% 精度的 1A FlexCap 低压差线性稳压器
- UCC381-5 - 单输出 LDO、1.0A、固定电压 (5.0V)、低静态电流
- TL1431-Q1 - 汽车类精密可调节(可编程)并联参考
- TAS5412-Q1 - 双通道汽车数字放大器
- SN65HVD1471 - 具有 16kV IEC61000-4-2 接触放电 ESD 保护的 3.3V 电源全双工 RS-485
- DAC8552 - DAC8552:16 位双路电压输出数模转换器
- SN74ACT374 - 具有三态输出的八路 D 类边沿触发器
- TPS3800G27 - 超小型电源电压监控器
- UC1901-SP - 隔离反馈生成器
- TPS60150 - TPS60150



