

- UC3844AN - 集成电路(IC) > 电源管理(PMIC) > DC-DC 开关控制器
- TAS5412TPHDRQ1 - 集成电路(IC) > 线性 > 放大器 > 音频放大器
- PT78HT208S - 直流转换器
- UCC5390SCD - 隔离器 > 隔离器 - 栅极驱动器
- LM3405AXMKE/NOPB - 集成电路(IC) > 电源管理(PMIC) > LED 驱动器
- THS4275DGNR - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- CC1020-RTB1 - 射频和无线 > 射频收发器 IC
- CC2541DK-MINI - 开发板,套件,编程器 > 评估板 > 射频评估和开发套件,板
- SN74LS157NE4 - 集成电路(IC) > 逻辑 > 信号开关,多路复用器,解码器
- LM5023-2NBEVM - 开发板,套件,编程器 > 评估板 > DC/DC 和 AC/DC(离线)SMPS 评估板
- TPS79147DBVRQ1 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- SN74LV594ADR - 集成电路(IC) > 逻辑 > 移位寄存器
- TPSM81033EVM-035 - 开发板,套件,编程器 > 评估板 > DC/DC 和 AC/DC(离线)SMPS 评估板
- TLV75512PDRVR - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- TPS2046BD - 集成电路(IC) > 电源管理(PMIC) > 配电开关,负载驱动器
- SN65HVD1176DR - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- TM4C123FH6PMI - 集成电路(IC) > 嵌入式 > 微控制器
- 74CBTD3861DBQRG4 - 集成电路(IC) > 逻辑 > 信号开关,多路复用器,解码器
- SN74HCT32APWLE - 集成电路(IC) > 逻辑 > 门和反相器
- TUSB564Q1-EVM - 开发板,套件,编程器 > 评估板 > 评估和演示板及套件



SN74AC534 - 具有三态输出的八路边沿 D 类触发器
SN74AC534是TI德州仪器公司的一款D类触发器产品,SN74AC534是具有三态输出的八路边沿 D 类触发器,本站介绍了SN74AC534的封装应用图解、特点和优点、功能等,并给出了与SN74AC534相关的TI元器件型号供参考。
SN74AC534 - 具有三态输出的八路边沿 D 类触发器 - D类触发器 - 触发器/锁存器/寄存器 - 德州仪器
These octal edge-triggered D-type flip-flops feature 3-state outputs designed specifically for driving highly capacitive or relatively low-impedance loads. The devices are particularly suitable for implementing buffer registers, I/O ports, bidirectional bus drivers, and working registers.
On the positive transition of the clock (CLK) input, the Q\ outputs are set to the complements of the logic levels set up at the data (D) inputs.
A buffered output-enable (OE)\ input can be used to place the eight outputs in either a normal logic state (high or low logic levels) or the high-impedance state. In the high-impedance state, the outputs neither load nor drive the bus lines significantly. The high-impedance state and increased drive provide the capability to drive bus lines without need for interface or pullup components.
OE\ does not affect internal operations of the flip-flops. Old data can be retained or new data can be entered while the outputs are in the high-impedance state.
To ensure the high-impedance state during power up or power down, OE\ should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
- 2-V to 6-V VCC Operation
- Inputs Accept Voltages to 6 V
- Max tpd of 11 ns at 5 V
- 3-State Inverting Outputs Drive Bus Lines Directly
- Full Parallel Access for Loading
- ADC08B200 - 具有捕捉缓冲器的 8 位、200 MSPS A/D 转换器
- ADC12J1600 - ADC12J1600 和 ADC12J2700 超宽带 RF 采样子系统
- CC430F5147 - 具有射频内核的 CC430F614x、CC430F514x、CC430F512x SoC
- MSP430F5341 - MSP430F534x 混合信号微处理器
- TMS320F28374D - TMS320F2837xD 双核 Delfino 微控制器
- TPS78601 - 单输出 LDO、1.5A、可调节电压(1.2 至 5.5V)、低噪声、高 PSRR
- DLPA3005 - DLPA3005 PMIC 和高电流 LED 驱动器 IC
- ADS5121 - 低功耗 8 通道 10 位 40MSPS 1.8V ADC
- MAX3222E - 具有 +/-15kV ESD 保护的 3V 至 5V 多通道 RS-232 线路驱动器/接收器
- ADS8406 - 16 位 1.25MSPS 伪双极全差动输入微功耗采样 ADC



