

- TPA0222PWPG4 - 线性 - 放大器 - 音频
- LMK3H2108A0ERKPR - 集成电路(IC) > 时钟/定时 > 应用特定时钟/定时
- SN74V245-15PAGEP - 集成电路(IC) > 逻辑 > FIFO 存储器
- TPS2066CEVM-293 - 开发板,套件,编程器 > 评估板 > 评估和演示板及套件
- CSD13302WT - 分立半导体产品 > 晶体管 > FET,MOSFET > 单 FET,MOSFET
- LP2980AIM5X-3.6 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- TL750L05CKTTR - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- TPS3306-33QDRQ1 - 集成电路(IC) > 电源管理(PMIC) > 监控器
- LM4041DIM3X-ADJ/NOPB - 集成电路(IC) > 电源管理(PMIC) > 电压基准
- LM317AEMP/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- OPA2357AIDGSR - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- LMK04906BISQE/NOPB - 集成电路(IC) > 时钟/定时 > 时钟发生器,PLL,频率合成器
- LM25066APSQX/NOPB - 集成电路(IC) > 电源管理(PMIC) > 电源管理 - 专用
- CD74AC540M96 - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- TPS63012YFFR - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- ADC08831IWM/NOPB - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- AM5716AABCDA - 集成电路(IC) > 嵌入式 > 微处理器
- TMP118MDIYMSR - 传感器,变送器 > 温度传感器 > 模拟和数字输出
- SN74HC7002PWG4 - 集成电路(IC) > 逻辑 > 门和反相器
- CD74HC75M96 - 集成电路(IC) > 逻辑 > 锁存器



SN74ACT16374-EP - 具有三态输出的增强型产品 16 位 D 类边沿触发器
SN74ACT16374-EP是TI德州仪器公司的一款D类触发器产品,SN74ACT16374-EP是具有三态输出的增强型产品 16 位 D 类边沿触发器,本站介绍了SN74ACT16374-EP的封装应用图解、特点和优点、功能等,并给出了与SN74ACT16374-EP相关的TI元器件型号供参考。
SN74ACT16374-EP - 具有三态输出的增强型产品 16 位 D 类边沿触发器 - D类触发器 - 触发器/锁存器/寄存器 - 德州仪器
The SN74ACT16374Q-EP is a 16-bit edge-triggered D-type flip-flop with 3-state outputs, designed specifically for driving highly capacitive or relatively low-impedance loads. It is particularly suitable for implementing buffer registers, I/O ports, bidirectional bus drivers, and working registers.
This device can be used as two 8-bit flip-flops or one 16-bit flip-flop. On the positive transition of the clock (CLK) input, the Q outputs of the flip-flop take on the logic levels set up at the data (D) inputs.
An output-enable (OE)\ input can be used to place the outputs in either a normal logic state (high or low logic levels) or the high-impedance state. In the high-impedance state, the outputs neither load nor drive the bus lines significantly. The high-impedance state provides the capability to drive bus lines in a bus-organized system, without need for interface or pullup components. OE\ does not affect the internal operations of the flip-flop. Old data can be retained or new data can be entered while the outputs are in the high-impedance state.
- Controlled Baseline
- One Assembly/Test Site, One Fabrication Site
- Extended Temperature Performance of 40°C to 125°C
- Enhanced Diminishing Manufacturing Sources (DMS) Support
- Enhanced Product Change Notification
- Qualification Pedigree
- Member of the Texas Instruments Widebus Family
- Inputs Are TTL-Voltage Compatible
- 3-State Bus Driving True Outputs
- Flow-Through Architecture Optimizes PCB Layout
- Distributed VCC and GND Pins Minimize High-Speed Switching Noise
Component qualification in accordance with JEDEC and industry standards to ensure reliable operation over an extended temperature range. This includes, but is not limited to, highly accelerated stress test (HAST) or biased 85/85, temperature cycle, autoclave or unbiased HAST, electromigration, bond intermetallic life, and mold compound life. Widebus is a trademark of Texas Instruments.
- SN54F00 - 四路 2 输入正与非门
- ADS7868 - 1.2V 8 位 280KSPS 串行 ADC
- UC3770A - 高性能步进电机驱动电路
- TMS320F28069M - 具有 InstaSPIN-MOTION 的 Piccolo 微控制器
- TPS7A37 - 具有反向电流保护功能的 1% 高准确度,1A 低压降稳压器
- DS26LS32C - 四路差动线路接收器
- PTR08060W - 6A 输出 4.5V 至 14V 输入的非隔离宽输出可调节电源模块
- TPS3808G18-Q1 - 汽车类低静态电流可编程延迟监控电路
- ONET4251PA - 具有 LOS 和 RSSI 的 1Gbps 至 4.25Gbps 限幅放大器
- TPS7A7200 - 单路输出、极低输入、可配置固定(0.9 至 5.0V)2A 低压降线性稳压器



