

- 4703BDM - 集成电路(IC) > 逻辑 > FIFO 存储器
- SN74AS11N - 集成电路(IC) > 逻辑 > 门和反相器
- TLV320AIC14KIDBT - 集成电路(IC) > 接口 > 编解码器
- LM2577T-12 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- MSP430F2481TRGCT - 集成电路(IC) > 嵌入式 > 微控制器
- SN74LS670D - 集成电路(IC) > 逻辑 > 信号开关,多路复用器,解码器
- TPS75625KTTR - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- OPA4314AIPW - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TUSB1002ARGET - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- CC2550RSTG3 - 射频和无线 > 射频发射器
- UC2524ADWTR - 集成电路(IC) > 电源管理(PMIC) > DC-DC 开关控制器
- LP3917RLX-S/NOPB - 电源管理IC - 电源管理 - 专用型
- ISO1176EVM - 开发板,套件,编程器 > 评估板 > 评估和演示板及套件
- LP3470IM5X-2.63/NOPB - 集成电路(IC) > 电源管理(PMIC) > 监控器
- TL5002EVM-182 - 评估板 - DC-DC 与 AC-DC(离线)SMPS
- INA219AIDCNTG4 - 集成电路(IC) > 电源管理(PMIC) > 电流调节/管理
- TL4051B12QDBZT - 集成电路(IC) > 电源管理(PMIC) > 电压基准
- UCC28070PWR - 集成电路(IC) > 电源管理(PMIC) > PFC(功率因数校正)
- SN74AS157D - 集成电路(IC) > 逻辑 > 信号开关,多路复用器,解码器
- MSPM0G3518SRGZR - 集成电路(IC) > 嵌入式 > 微控制器



SN74ACT373 - 具有三态输出的八路 D 类透明锁存器
SN74ACT373是TI德州仪器公司的一款D类锁存器产品,SN74ACT373是具有三态输出的八路 D 类透明锁存器,本站介绍了SN74ACT373的封装应用图解、特点和优点、功能等,并给出了与SN74ACT373相关的TI元器件型号供参考。
SN74ACT373 - 具有三态输出的八路 D 类透明锁存器 - D类锁存器 - 触发器/锁存器/寄存器 - 德州仪器
These 8-bit latches feature 3-state outputs designed specifically for driving highly capacitive or relatively low-impedance loads. The devices are particularly suitable for implementing buffer registers, I/O ports, bidirectional bus drivers, and working registers.
The eight latches are D-type transparent latches. When the latch-enable (LE) input is high, the Q outputs follow the data (D) inputs. When LE is taken low, the Q outputs are latched at the logic levels set up at the D inputs.
A buffered output-enable (OE)\ input can be used to place the eight outputs in either a normal logic state (high or low logic levels) or the high-impedance state. In the high-impedance state, the outputs neither load nor drive the bus lines significantly. The high-impedance state and increased drive provide the capability to drive bus lines in bus-organized systems without need for interface or pullup components.
(OE)\ does not affect the internal operations of the latches. Old data can be retained or new data can be entered while the outputs are in the high-impedance state.
To ensure the high-impedance state during power up or power down, (OE)\ should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
- 4.5-V to 5.5-V VCC Operation
- Inputs Accept Voltages to 5.5 V
- Max tpd of 10 ns at 5 V
- Inputs Are TTL-Voltage Compatible
- ADS5521 - 12 位 105MSPS 模数转换器
- DS90C365A - +3.3V 可编程 LVDS 发送器 18 位平板显示链接 - 87.5 MHz
- TPS60202 - 具有电池低电量指示信号的稳压 3.3V 低纹波充电泵
- SN74LVC2G53 - 单极、双闸 (SPDT) 模拟开关或 2:1 模拟多路复用器/多路解复用器
- CSD97370AQ5M - 同步降压 NexFET? 功率级,Vds 30V
- MSP430G2744 - MSP430G2x44 混合信号微控制器
- TPS630242 - 高效 1.5A 单电感降压/升压转换器
- LM34 - 采用华氏刻度校准且支持 30V 电源电压的 ±1°F 模拟输出温度传感器
- MSP430F5325 - MSP430F532x 混合信号微处理器
- LMH0376 - 串行数字接口



