

- BQ7790518PWR - 集成电路(IC) > 电源管理(PMIC) > 电池管理
- LMC6035IM/NOPB - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- DRV8847PWPR - 集成电路(IC) > 电源管理(PMIC) > 电机驱动器,控制器
- V62/22613-03XE - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- TPD5S116EVM - 开发板,套件,编程器 > 评估板 > 评估和演示板及套件
- TPS62148EVM-034 - 开发板,套件,编程器 > 评估板 > DC/DC 和 AC/DC(离线)SMPS 评估板
- OPA4244EA/250G4 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- 5962-9756001QCA - 集成电路(IC) > 逻辑 > 门和反相器
- DS90CF388VJD - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- UCC27323DGN - 集成电路(IC) > 电源管理(PMIC) > 栅极驱动器
- LM2694MTX/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- CD74HCT30E - 集成电路(IC) > 逻辑 > 门和反相器
- TLV341AIDBVTE4 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TLV2470CP - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- CD4099BNS - 集成电路(IC) > 逻辑 > 锁存器
- OMAPL138BZWTA4 - 集成电路(IC) > 嵌入式 > 微处理器
- LM1117DT-1.8 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- PT4473N - 直流转换器
- V62/06626-03XE - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- TPS65001RUKR - 集成电路(IC) > 电源管理(PMIC) > 电源管理 - 专用



SN74ACT563 - 具有三态输出的八路 D 类透明锁存器
SN74ACT563是TI德州仪器公司的一款D类锁存器产品,SN74ACT563是具有三态输出的八路 D 类透明锁存器,本站介绍了SN74ACT563的封装应用图解、特点和优点、功能等,并给出了与SN74ACT563相关的TI元器件型号供参考。
SN74ACT563 - 具有三态输出的八路 D 类透明锁存器 - D类锁存器 - 触发器/锁存器/寄存器 - 德州仪器
The ACT563 devices are octal D-type transparent latches with 3-state outputs. When the latch-enable (LE) input is high, the Q\ outputsare set to the complements of the data (D) inputs. When LE is taken low, the Q\ outputs are latched at the inverse logic levels set up at the D inputs.
A buffered output-enable (OE)\ input places the eight outputs in either a normal logic state (high or low logic levels) or the high-impedance state. In the high-impedance state, the outputs neither load nor drive the bus lines significantly. The high-impedance state and increased high logic level provide the capability to drive bus lines without interface or pullup components.
OE\ does not affect internal operations of the latches. Old data can be retained or new data can be entered while the outputs are in the high-impedance state.
To ensure the high-impedance state during power up or power down, OE\ should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
- 4.5-V to 5.5-V VCC Operation
- Inputs Accept Voltages to 5.5 V
- Max tpd of 8.5 ns at 5 V
- Inputs Are TTL-Voltage Compatible
- 3-State Inverted Outputs Drive Bus Lines Directly
- Flow-Through Architecture to Optimize PCB Layout
- LM10506 - 三路降压 + LDO 电源管理 IC (PMIC)
- DAC1221 - 16 位 Δ-Σ 低功耗数模转换器
- CD74AC164 - 8 位串行输入/并行输出移位寄存器
- SN65C23243 - 3V 至 5.5V 双路 RS-232 端口
- LM4041C - 可调节精密微功耗并联电压参考,0.5% 精确度
- PTH04T220W - 16-A, 2.2-V to 5.5-V Input, Non-Isolated, Wide-Output, Adjustable Power Module
- TPS61072 - Adjustable, 600-mA Switch, 90% Efficient PFM/PWM Boost Converter in ThinSOT-23
- ADS8318 - 16 位单极差动输入 500kSPS 串行输出的 4.5V 至 5.5V 微功耗采样 ADC
- DAC5573 - 具有 I2C 接口的 8 位四路 DAC
- TPS77350 - 采用 MSOP8 封装的 250mA 低压降稳压器和 SVS



