

- TCAN1043HGDMTTQ1 - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- CD4502BNSR - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- THS4130IDGKG4 - 线性器件 - 放大器 - 仪器、运算放大器、缓冲放大器
- SN74HCT14N - 集成电路(IC) > 逻辑 > 门和反相器
- TPS7N4901PDSQR - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- UC3909DWTR - 集成电路(IC) > 电源管理(PMIC) > 电池充电器
- RM48L730DPGET - 嵌入式 - 微控制器
- LMH6646 MDC - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- UC3823DW - 集成电路(IC) > 电源管理(PMIC) > AC DC 转换器,离线开关
- AM26C32IDBR - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- LM3S9BN5-IQC80-C3 - 嵌入式 - 微控制器
- CY74FCT573ATSOCT - 集成电路(IC) > 逻辑 > 锁存器
- LP2989AIMM-2.8/NOPB - 电源管理IC - 稳压器 - 线性
- TRF6900APTG4 - 射频收发器 IC
- TUSB522PRGER - 集成电路(IC) > 接口 > 信号缓冲器、中继器、分离器
- ADC128S102CIMT - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- ADS8318IBDGSTG4 - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- LM3S9B90-IBZ80-C1T - 嵌入式 - 微控制器
- TPS781330220DDCT - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- OPA857TD2 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器



SN74ALVCH16373 - 具有三态输出的 16 位透明 D 类锁存器
SN74ALVCH16373是TI德州仪器公司的一款D类锁存器产品,SN74ALVCH16373是具有三态输出的 16 位透明 D 类锁存器,本站介绍了SN74ALVCH16373的封装应用图解、特点和优点、功能等,并给出了与SN74ALVCH16373相关的TI元器件型号供参考。
SN74ALVCH16373 - 具有三态输出的 16 位透明 D 类锁存器 - D类锁存器 - 触发器/锁存器/寄存器 - 德州仪器
This 16-bit transparent D-type latch is designed for 1.65-V to 3.6-V VCC operation.
The SN74ALVCH16373 is particularly suitable for implementing buffer registers, I/O ports, bidirectional bus drivers, and working registers. This device can be used as two 8-bit latches or one 16-bit latch. When the latch-enable (LE) input is high, the Q outputs follow the data (D) inputs. When LE is taken low, the Q outputs are latched at the levels set up at the D inputs.
A buffered output-enable (OE)\ input can be used to place the eight outputs in either a normal logic state (high or low logic levels) or the high-impedance state. In the high-impedance state, the outputs neither load nor drive the bus lines significantly. The high-impedance state and the increased drive provide the capability to drive bus lines without need for interface or pullup components. OE\ does not affect internal operations of the latch. Old data can be retained or new data can be entered while the outputs are in the high-impedance state.
To ensure the high-impedance state during power up or power down, OE\ should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
Active bus-hold circuitry holds unused or undriven inputs at a valid logic state. Use of pullup or pulldown resistors with the bus-hold circuitry is not recommended.
- Member of the Texas Instruments Widebus Family
- Operates From 1.65 V to 3.6 V
- Max tpd of 3.6 ns at 3.3 V
- ±24-mA Output Drive at 3.3 V
- Bus Hold on Data Inputs Eliminates the Need for External Pullup/Pulldown Resistors
- Latch-Up Performance Exceeds 250 mA Per JESD 17
- ESD Protection Exceeds JESD 22
- 2000-V Human-Body Model (A114-A)
- 200-V Machine Model (A115-A)
Widebus is a trademark of Texas Instruments.
- REF1004-2.5 - 微功耗电压参考
- REG710-25 - 具有固定 2.5V 输出的 30mA 开关电容 DC-DC 转换器
- TPS51633 - 用于 VR12.6/VR12.6+ VCPU 的三相、D-CAP+(tm)、降压控制器
- ADC10464 - 具有输入多路复用器和采样/保持功能的 10 位 600 ns A/D 转换器
- UCC3960 - 初级侧启动控制器
- MSP430G2111 - MSP430G2x01、MSP430G2x11 混合信号微处理器
- LM3632A - LM3632A 单芯片背光 + 偏置电源 + 1.5A 闪光灯 LED 驱动器
- CD74HC670 - 高速 CMOS 逻辑 4 x 4 寄存器文件
- SN75LBC173A - 四路 RS-485 差动线路接收器
- TPS3839E16 - 150nA 超低电流、超小型电压监控器



