

- LP87562Q1EVM - 开发板,套件,编程器 > 评估板 > DC/DC 和 AC/DC(离线)SMPS 评估板
- SN65LVDS324ZQLR - 集成电路(IC) > 接口 > 专用
- SN74LV4066APWR - 集成电路(IC) > 接口 > 模拟开关,多路复用器,解复用器
- XIO2213BIZAY - 集成电路(IC) > 接口 > 专用
- TPS65218D0RSLT - 集成电路(IC) > 电源管理(PMIC) > 特殊用途稳压器
- LP3986TL-2818 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- TLVH431CPK - 集成电路(IC) > 电源管理(PMIC) > 电压基准
- TLV2780IDG4 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TPS2013PWRG4 - 集成电路(IC) > 电源管理(PMIC) > 配电开关,负载驱动器
- TPS23880EVM-008 - 开发板,套件,编程器 > 评估板 > 评估和演示板及套件
- CC1101RTKRG3 - 射频和无线 > 射频收发器 IC
- TLV70731DQNR - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- TLV320AIC33IZXH - 集成电路(IC) > 接口 > 编解码器
- DK-LM3S817 - 开发板,套件,编程器 > 评估板 > 嵌入式 MCU、DSP 评估板
- PCM2702EG/2K - 数据采集 - ADC-DAC - 专用型
- AM3356BZCZA30 - 集成电路(IC) > 嵌入式 > 微处理器
- TLC5971RGET - 集成电路(IC) > 电源管理(PMIC) > LED 驱动器
- LMZ22008EVAL/NOPB - 开发板,套件,编程器 > 评估板 > DC/DC 和 AC/DC(离线)SMPS 评估板
- DRV5015A1QDBZR - 传感器,变送器 > 磁性传感器 > 开关(固态)
- TLC27M4CPW - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器



SN74ALVCH16374 - 具有三态输出的 16 位边沿 D 类触发器
SN74ALVCH16374是TI德州仪器公司的一款D类触发器产品,SN74ALVCH16374是具有三态输出的 16 位边沿 D 类触发器,本站介绍了SN74ALVCH16374的封装应用图解、特点和优点、功能等,并给出了与SN74ALVCH16374相关的TI元器件型号供参考。
SN74ALVCH16374 - 具有三态输出的 16 位边沿 D 类触发器 - D类触发器 - 触发器/锁存器/寄存器 - 德州仪器
This 16-bit edge-triggered D-type flip-flop is designed for 1.65-V to 3.6-V VCC operation.
The SN74ALVCH16374 is particularly suitable for implementing buffer registers, I/O ports, bidirectional bus drivers, and working registers. It can be used as two 8-bit flip-flops or one 16-bit flip-flop. On the positive transition of the clock (CLK) input, the Q outputs of the flip-flop take on the logic levels at the data (D) inputs. OE\ can be used to place the eight outputs in either a normal logic state (high or low logic levels) or the high-impedance state. In the high-impedance state, the outputs neither load nor drive the bus lines significantly. The high-impedance state and the increased drive provide the capability to drive bus lines without need for interface or pullup components.
OE\ does not affect internal operations of the flip-flop. Old data can be retained or new data can be entered while the outputs are in the high-impedance state.
To ensure the high-impedance state during power up or power down, OE\ should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
Active bus-hold circuitry holds unused or undriven inputs at a valid logic state. Use of pullup or pulldown resistors with the bus-hold circuitry is not recommended.
- Member of the Texas Instruments Widebus Family
- Operates From 1.65 to 3.6 V
- Max tpd of 4.2 ns at 3.3 V
- ±24-mA Output Drive at 3.3 V
- Bus Hold on Data Inputs Eliminates the Need for External Pullup/Pulldown Resistors
- Latch-Up Performance Exceeds 250 mA Per JESD 17
- ESD Protection Exceeds JESD 22
- 2000-V Human-Body Model (A114-A)
- 200-V Machine Model (A115-A)
Widebus is a trademark of Texas Instruments.
- LMV232 - 用于 CDMA 和 WCDMA 的双通道集成均方根功率检测器
- LM555 - 用于生成准确延时和振荡的高稳定性 555 定时器
- TPS65177 - 完全 I2C 可编程 6-CH LCD 偏置 IC,用于所有尺寸的电视
- BQ2000 - 具有峰值电压检测终端的多化合物、开关模式充电管理 IC
- SN74LVT8980A-EP - 增强型产品嵌入式测试总线控制器 Ieee Std 1149.1 (Jtag) Tap 主控制器
- DAC8162 - 具有 2.5V、4ppm/°C 基准的 14 位、双路、低功耗、超低短时脉冲波形干扰、缓冲电压输出 DAC
- TPS2838 - 具有内部可调节稳压器的同向快速同步降压 MOSFET 驱动器
- MC79L12 - 3 引脚 100mA 固定 (-12V) 负电压稳压器
- CD74AC86 - 四路 2 输入异或门
- DAC7631 - 串行输入 16 位电压输出数模转换器



