
- MSP430FR5729IDAR - 集成电路(IC) > 嵌入式 > 微控制器
- REF3333AIDCKTG4 - 集成电路(IC) > 电源管理(PMIC) > 电压基准
- DAC3484IRKDT - 集成电路(IC) > 数据采集 > 数模转换器(DAC)
- CC1190RGVR - 射频和无线 > 射频前端(LNA + PA)
- SN74AVCA406LGQSR - 集成电路(IC) > 逻辑 > 转换器,电平移位器
- JM38510/32203SFA - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- UCC2800QDREP - 集成电路(IC) > 电源管理(PMIC) > DC-DC 开关控制器
- DM54LS175J/883 - 集成电路(IC) > 逻辑 > 触发器
- TLC27M2BIDR - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TPS92629QDGNRQ1 - 集成电路(IC) > 电源管理(PMIC) > LED 驱动器
- SN74AHCT374DW - 集成电路(IC) > 逻辑 > 触发器
- DRV8706H-Q1EVM - 开发板,套件,编程器 > 评估板 > 评估和演示板及套件
- UCD9080RHBR - 集成电路(IC) > 电源管理(PMIC) > 监控器
- M0C1103QDDFRQ1 - 集成电路(IC) > 嵌入式 > 微控制器
- SN74CB3T3383PW - 集成电路(IC) > 逻辑 > 信号开关,多路复用器,解码器
- CC3200R1M2RGCR - 射频和无线 > 射频收发器 IC
- LM4929MM - 集成电路(IC) > 线性 > 放大器 > 音频放大器
- THVD1500DR - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- PCI4510RGVF - 集成电路(IC) > 专用 IC
- SN74AHCT32PWRG4 - 集成电路(IC) > 逻辑 > 门和反相器



SN74ALVCH32501 - 具有三态输出的 36 位通用总线收发器
SN74ALVCH32501是TI德州仪器公司的一款通用总线收发器(UBT)产品,SN74ALVCH32501是具有三态输出的 36 位通用总线收发器,本站介绍了SN74ALVCH32501的封装应用图解、特点和优点、功能等,并给出了与SN74ALVCH32501相关的TI元器件型号供参考。
SN74ALVCH32501 - 具有三态输出的 36 位通用总线收发器 - 通用总线收发器(UBT) - 通用总线功能 - 德州仪器
This 36-bit universal bus transceiver is designed for 1.65-V to 3.6-V VCC operation.
This device can be used as two 18-bit transceivers or one 36-bit transceiver. Data flow in each direction is controlled by output-enable (OEAB and OEBA\), latch-enable (LEAB and LEBA), and clock (CLKAB and CLKBA) inputs. For A-to-B data flow, the device operates in the transparent mode when LEAB is high. When LEAB is low, the A data is latched if CLKAB is held at a high or low logic level. If LEAB is low, the A data is stored in the latch/flip-flop on the low-to-high transition of CLKAB. When OEAB is high, the outputs are active. When OEAB is low, the outputs are in the high-impedance state.
Data flow for B to A is similar to that of A to B, but uses OEBA\, LEBA, and CLKBA. The output enables are complementary (OEAB is active high and OEBA\ is active low).
To ensure the high-impedance state during power up or power down, OEBA\ should be tied to VCC through a pullup resistor and OEAB should be tied to GND through a pulldown resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
Active bus-hold circuitry holds unused or undriven inputs at a valid logic state. Use of pullup or pulldown resistors with the bus-hold circuitry is not recommended.
- Member of the Texas Instruments Widebus+ Family
- UBT Transceiver Combines D-Type Latches and D-Type Flip-Flops for Operation in Transparent, Latched, or Clocked Mode
- Operates From 1.65 V to 3.6 V
- Max tpd of 3.9 ns at 3.3 V
- ±24 mA Output Drive at 3.3 V
- Bus Hold on Data Inputs Eliminates the Need for External Pullup/Pulldown Resistors
- Latch-Up Performance Exceeds 250 mA Per JESD 17
- ESD Protection Exceeds JESD 22
- 2000-V Human-Body Model (A114-A)
- 200-V Machine Model (A115-A)
Widebus+, UBT are trademarks of Texas Instruments.
- TPS22969 - TPS22969 3V、6A、超低电阻负载开关
- LM2841-Q1 - 采用超薄 SOT-23 封装的 300 mA 最高 42V 输入降压 DC/DC 稳压器
- SN7432 - 四路 2 输入正或门
- TPS54525 - 5-A Output Single Synchronous Step Down Switcher With Integrated FET (SWIFT)
- SM320C6701-EP - 增强型产品浮点数字信号处理器
- TPS51367 - 具有集成 FET 的 22V 输入 12A ULQ(tm) DC/DC 转换器
- ONET1151P - 11.3Gbps 限幅放大器
- LMC6953 - PCI 本地总线电源监控器
- TPS75425 - 单输出 LDO、2.0A、固定电压 (2.5V)、电源良好 (PG) 输出、快速瞬态响应
- CD54HCT283 - 具有快速进位的高速 CMOS 逻辑 4 位二进制全加器



