

- SN74HC74ANS - 集成电路(IC) > 逻辑 > 触发器
- SN74HC132D - 集成电路(IC) > 逻辑 > 门和反相器
- SN74LXCH8T245RHLR - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- DS90LV018ATM - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- SN72275N - 集成电路(IC) > 逻辑 > 门和反相器
- LM4733TABD - 开发板,套件,编程器 > 评估板 > 音频放大器评估板
- TLV755185PDQNRM3 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- TMS320C6204GHK200 - 集成电路(IC) > 嵌入式 > DSP(数字信号处理器)
- DAC900EG4 - 集成电路(IC) > 数据采集 > 数模转换器(DAC)
- DS50EV401SQE/NOPB - 集成电路(IC) > 接口 > 专用
- TAS2770RJQR - 集成电路(IC) > 线性 > 放大器 > 音频放大器
- SN74AHC139DG4 - 集成电路(IC) > 逻辑 > 信号开关,多路复用器,解码器
- TLC2272CPSR - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- UCC38C45DR - 集成电路(IC) > 电源管理(PMIC) > DC-DC 开关控制器
- LM5025MTCX/NOPB - 集成电路(IC) > 电源管理(PMIC) > DC-DC 开关控制器
- OPA2187ID - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- XAM437XAZDN100 - 集成电路(IC) > 嵌入式 > 微处理器
- UCC2913DTR - 集成电路(IC) > 电源管理(PMIC) > 热插拔控制器
- INA600AIDBVR - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- LM2670S-ADJ/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器



SN74ALVCH373 - 具有三态输出的八路透明 D 类锁存器
SN74ALVCH373是TI德州仪器公司的一款D类锁存器产品,SN74ALVCH373是具有三态输出的八路透明 D 类锁存器,本站介绍了SN74ALVCH373的封装应用图解、特点和优点、功能等,并给出了与SN74ALVCH373相关的TI元器件型号供参考。
SN74ALVCH373 - 具有三态输出的八路透明 D 类锁存器 - D类锁存器 - 触发器/锁存器/寄存器 - 德州仪器
This octal transparent D-type latch is designed for 1.65-V to 3.6-V VCC operation.
The SN74ALVCH373 is particularly suitable for implementing buffer registers, I/O ports, bidirectional bus drivers, and working registers. While the latch-enable (LE) input is high, the Q outputs follow the data (D) inputs. When LE is taken low, the Q outputs are latched at the logic levels set up at the D inputs.
A buffered output-enable (OE)\ input can be used to place the eight outputs in either a normal logic state (high or low logic levels) or the high-impedance state. In the high-impedance state, the outputs neither load nor drive the bus lines significantly. The high-impedance state and increased drive provide the capability to drive bus lines without interface or pullup components.
OE\ does not affect the internal operations of the latches. Old data can be retained or new data can be entered while the outputs are in the high-impedance state.
To ensure the high-impedance state during power up or power down, OE\ should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
Active bus-hold circuitry holds unused or undriven inputs at a valid logic state. Use of pullup or pulldown resistors with the bus-hold circuitry is not recommended.
- Operates From 1.65 V to 3.6 V
- Max tpd of 3.3 ns at 3.3 V
- ±24-mA Output Drive at 3.3 V
- Bus Hold on Data Inputs Eliminates the Need for External Pullup/Pulldown Resistors
- Latch-Up Performance Exceeds 100 mA Per JESD 78, Class II
- ESD Protection Exceeds JESD 22
- 2000-V Human-Body Model (A114-A)
- 200-V Machine Model (A115-A)
- 1000-V Charged-Device Model (C101)
- ONET1151P - 11.3Gbps 限幅放大器
- DS91M124 - 具有 LVCMOS 输入的 125 MHz 1:4 M-LVDS 中继器
- LM5134 - 具有备用导频输出的单个 7.6A 峰值电流低侧栅极驱动器
- TPD12S015A - 具有升压 DC-DC、I2C 电平转换器和高速 ESD 钳位的 HDMI 配套芯片,用于便携式应用
- CDCM9102 - 低噪声双通道 100MHz PCIe 时钟发生器
- SN74GTL16612 - 18 位 LVTTL 至 GTL/GTL+ 通用总线收发器
- SN74ALS10A - 三路 3 输入正与非门
- ADS5413 - 低功耗模数转换器
- LM3402 - 用于高功率 LED 驱动器的 0.5A 恒流降压稳压器
- LSF0101 - 单路/双路双向多电压电平转换器



