

- SN74F151BDR - 集成电路(IC) > 逻辑 > 信号开关,多路复用器,解码器
- LM2596S-12/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- JM38510/05754BEA - 集成电路(IC) > 逻辑 > 移位寄存器
- LP2951ACMM/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- LP2981IM5-3.2/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- TLV2211IDBVTG4 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- UA78L05ACPK - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- DS10BR254TSQX/NOPB - 集成电路(IC) > 接口 > 信号缓冲器、中继器、分离器
- ADC3424IRTQ25 - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- DEM-OPA-SOT-1B - 开发板,套件,编程器 > 评估板 > 运算放大器评估板
- BQ7790512PW - 集成电路(IC) > 电源管理(PMIC) > 电池管理
- SN74ACT08DG4 - 集成电路(IC) > 逻辑 > 门和反相器
- UC2544N - 集成电路(IC) > 电源管理(PMIC) > 电源控制器,监视器
- SN74ABT5400ADW - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- TL4050B41IDBZT - 集成电路(IC) > 电源管理(PMIC) > 电压基准
- ADS7863ARGET - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- SM74101SDX/NOPB - 集成电路(IC) > 电源管理(PMIC) > 栅极驱动器
- UC282TDTR-1 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- SN74LV273ADBRG4 - 集成电路(IC) > 逻辑 > 触发器
- TL594IPWE4 - 集成电路(IC) > 电源管理(PMIC) > DC-DC 开关控制器



SN74AVC16334 - 具有三态输出的 16 位通用总线驱动器
SN74AVC16334是TI德州仪器公司的一款通用总线驱动器(UBD)产品,SN74AVC16334是具有三态输出的 16 位通用总线驱动器,本站介绍了SN74AVC16334的封装应用图解、特点和优点、功能等,并给出了与SN74AVC16334相关的TI元器件型号供参考。
SN74AVC16334 - 具有三态输出的 16 位通用总线驱动器 - 通用总线驱动器(UBD) - 通用总线功能 - 德州仪器
A Dynamic Output Control (DOC) circuit is implemented, which, during the transition, initially lowers the output impedance to effectively drive the load and, subsequently, raises the impedance to reduce noise. Figure 1 shows typical VOL vs IOL and VOH vs IOH curves to illustrate the output impedance and drive capability of the circuit. At the beginning of the signal transition, the DOC circuit provides a maximum dynamic drive that is equivalent to a high-drive standard-output device. For more information, refer to the TI application reports, AVC Logic Family Technology and Applications, literature number SCEA006, and Dynamic Output Control (DOC) Circuitry Technology and Applications, literature number SCEA009.
This 16-bit universal bus driver is operational at 1.2-V to 3.6-V VCC, but is designed specifically for 1.65-V to 3.6-V VCC operation.
Data flow from A to Y is controlled by the output-enable (OE)\ input. The device operates in the transparent mode when the latch-enable (LE)\ input is low. When LE\ is high, the A data is latched if the clock (CLK) input is held at a high or low logic level. If LE\ is high, the A data is stored in the latch/flip-flop on the low-to-high transition of CLK. When OE\ is high, the outputs are in the high-impedance state.
To ensure the high-impedance state during power up or power down, OE\ should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
This device is fully specified for partial-power-down applications using Ioff. The Ioff circuitry disables the outputs, preventing damaging current backflow through the device when it is powered down.
- Member of the Texas Instruments Widebus Family
- DOC (Dynamic Output Control) Circuit Dynamically Changes Output Impedance, Resulting in Noise Reduction Without Speed Degradation
- Dynamic Drive Capability Is Equivalent to Standard Outputs With IOH and IOL of ±24 mA at 2.5-V VCC
- Overvoltage-Tolerant Inputs/Outputs Allow Mixed-Voltage-Mode Data Communications
- Ioff Supports Partial-Power-Down Mode Operation
- ESD Protection Exceeds JESD 22
- 2000-V Human-Body Model (A114-A)
- 200-V Machine Model (A115-A)
- Latch-Up Performance Exceeds 100 mA Per JESD 78, Class II
DOC and Widebus are trademarks of Texas Instruments.
- TPS3839G25 - 150nA 超低电流、超小型电压监控器
- TPS23754 - 具有高效集成 PWM 控制器的高功率 PoE 接口
- TPS55340-EP - 集成式 5A 40V 宽输入范围升压/SEPIC/反激式 DC-DC 稳压器
- DAC8501 - 乘法、低功耗、轨至轨输出、16 位串行输入数模转换器
- MSP430F47177 - 16 位超低功耗微控制器,具有 92KB 闪存、8KB RAM、7 个 Σ-Δ ADC 和 LCD 驱动器
- TPS65281-1 - 3A、4.5V 至 18V、精度可调节限流配电开关
- ADS808 - 12 位 70MSPS ADC,具有单端/差动输入、内部/外部参考、灵活时钟、可选择全范围和断电功能
- LM1881 - 视频同步分离器
- SN75LVDS83B - FlatLink 10-135MHz 发送器
- TLVH431 - 低电压可调节精密并联稳压器



