

- PT4141A - 板安装电源 > 直流转换器
- SN74F174AN - 集成电路(IC) > 逻辑 > 触发器
- UCD3040PFC - 集成电路(IC) > 电源管理(PMIC) > 电源管理 - 专用
- CC2630F128RGZT - 射频和无线 > 射频收发器 IC
- ADS1114LIDGSR - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- LM4040C41ILPR - 集成电路(IC) > 电源管理(PMIC) > 电压基准
- CD74HC597M96 - 集成电路(IC) > 逻辑 > 移位寄存器
- TPS54424RNVT - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- SN75HVD05P - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- TPS54526RSAR - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- TLV1117CDCYR - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- SN74AUP1G08YFPR - 集成电路(IC) > 逻辑 > 门和反相器
- TLV5625CD - 集成电路(IC) > 数据采集 > 数模转换器(DAC)
- TPSM63610EXTRDFR - 板安装电源 > 直流转换器
- TPS22993PRLWT - 集成电路(IC) > 电源管理(PMIC) > 配电开关,负载驱动器
- ADC121S051CIMF - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- V62/03632-09XE - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- TNETV6421INZDU4 - 集成电路(IC) > 嵌入式 > DSP(数字信号处理器)
- TPS71730DCKRG4 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- MPD23749DREP - 集成电路(IC) > 接口 > 驱动器,接收器,收发器



SN74AVCB164245-Q1 - 具有可配置电压转换和三态输出的汽车类 16 位双电源总线收发器
SN74AVCB164245-Q1是TI德州仪器公司的一款应用特定电压转换产品,SN74AVCB164245-Q1是具有可配置电压转换和三态输出的汽车类 16 位双电源总线收发器,本站介绍了SN74AVCB164245-Q1的封装应用图解、特点和优点、功能等,并给出了与SN74AVCB164245-Q1相关的TI元器件型号供参考。
SN74AVCB164245-Q1 - 具有可配置电压转换和三态输出的汽车类 16 位双电源总线收发器 - 应用特定电压转换 - 电压电平转换 - 德州仪器
This 16-bit (dual-octal) noninverting bus transceiver uses two separate configurable power-supply rails. The A port is designed to track VCCA. VCCA accepts any supply voltage from 1.4 V to 3.6 V. The B port is designed to track VCCB. VCCB accepts any supply voltage from 1.4 V to 3.6 V. This allows for universal low-voltage bidirectional translation between any of the 1.5-V, 1.8-V, 2.5-V, and 3.3-V voltage nodes.
The SN74AVCB164245 is designed for asynchronous communication between data buses. The device transmits data from the A bus to the B bus or from the B bus to the A bus, depending on the logic level at the direction-control (DIR) input. The output-enable (OE) input can be used to disable the outputs so the buses are effectively isolated.
The SN74AVCB164245 is designed so that the control pins (1DIR, 2DIR, 1OE, and 2OE) are supplied by VCCB.
To ensure the high-impedance state during power up or power down, OE should be tied to VCCB through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
This device is fully specified for partial-power-down applications using Ioff. The Ioff circuitry disables the outputs, preventing damaging current backflow through the device when it is powered down. If either VCC input is at GND, both ports are in the high-impedance state.
- Qualified for Automotive Applications
- Member of the Texas Instruments Widebus™ Family
- DOC™ Circuitry Dynamically Changes Output Impedance, Resulting in Noise Reduction Without Speed Degradation
- Dynamic Drive Capability Is Equivalent to Standard Outputs With IOH and IOL of ±24 mA at 2.5-V VCC
- Control Inputs VIH/VIL Levels Are Referenced to VCCB Voltage
- If Either VCC Input Is at GND, Both Ports Are in the High-Impedance State
- Overvoltage-Tolerant Inputs/Outputs Allow Mixed-Voltage-Mode Data Communications
- Ioff Supports Partial-Power-Down Mode Operation
- Fully Configurable Dual-Rail Design Allows Each Port to Operate Over Full 1.4-V to 3.6-V Power-Supply Range
- Latch-Up Performance Exceeds 100 mA Per JESD 78, Class II
- ESD Protection Exceeds JESD 22
- 2000-V Human-Body Model (A114-A)
- 200-V Machine Model (A115-A)
- 750-V Charged-Device Model (C101)
Widebus is a trademark of Texas Instruments. DOC is a trademark of Texas Instruments
- CD74HC4316 - 具有电平转换功能的高速 CMOS 四路模拟开关
- MSP430F2410 - 16 位超低功耗微控制器,具有 56KB 闪存、4KB RAM、12 位 ADC、2 个 USCI 和 HW 乘法器
- CD54HCT112 - 具有设置与复位功能和下降沿触发的高速 CMOS 逻辑双路 J-K 触发器
- DRV2667 - 具有升压、数字前端和内部波形存储器的压电式触觉驱动器
- LM2595 - SIMPLE SWITCHER 电源转换器 150 KHz 1A 降压电压稳压器
- SN75LBC184 - 瞬态电压抑制差动收发器
- SN54LVTH16373 - 具有三态输出的 3.3V ABT 16 位透明 D 类锁存器
- TPS61091 - 3.3V 500mA 输出的 96% 效率升压转换器,静态电流 20uA,采用 QFN-16 封装
- TLV1543 - 10 位 200 kSPS ADC 串行 输出,内置自检测模式,内部 S,引脚兼容。 TLC1543,11 通道
- UCC2819 - BiCMOS 功率因素前置稳压器



