

- LMK60A0-148M35SIAT - 晶体,振荡器,谐振器 > 振荡器
- LMV358QDDUR - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- SN74ALVTH16601DL - 集成电路(IC) > 逻辑 > 通用总线功能
- SCANSTA111SMX/NOPB - 集成电路(IC) > 接口 > 专用
- BQ21061YFPT - 集成电路(IC) > 电源管理(PMIC) > 电池充电器
- OPA4141AIPW - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- ISO7741FDBQR - 隔离器 > 数字隔离器
- INA4180A2IPWR - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TMP235AEDCKRQ1 - 传感器,变送器 > 温度传感器 > 模拟和数字输出
- SN74ALS32N - 集成电路(IC) > 逻辑 > 门和反相器
- DRV5055Z4QDBZR - 传感器,变送器 > 磁性传感器 > 线性、罗盘(IC)
- SN74V283PZAEP - 集成电路(IC) > 逻辑 > FIFO 存储器
- ADS7052IRUGR - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- LM124DRG4 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- UCC3895NG4 - 集成电路(IC) > 电源管理(PMIC) > DC-DC 开关控制器
- MSP430F5638IPZ - 集成电路(IC) > 嵌入式 > 微控制器
- TS5USBC410YFFT - 集成电路(IC) > 接口 > 模拟开关 - 特殊用途
- SN74LVC245APWRG3 - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- TPS54335EVM-556 - 开发板,套件,编程器 > 评估板 > DC/DC 和 AC/DC(离线)SMPS 评估板
- LP87694Q1EVM - 开发板,套件,编程器 > 评估板 > DC/DC 和 AC/DC(离线)SMPS 评估板



SN74AVCB164245 - 16 位双电源总线收发器,具有可配置 转换和三态输出
SN74AVCB164245是TI德州仪器公司的一款应用特定电压转换产品,SN74AVCB164245是16 位双电源总线收发器,具有可配置 转换和三态输出,本站介绍了SN74AVCB164245的封装应用图解、特点和优点、功能等,并给出了与SN74AVCB164245相关的TI元器件型号供参考。
SN74AVCB164245 - 16 位双电源总线收发器,具有可配置 转换和三态输出 - 应用特定电压转换 - 电压电平转换 - 德州仪器
This 16-bit (dual-octal) noninverting bus transceiver uses two separate configurable power-supply rails. The A port is designed to track VCCA. VCCA accepts any supply voltage from 1.4 V to 3.6 V. The B port is designed to track VCCB. VCCB accepts any supply voltage from 1.4 V to 3.6 V. This allows for universal low-voltage bidirectional translation between any of the 1.5-V, 1.8-V, 2.5-V, and 3.3-V voltage nodes.
The SN74AVCB164245 is designed for asynchronous communication between data buses. The device transmits data from the A bus to the B bus or from the B bus to the A bus, depending on the logic level at the direction-control (DIR) input. The output-enable (OE) input can be used to disable the outputs so the buses are effectively isolated.
The SN74AVCB164245 is designed so that the control pins (1DIR, 2DIR, 1OE, and 2OE) are supplied by VCCB.
To ensure the high-impedance state during power up or power down, OE should be tied to VCCB through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
This device is fully specified for partial-power-down applications using Ioff. The Ioff circuitry disables the outputs, preventing damaging current backflow through the device when it is powered down. If either VCC input is at GND, both ports are in the high-impedance state.
- Member of the Texas Instruments Widebus Family
- DOC Circuitry Dynamically Changes Output Impedance, Resulting in Noise Reduction Without Speed Degradation
- Dynamic Drive Capability Is Equivalent to Standard Outputs With IOH and IOL of ±24 mA at 2.5-V VCC
- Control Inputs VIH/VIL Levels Are Referenced to VCCB Voltage
- If Either VCC Input Is at GND, Both Ports Are in the High-Impedance State
- Overvoltage-Tolerant Inputs/Outputs Allow Mixed-Voltage-Mode Data Communications
- Ioff Supports Partial-Power-Down Mode Operation
- Fully Configurable Dual-Rail Design Allows Each Port to Operate Over Full 1.4-V to 3.6-V Power-Supply Range
- Latch-Up Performance Exceeds 100 mA Per JESD 78, Class II
- ESD Protection Exceeds JESD 22
- 2000-V Human-Body Model (A114-A)
- 200-V Machine Model (A115-A)
- 1000-V Charged-Device Model (C101)
Widebus, DOC are trademarks of Texas Instruments.
- DP83848YB - PHYTER 扩展温度单端口 10/100 Mb/s 以太网物理层收发器
- TLV733P - 用于便携式器件带有折返电流限制的无电容器,300mA,低压降稳压器
- TLV320DAC23 - 具有耳机放大器的低功耗立体声音频 DAC
- TMS320VC5402A - 定点数字信号处理器
- TPS6735 - 固定负 5V 200MA 反向 DC/DC 转换器
- SN74LS86A - 四路 2 输入异或门
- LM10500 - 5A Step-Down Energy Management Unit With PowerWise® Adaptive Voltage Scaling
- MSP430FR5727 - MSP430FR573x MSP430FR572x 混合信号微控制器
- TPS77515 - 单输出 LDO、500mA、固定电压 (1.5V)、快速瞬态响应、SVS
- DS92LX2121 - 10 - 50 MHz DC 平衡频道链接 III 双向性控制串行器



