

- SNJ54ALS374J - 集成电路(IC) > 逻辑 > 触发器
- LM22675QMRX-5.0/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- SN74AS756DWRG4 - 逻辑 - 缓冲器,驱动器,接收器,收发器
- TPS65033207RGERQ1 - 未分类 > 未分类
- TDES9640RURR - 集成电路(IC) > 接口 > 串行器,解串器
- OPA322SAIDBVR - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- DAC7564ICPWR - 集成电路(IC) > 数据采集 > 数模转换器(DAC)
- TPS7B8333QDCYRQ1M3 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- LP2985A-18DBVTG4 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- LMR14020QDPREVM - 开发板,套件,编程器 > 评估板 > DC/DC 和 AC/DC(离线)SMPS 评估板
- ADS1158IRTCR - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- TPS1HTC100QPWPRQ1 - 集成电路(IC) > 电源管理(PMIC) > 配电开关,负载驱动器
- CDC6CE019200ADLXR - 晶体,振荡器,谐振器 > 振荡器
- BQ27500DRZR-V120G4 - 集成电路(IC) > 电源管理(PMIC) > 电池管理
- LM9036DT-5.0/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- LM48410SQBD - 开发板,套件,编程器 > 评估板 > 音频放大器评估板
- LP38690SDX-2.5/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- S4MF03107SPZQQ1R - 集成电路(IC) > 嵌入式 > 微控制器
- TLV70025DDCR - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- LM3678SDX-1.2/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器



TPS2420 - 具有负载电流监控功能的 3-20V 集成 FET 0-5A 双故障阀值热插拔
TPS2420是TI德州仪器公司的一款eFuses(集成FET)产品,TPS2420是具有负载电流监控功能的 3-20V 集成 FET 0-5A 双故障阀值热插拔,本站介绍了TPS2420的封装应用图解、特点和优点、功能等,并给出了与TPS2420相关的TI元器件型号供参考。
TPS2420 - 具有负载电流监控功能的 3-20V 集成 FET 0-5A 双故障阀值热插拔 - eFuses(集成FET) - 保护、监控和热插拔 - 德州仪器
The TPS2420 device provides highly integrated load protection for applications up to 20-V. The maximum UV turn-on threshold of 2.9 V makes the TPS2420 well suited to standard bus voltages as low as 3.3 V. The TPS2420 device protects loads, minimizes inrush current, and safely shuts down in the event of a fault. The programmable fault current threshold starts the fault timer while allowing the current to pass to the load uninhibited. The programmable current limit threshold sets the maximum current allowed into the load, for both inrush and severe load faults. Both events use the programmable timer which inhibits all current to the load when it expires.
The dual protection thresholds are useful in applications such as disk drives. The start-up and seek currents are typically higher than the nominal current and during this time the load needs a low impedance path to deliver the power. If a failure at the load occurs, the current limit does not allow the current to exceed the programmed threshold. This protects both the load and the integrity of the power supply. The internal MOSFET is protected by power limit circuitry which ensures that the MOSFET remains within its safe operating area (SOA) during all operating states.
The TPS2420 device also allows the system to monitor load currents with no need for a shunt in the power path. The gain of the current monitor can be scaled to the application. Fault and power good outputs are provided for improved system management and sequencing control.
This device can be programmed to either latch-off or retry in the event of a fault. All of this functionality is packed into a 16-pin 4 × 4 mm QFN package.
- Integrated 30-mΩ Pass MOSFET
- Up to 20-V Bus Operation
- Programmable Fault Current
- Programmable Hard Current-Limit
- Programmable Fault Timer
- Internal MOSFET Power Limiting Foldback
- Latching and Auto-Retry Operation
- Analog Current Monitor Output
- Powergood Output
- Fault Output Indicator
- 4 mm × 4 mm QFN
- –40°C to 125°C Junction Temperature Range
- UL2367 Recognized - File Number E169910
- LM7912 - 3 端子负电压稳压器
- TAS5121I - 100W 单声道数字放大器功率级
- TMP102-Q1 - 采用微型 SOT-563 封装的汽车级超低功耗数字温度传感器
- ADC121C021-Q1 - 具有报警引脚的汽车类 I2C 兼容、12 位模数转换器
- ADS7852 - 12 位 8 通道并行输出模数转换器
- LM4121 - 精密微功耗低压降电压基准
- TAS5414C-Q1 - 4 通道汽车数字放大器
- DAC7811 - 12 位串行输入乘法数模转换器
- ADS1202 - 电流并联 Δ-Σ 调制器,具有 10MHz 时钟、+/-250mV 输入 和 16 位分辨率
- ADS4222 - 12 位 65MSPS 双路低功耗 ADC



