
- TLC540IN - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- TPIC6C595DRG4 - 集成电路(IC) > 逻辑 > 移位寄存器
- CD4043BEE4 - 集成电路(IC) > 逻辑 > 锁存器
- SN74HC4851PWRG4 - 集成电路(IC) > 接口 > 模拟开关,多路复用器,解复用器
- DRV8213DSGR - 集成电路(IC) > 电源管理(PMIC) > 电机驱动器,控制器
- OPA2107AP - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- SN75C3232DRE4 - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- ADC6120EVM-PDK - 开发板,套件,编程器 > 评估板 > 评估和演示板及套件
- CC1110F32RSPG3 - 射频和无线 > 射频收发器 IC
- SN103764DR - 集成电路(IC) > 接口 > 模拟开关 - 特殊用途
- LP2989AIM-5.0/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- SN74ALS621A-1DW - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- TLC075IN - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TMS320DM6433ZWT5 - 集成电路(IC) > 嵌入式 > DSP(数字信号处理器)
- CD4014BM - 集成电路(IC) > 逻辑 > 移位寄存器
- ADS1231REF - 开发板,套件,编程器 > 评估板 > 模数转换器(ADC)评估板
- TLV2432AID - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- MSP430G2253IPW20 - 集成电路(IC) > 嵌入式 > 微控制器
- PT4503N - 板安装电源 > 直流转换器
- CD74HC4351M - 集成电路(IC) > 接口 > 模拟开关,多路复用器,解复用器



TPS40197 - 具有 4 位 VID 接口和电源状态良好指示的 4.5V 至 14V 输入同步降压控制器
TPS40197是TI德州仪器公司的一款控制器(外部开关)产品,TPS40197是具有 4 位 VID 接口和电源状态良好指示的 4.5V 至 14V 输入同步降压控制器,本站介绍了TPS40197的封装应用图解、特点和优点、功能等,并给出了与TPS40197相关的TI元器件型号供参考。
TPS40197 - 具有 4 位 VID 接口和电源状态良好指示的 4.5V 至 14V 输入同步降压控制器 - 控制器(外部开关) - DC/DC开关稳压器 - 德州仪器
The TPS40197 is a synchronous buck controller that operates from 4.5 V to 14 V input supply nominally. The controller implements voltage-mode control architecture with the switching frequency fixed at 520kHz. The higher switching frequency facilitates the use of smaller inductor and output capacitors, thereby providing a compact power-supply solution. An adaptive anti-cross conduction scheme is used to prevent shoot through current in the power FETs.
The TPS40197 integrates the PWM control and 4-bit VID interface in a single chip to allow seamless on-the-fly VID changes with programmable transition rate. It provides a simple power solution for Smart-Reflex™ DSP cores.
Short circuit detection is done by sensing the voltage drop across the low-side FET when it is on and comparing it with a user selected threshold of 100 mV, 200 mV or 280 mV. The threshold is set with a single external resistor connected from COMP to GND. This resistor is sensed at startup and the selected threshold is latched. Pulse by pulse limiting (to prevent current runaway) is provided by sensing the voltage across the high-side FET when it is on and terminating the cycle when the voltage drop rises above a fixed threshold of 550 mV. When the controller senses an output short circuit, both FETs are turned off and a timeout period is observed before attempting to restart. This provides limited power dissipation in the event of a sustained fault.
- Input Voltage Range: 4.5 V to 14 V
- 4-Bit Dynamic VID-On-The-Fly Support
- VID Programmable Output Voltage with Programmable Transition Rate
- Fixed Switching Frequency of 520kHz
- Selectable Low-Side (Three Settings) and Fixed High-Side Thermally Compensated Overcurrent Protection
- Power Good Indicator
- Internal 5-V Regulator
- Voltage Mode Control
- Internally Fixed 5.5-ms Soft-Start Time
- Pre-Bias Output Safe
- Thermal Shutdown at 140°C
- 16-Pin QFN Package
- LSF0204D - 适用于漏极开路和推挽应用的 4 位双向多电压电平转换器
- UCC3973 - BiCMOS 冷阴极荧光灯驱动器控制器
- TPS62736 - 具有 50mA 负载能力的可编程输出毫微功率降压转换器
- LM4990 - 2 Watt Audio Power Amplifier with Selectable Shutdown Logic Level
- TL3844B - TL284xB, TL384xB
- 74SSTUB32868 - 28-Bit to 56-Bit Registered Buffer with Address-Parity Test
- MC79L15A - 3 引脚 100mA 固定 (-15V) 负电压稳压器
- SN74AHCT1G86-Q1 - 汽车类单路 2 输入异或门
- TL5001A-Q1 - 汽车类脉冲宽度调制控制电路
- UA7805 - 5V 1.5A 固定正电压稳压器



