



- SN74LVTH244ADWR - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- LM78M05CH - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- TLC1543CFNRG3 - 数据采集 - 模数转换器(ADC)
- TLV76750DRVT - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- CY74FCT823BTPC - 集成电路(IC) > 逻辑 > 触发器
- DS90LV048ATM/DRPB - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- TLV1549CPG4 - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- TLE2084CDW - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- LP38692SD-3.3/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- TLE2022AID - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TLC279IN - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TPL5010DDCT - 集成电路(IC) > 时钟/定时 > 可编程定时器和振荡器
- TMS5701224BZWTQQ1 - 集成电路(IC) > 嵌入式 > 微控制器
- ADS7822EC/2K5G4 - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- MSP430F149IPMRG4 - 集成电路(IC) > 嵌入式 > 微控制器
- UC3827DWTR-1G4 - 电源管理IC - 稳压器 - DC DC 开关式控制器
- THS3202DG4 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- CD4503BE - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- INA213AQDCKRQ1 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- 2512737-0002R - 集成电路(IC) > 电源管理(PMIC) > 显示驱动器



TPS61003 - 具有固定 2.5V 输出的低输入电压升压转换器
TPS61003是TI德州仪器公司的一款转换器(集成开关)产品,TPS61003是具有固定 2.5V 输出的低输入电压升压转换器,本站介绍了TPS61003的封装应用图解、特点和优点、功能等,并给出了与TPS61003相关的TI元器件型号供参考。
TPS61003 - 具有固定 2.5V 输出的低输入电压升压转换器 - 转换器(集成开关) - DC/DC开关稳压器 - 德州仪器
- Start-Up Into a Full Load With Supply Voltages as Low as 0.9 V Over Full Temperature Range
- Minimum 100-mA Output Current From 0.8-V Supply Voltage, 250 mA From 1.8 V
- High Power Conversion Efficiency, up to 90%
- Power-Save Mode for Improved Efficiency at Low Output Currents
- Device Quiescent Current Less Than 50 µA
- Added System Security With Integrated Low-Battery Comparator
- Low-EMI Converter (Integrated Antiringing Switch Across Inductor)
- Micro-Size 10-Pin MSOP Package
- Evaluation Modules Available (TPS6100xEVM–156)
- Single- and Dual-Cell Battery Operated Products
- MP3-Players and Wireless Headsets
- Pagers and Cordless Phones
- Portable Medical Diagnostic Equipment
- Remote Controls
The TPS6100x devices are boost converters intended for systems that are typically operated from a single- or dual-cell nickel-cadmium (NiCd), nickel-metal hydride (NiMH), or alkaline battery. The converter output voltage can be adjusted from 1.5 V to a maximum of 3.3 V and provides a minimum output current of 100 mA from a single battery cell and 250 mA from two battery cells. The converter starts up into a full load with a supply voltage of 0.9 V and stays in operation with supply voltages as low as 0.8 V.
The converter is based on a fixed-frequency, current-mode pulse-width-modulation (PWM) controller that goes into power-save mode at low load currents. The current through the switch is limited to a maximum of 1100 mA, depending on the output voltage. The current sense is integrated to further minimize external component count. The converter can be disabled to minimize battery drain when the system is put into standby.
A low-EMI mode is implemented to reduce interference and radiated electromagnetic energy that is caused by the ringing of the inductor when the inductor discharge-current decreases to zero. The device is packaged in the space-saving 10-pin MSOP package.
| PART NUMBER | PACKAGE | BODY SIZE (NOM) |
|---|---|---|
| TPS6100x | VSSOP (10) | 3.00 mm × 3.00 mm |
- DS90UR904Q-Q1 - 10 - 43MHz 18 Bit Color FPD-Link II Deserializer
- LM4308 - Mobile Pixel Link Two (MPL-2) - 18 位 CPU 显示接口主/从
- INA270 - Voltage Output High-Side Measurement Current-Shunt Monitor
- TPS71933-28 - 200mA 输出、低噪声、高 PSRR、低压降双路线性稳压器
- UC3861 - 谐振模式电源控制器
- CD40257B-MIL - COMS 四路 2 线路至 1 线路数据选择器/多路复用器
- SN54HC132-SP - 具有施密特触发器输入的四路正与非门
- CDCP1803 - 具有可编程除法器的 1:3 LVPECL 时钟缓冲器
- ADS6143 - 具有可选并行 CMOS 或 LVDS 输出的低功耗 14 位 80MSPS ADC
- SN74LVCH16374A - 具有三态输出的 16 位边沿 D 类触发器



