



- LM56CIMX - 传感器,变送器 > 温度传感器 > 模拟和数字输出
- OPA627AU/2K5G4 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- SN74LS243NE4 - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- LP877020RHBRQ1 - 集成电路(IC) > 电源管理(PMIC) > 电源管理 - 专用
- LP2986AIMX-3.0 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- CD74HC564M - 集成电路(IC) > 逻辑 > 触发器
- PGA204BPG4 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TMCS1127A4AQDVGR - 传感器,变送器 > 电流传感器
- TLV70033DDCT - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- LM6172IMX - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- AFE11612EVM - 开发板,套件,编程器 > 评估板 > 评估和演示板及套件
- TL16C550CN - 集成电路(IC) > 接口 > UART(通用异步接收器发送器)
- CD4504BM - 集成电路(IC) > 逻辑 > 转换器,电平移位器
- TPS74801QDRCRM3Q1 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- M0G3105QRHBRQ1 - 集成电路(IC) > 嵌入式 > 微控制器
- TPS274C65ASRHAR - 集成电路(IC) > 电源管理(PMIC) > 配电开关,负载驱动器
- LP5952TL-1.5EV - 开发板,套件,编程器 > 评估板 > 线性稳压器评估板
- TRS3243CPWR - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- SN74AHCT14RGYRG4 - 集成电路(IC) > 逻辑 > 门和反相器
- LM2707MFX/NOPB - 集成电路(IC) > 电源管理(PMIC) > LED 驱动器



TPS61007 - 具有可调节输出的低输入电压升压转换器
TPS61007是TI德州仪器公司的一款转换器(集成开关)产品,TPS61007是具有可调节输出的低输入电压升压转换器,本站介绍了TPS61007的封装应用图解、特点和优点、功能等,并给出了与TPS61007相关的TI元器件型号供参考。
TPS61007 - 具有可调节输出的低输入电压升压转换器 - 转换器(集成开关) - DC/DC开关稳压器 - 德州仪器
- Start-Up Into a Full Load With Supply Voltages as Low as 0.9 V Over Full Temperature Range
- Minimum 100-mA Output Current From 0.8-V Supply Voltage, 250 mA From 1.8 V
- High Power Conversion Efficiency, up to 90%
- Power-Save Mode for Improved Efficiency at Low Output Currents
- Device Quiescent Current Less Than 50 µA
- Added System Security With Integrated Low-Battery Comparator
- Low-EMI Converter (Integrated Antiringing Switch Across Inductor)
- Micro-Size 10-Pin MSOP Package
- Evaluation Modules Available (TPS6100xEVM–156)
- Single- and Dual-Cell Battery Operated Products
- MP3-Players and Wireless Headsets
- Pagers and Cordless Phones
- Portable Medical Diagnostic Equipment
- Remote Controls
The TPS6100x devices are boost converters intended for systems that are typically operated from a single- or dual-cell nickel-cadmium (NiCd), nickel-metal hydride (NiMH), or alkaline battery. The converter output voltage can be adjusted from 1.5 V to a maximum of 3.3 V and provides a minimum output current of 100 mA from a single battery cell and 250 mA from two battery cells. The converter starts up into a full load with a supply voltage of 0.9 V and stays in operation with supply voltages as low as 0.8 V.
The converter is based on a fixed-frequency, current-mode pulse-width-modulation (PWM) controller that goes into power-save mode at low load currents. The current through the switch is limited to a maximum of 1100 mA, depending on the output voltage. The current sense is integrated to further minimize external component count. The converter can be disabled to minimize battery drain when the system is put into standby.
A low-EMI mode is implemented to reduce interference and radiated electromagnetic energy that is caused by the ringing of the inductor when the inductor discharge-current decreases to zero. The device is packaged in the space-saving 10-pin MSOP package.
| PART NUMBER | PACKAGE | BODY SIZE (NOM) |
|---|---|---|
| TPS6100x | VSSOP (10) | 3.00 mm × 3.00 mm |
- MSP430F67691 - MSP430F677x1、MSP430F676x1 、MSP430F674x1 混合信号微处理器
- TPS3707-50 - 具有电源故障检测功能的处理器监控电路
- TPS2210A - 具有串行接口的 1A 单槽 PC 卡电源开关
- CD4512B-MIL - CMOS 8 通道数据选择器
- LM3724 - 5 引脚微处理器重置电路
- ADC081C021 - 具有警报引脚的 I2C 兼容、8 位模数转换器
- TPS5130 - 具有 LDO 控制器的三路同步降压控制器
- ADC14155QML-SP - 14-Bit, 155 MSPS, 1.1 GHz Bandwidth A/D Converter
- UC3846 - 电流模式 PWM 控制器
- CD54HCT20 - 高速 CMOS 逻辑双路 4 输入与非门



