

- SNJ54AS652W - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- DS160PR1601ZDGR - 集成电路(IC) > 接口 > 信号缓冲器、中继器、分离器
- TPS546A24AEVM-1PH - 开发板,套件,编程器 > 评估板 > DC/DC 和 AC/DC(离线)SMPS 评估板
- SN74ALS541-1NS - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- MSP430FR2153TDBT - 集成电路(IC) > 嵌入式 > 微控制器
- UCC21541DW - 隔离器 > 隔离器 - 栅极驱动器
- SN74HCT373NG4 - 集成电路(IC) > 逻辑 > 锁存器
- SN65HVD62RGTR - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- TPS73030DBVR - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- DRV8811PWPR - 集成电路(IC) > 电源管理(PMIC) > 电机驱动器,控制器
- TPUL2G122ADRQ1 - 集成电路(IC) > 逻辑 > 多谐振荡器
- DCP010507DBP-UE4 - 板安装电源 > 直流转换器
- PTB48511BAS - 直流转换器
- SN74LV245ATPWT - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- LP3907SQ-TJXIP/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性 + 开关
- MSP430F5234IRGZR - 集成电路(IC) > 嵌入式 > 微控制器
- LP5907SNX-2.8/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- TLV2782AIDRG4 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- LM2941S - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- LP3470M5X-3.08/NOPB - 集成电路(IC) > 电源管理(PMIC) > 监控器



TPS63000-Q1 - 采用 3x3 QFN 封装,具有 1.8A 电流开关的汽车类 96% 升压降压转换器
TPS63000-Q1是TI德州仪器公司的一款转换器(集成开关)产品,TPS63000-Q1是采用 3x3 QFN 封装,具有 1.8A 电流开关的汽车类 96% 升压降压转换器,本站介绍了TPS63000-Q1的封装应用图解、特点和优点、功能等,并给出了与TPS63000-Q1相关的TI元器件型号供参考。
TPS63000-Q1 - 采用 3x3 QFN 封装,具有 1.8A 电流开关的汽车类 96% 升压降压转换器 - 转换器(集成开关) - DC/DC开关稳压器 - 德州仪器
The TPS63000 devices provide a power supply solution for products powered by either a two-cell or three-cell alkaline, NiCd or NiMH battery, or a one-cell Li-Ion or Li-polymer battery. Output currents can go as high as 1200 mA while using a single-cell Li-Ion or Li-Polymer battery, and discharge it down to 2.5 V or lower. The buck-boost converter is based on a fixed frequency, pulse-width-modulation (PWM) controller using synchronous rectification to obtain maximum efficiency. At low load currents, the converter enters Power Save mode to maintain high efficiency over a wide load current range. The Power Save mode can be disabled, forcing the converter to operate at a fixed switching frequency. The maximum average current in the switches is limited to a typical value of 1800 mA. The output voltage is programmable using an external resistor divider. The converter can be disabled to minimize battery drain. During shutdown, the load is disconnected from the battery. The device is packaged in a 10-pin QFN PowerPAD package measuring 3 mm × 3 mm (DRC).
- Qualified for Automotive Applications
- Up to 96% Efficiency
- 1200-mA Output Current at 3.3 V in Step Down Mode (VIN = 3.6 V to 5.5 V)
- Up to 800-mA Output Current at 3.3 V in Boost Mode (VIN > 2.4 V)
- Automatic Transition between Step Down and Boost Mode
- Device Quiescent Current Less Than 50 µA
- Input Voltage Range: 1.8 V to 5.5 V
- Adjustable Output Voltage From 1.2 V to 5.5 V
- Power Save Mode for Improved Efficiency at Low Output Power
- Forced Fixed Frequency Operation and Synchronization Possible
- Load Disconnect During Shutdown
- Over-Temperature Protection
- Available in Small 3 mm × 3 mm, QFN-10 Package
- APPLICATIONS
- All Two-Cell and Three-Cell Alkaline, NiCd or NiMH or Single-Cell Li Battery Powered Products
- Portable Audio Players
- PDAs
- Cellular Phones
- Personal Medical Products
- White LEDs
PowerPAD Is a trademark of Texas Instruments. All other trademarks are the property of their respective owners.
- PCM2707 - 具有 USB 接口、耳机输出和 S/PDIF 输出的立体声音频 DAC
- DAC7613 - 12 位电压输出数模转换器
- UC282-1 - 单输出 LDO、3.0A、固定电压 (1.5V)、快速瞬态响应、低静态电流
- CDC339 - 具有清零功能的 1 至 8(其中 4 个频率相同,另外 4 个的频率除 2)时钟驱动器
- MSP430F5310 - MSP430F530x 混合信号微处理器
- TPS75333-EP - 增强型产品快速瞬态响应 1.5A 低压降稳压器
- LP38691 - 借助陶瓷输出电容实现稳定的 500mA 低压降 CMOS 线性稳压器
- SN74HC32 - 四路 2 输入正或门
- TPS65190 - 用于 LCD 显示屏的 10 通道电平转换器,具有 VCOM 运算放大器
- MSP430F2254 - 16 位超低功耗微控制器,具有 16KB 闪存和 512B RAM



