TPS75333 - 单输出 LDO、1.5A、固定电压 (3.3V)、电源良好 (PG) 输出、快速瞬态响应

TPS75333是TI德州仪器公司的一款单通道LDO产品，TPS75333是单输出 LDO、1.5A、固定电压 (3.3V)、电源良好 (PG) 输出、快速瞬态响应，本站介绍了TPS75333的封装应用图解、特点和优点、功能等，并给出了与TPS75333相关的TI元器件型号供参考。

TPS75333 - 单输出 LDO、1.5A、固定电压 (3.3V)、电源良好 (PG) 输出、快速瞬态响应 - 单通道LDO - 线性稳压器(LDO) - 德州仪器

产品描述

The TPS753xxQ and TPS751xxQ devices are low-dropout regulators with integrated power-on reset and power-good (PG) functions respectively. These devices are capable of supplying 1.5 A of output current with a dropout of 160 mV (TPS75133Q, TPS75333Q). Quiescent current is 75 µA at full load and drops down to 1 µA when the device is disabled. These devices are designed to have fast transient response for larger load current changes.

Because the PMOS device behaves as a low-value resistor, the dropout voltage is very low (typically 160 mV at an output current of 1.5 A for the TPS75x33Q) and is directly proportional to the output current. Additionally, because the PMOS pass element is a voltage-driven device, the quiescent current is very low and independent of output loading (typically 75 µA over the full range of output current, 1 mA to 1.5 A). These two key specifications yield a significant improvement in operating life for battery-powered systems.

The device is enabled when EN is connected to a low-level input voltage. This LDO family also features a sleep mode; applying a TTL high signal to EN (enable) shuts down the regulator, reducing the quiescent current to less than 1 µA at TJ = +25°C.

For the TPS751xxQ, the power-good terminal (PG) is an active high, open drain output for use with a power-on reset or a low-battery indicator.

The RESET (SVS, POR, or power on reset) output of the TPS753xxQ initiates a reset in microcomputer and microprocessor systems in the event of an undervoltage condition. An internal comparator in the TPS753xxQ monitors the output voltage of the regulator to detect an undervoltage condition on the regulated output voltage. When the output reaches 95% of its regulated voltage, RESET goes to a high-impedance state after a 100-ms delay. RESET goes to a logic-low state when the regulated output voltage is pulled below 95% (that is, during an overload condition) of its regulated voltage.

The TPS751xxQ and TPS753xxQ are offered in 1.5 V, 1.8 V, 2.5 V and 3.3 V fixed-voltage versions and in an adjustable version (programmable over the range of 1.5 V to 5 V). Output voltage tolerance is specified as a maximum of 2% over line, load, and temperature ranges. The TPS751xxQ and TPS753xxQ families are available in a 20-pin TSSOP (PWP) package.

产品特性

1.5-A Low-Dropout Voltage Regulator
Available in 1.5 V, 1.8 V, 2.5 V, and 3.3 V Fixed Output and Adjustable Versions
Open Drain Power-Good (PG) Status Output (TPS751xxQ)
Open Drain Power-On Reset With 100msDelay (TPS753xxQ)
Dropout Voltage Typically 160 mV at 1.5 A (TPS75133Q)
Ultralow 75-µA Typical Quiescent Current
Fast Transient Response
2% Tolerance Over Specified Conditions for Fixed-Output Versions
20-Pin TSSOP PowerPAD™ (PWP) Package
Thermal Shutdown Protection
APPLICATIONS
- Telecom
- Servers
- DSP, FPGA Supplies

PowerPAD is a trademark of Texas Instruments. All other trademarks are the property of their respective owners.

下面可能是您感兴趣的TI德州仪器公司单通道LDO元器件

TI公司产品现货专家，订购TI公司产品不限最低起订量，TI芯片大陆现货即时发货，香港库存3-5天发货，海外库存7-10天发货

寻找全球TI代理商现货货源 - TI公司（德州仪器）电子元件在线订购