

- ADS1015IRUGR - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- DS15BR401TSQX - 接口 - 信号缓冲器、中继器、分离器
- LM25117PSQ/NOPB - 集成电路(IC) > 电源管理(PMIC) > DC-DC 开关控制器
- TLK106RHBR - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- TPS3836E18DBVT - 集成电路(IC) > 电源管理(PMIC) > 监控器
- SN65HVD09DGGR - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- CDC2536DBR - 集成电路(IC) > 时钟/定时 > 时钟发生器,PLL,频率合成器
- UA741CPSR - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- CD40192BNSR - 集成电路(IC) > 逻辑 > 计数器,除法器
- TPIC9201PWP - 集成电路(IC) > 电源管理(PMIC) > 配电开关,负载驱动器
- EKT-LM3S6965 - 开发板,套件,编程器 > 评估板 > 嵌入式 MCU、DSP 评估板
- TRSF3221IDBG4 - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- TLC372MUB - 集成电路(IC) > 线性 > 比较器
- SN65C3223EDBG4 - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- THS7347IPHPG4 - 集成电路(IC) > 线性 > 放大器 > 视频放大器和模块
- LMX2325TMX - 集成电路(IC) > 时钟/定时 > 时钟发生器,PLL,频率合成器
- LM4780TA/NOPB - 集成电路(IC) > 线性 > 放大器 > 音频放大器
- TLV74125PDQNR - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- SN74ABT534ADW - 集成电路(IC) > 逻辑 > 触发器
- LP3991TL-1.2EV - 开发板,套件,编程器 > 评估板 > 线性稳压器评估板



UCC2583 - 开关模式二次侧后稳压器
UCC2583是TI德州仪器公司的一款PWM与谐振控制器产品,UCC2583是开关模式二次侧后稳压器,本站介绍了UCC2583的封装应用图解、特点和优点、功能等,并给出了与UCC2583相关的TI元器件型号供参考。
UCC2583 - 开关模式二次侧后稳压器 - PWM与谐振控制器 - 离线隔离型DC/DC控制器和转换器 - 德州仪器
The UCC3583 is a synchronizable secondary side post regulator for precision regulation of the auxiliary outputs of multiple output power supplies. It contains a leading edge pulse width modulator, which generates the gate drive signal for a FET power switch connected in series with the rectifying diode. The turn-on of the power switch is delayed from the leading edge of the secondary power pulse to regulate the output voltage. The UCC3583 contains a ramp generator slaved to the secondary power pulse, a voltage error amplifier, a current error amplifier, a PWM comparator and associated logic, a gate driver, a precision reference, and protection circuitry.
The ramp discharge and termination of the gate drive signal are triggered by the synchronization pulse, typically derived from the falling edge of the transformer secondary voltage. The ramp starts charging again once its low threshold is reached. The gate drive signal is turned on when the ramp voltage exceeds the control voltage. This leading edge modulation technique prevents instability when the UCC3583 is used in peak current mode primary controlled systems.
The controller operates from a floating power supply referenced to the output voltage being controlled. It features an undervoltage lockout (UVLO) circuit, a soft start circuit, and an averaging current limit amplifier. The current limit can be programmed to be proportional to the output voltage, thus achieving foldback operation to minimize the dissipation under short circuit conditions.
- Precision Secondary Side Post Regulation for Multiple Output Power Supplies
- Useful for Both Single Ended and Center Tapped Secondary Circuits
- Ideal Replacement for Complex Magnetic Amplifier Regulated Circuits
- Leading Edge Modulation
- Does Not Require Gate Drive Transformer
- High Frequency (>500kHz) Operation
- Applicable for Wide Range of Output Voltages
- High Current Gate Driver (0.5A Sink/1.5A Source)
- Average Current Limiting Loop
- UC1836 - 高效率稳压器
- SN54LS47 - BCD 到 7 段解码器/驱动器
- PTV05020W - 18A 5V 输入非隔离宽调节 SIP 模块
- BQ2057W - 锂离子低压降线性 (8.4V) 充电管理 IC,用于具有 AutoCompTM 的两节应用领域
- MSP430FR5948 - Wolverine 混合信号微控制器
- TL2575HV-ADJ - 具有输出使能端的 1A 简易步降电压可调节开关稳压器
- SN54S373 - 具有三态输出的八路 D 类透明锁存器
- SN74AVCA406 - MMC、SD、Memory Stick、Smart Media 和 XD-Picture Card 电压转换收发器
- LM3530 - 具有可编程环境光感应功能的高效白光 LED 驱动器
- CD54AC283 - 具有快速进位的 4 位二进制全加器



