This device is designed to multiplex signals from 4-bit data sources to four output data lines in bus-organized systems. The 3-state outputs do not load the data lines when the output-enable (OE\) input is at a high logic level.

To ensure the high-impedance state during power up or power down, OE\ should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.

• 3-State Outputs Interface Directly With System Bus
• Flow-Through Architecture Optimizes PCB Layout
• Center-Pin VCC and GND Configurations Minimize High-Speed Switching Noise
• 500-mA Typical Latch-Up Immunity at 125°C
• Provides Bus Interface From Multiple Sources in High-Performance Systems

• SN75DP122A - 具有集成 TMDS 转换器的 DisplayPort 1:2 开关
• TPS53211 - Single Phase PWM Controller with Light-Load Efficiency Optimization
• CDC208 - 5V 双路 1 至 4 时钟驱动器
• PTH04T240F - 用于 3GHz DSP 系统的 10A 2.2V 至 5.5V 输入的电源模块
• TLV2548Q - 汽车类 12 位 200kSPS ADC，具有串行 输出、自动断电（软件和硬件）和低功耗
• TLV5637 - 10 位 1us DAC，具有串行输入、双路 DAC、可编程内部参考和稳定时间
• MSP430G2152 - MSP430G2x52、MSP430G2x12 混合信号微处理器
• LM4040C10 - 10V 精密微功耗并联电压参考，0.5% 精确度
• LMZ10501 - 具有 5.5V 最大输入电压的 1A SIMPLE SWITCHER 纳米模块
• LM5009A - 100V、150mA 宽输入电压恒定导通时间降压开关稳压器