

- LMK62A2-100M00SIAR - 晶体,振荡器,谐振器 > 振荡器
- SN74CBT3244PWRE4 - 集成电路(IC) > 逻辑 > 信号开关,多路复用器,解码器
- MSP430P337AIPJM - 集成电路(IC) > 嵌入式 > 微控制器
- SN74HCT377DW - 集成电路(IC) > 逻辑 > 触发器
- INA186A1IDDFR - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TLVH431BQLPRE3 - 集成电路(IC) > 电源管理(PMIC) > 电压基准
- TPS61096DSST - 电源管理IC - 稳压器 - DC DC 开关稳压器
- TNETV2685VIDZUT5 - 嵌入式 - DSP(数字信号处理器)
- 8607601EA - 集成电路(IC) > 逻辑 > 计数器,除法器
- REG711EA27250G4 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- LM360M/NOPB - 集成电路(IC) > 线性 > 比较器
- OPA2704UA/2K5G4 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TPS54260QDGQRQ1 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- LMC6001BIN/NOPB - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TPS7225QPWR - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- LM1086CSX-2.85/NOPB - 电源管理IC - 稳压器 - 线性
- CD74ACT297M96 - 时钟-定时 - 时钟发生器,PLL,频率合成器
- SN74FB2031RCR - 集成电路(IC) > 逻辑 > 专用逻辑器件
- THS4120CDRG4 - 线性器件 - 放大器 - 仪器、运算放大器、缓冲放大器
- TL7733BID - 集成电路(IC) > 电源管理(PMIC) > 监控器



CD74HC123 - 具有复位功能的高速 CMOS 逻辑双路可重触发单稳多频振荡器
CD74HC123是TI德州仪器公司的一款单稳多频振荡器产品,CD74HC123是具有复位功能的高速 CMOS 逻辑双路可重触发单稳多频振荡器,本站介绍了CD74HC123的封装应用图解、特点和优点、功能等,并给出了与CD74HC123相关的TI元器件型号供参考。
CD74HC123 - 具有复位功能的高速 CMOS 逻辑双路可重触发单稳多频振荡器 - 单稳多频振荡器 - 特殊逻辑 - 德州仪器
The HC123, HCT123, CD74HC423 and CD74HCT423 are dual monostable multivibrators with resets. They are all retriggerable and differ only in that the 123 types can be triggered by a negative to positive reset pulse; whereas the 423 types do not have this feature. An external resistor (RX) and an external capacitor (CX) control the timing and the accuracy for the circuit. Adjustment of Rx and CX provides a wide range of output pulse widths from the Q and Q\ terminals. Pulse triggering on the A\ and B inputs occur at a particular voltage level and is not related to the rise and fall times of the trigger pulses.
Once triggered, the output pulse width may be extended by retriggering inputs A\ and B. The output pulse can be terminated by a LOW level on the Reset (R) pin. Trailing edge triggering (A)\ and leading edge triggering (B) inputs are provided for triggering from either edge of the input pulse. If either Mono is not used each input on the unused device (A\, B, and R\) must be terminated high or low.
The minimum value of external resistance, Rx is typically 5k. The minimum value external capacitance, CX, is 0pF. The calculation for the pulse width is tW = 0.45 RXCX at VCC = 5V.
- Overriding Reset Terminates Output Pulse
- Triggering From the Leading or Trailing Edge
- Q and Q\ Buffered Outputs
- Separate Resets
- Wide Range of Output-Pulse Widths
- Schmitt Trigger on Both A\ and B Inputs
- Fanout (Over Temperature Range)
- Standard Outputs . . . . . . . . . . . . . . . 10 LSTTL Loads
- Bus Driver Outputs . . . . . . . . . . . . . 15 LSTTL Loads
- Wide Operating Temperature Range . . . 55°C to 125°C
- Balanced Propagation Delay and Transition Times
- Significant Power Reduction Compared to LSTTL Logic ICs
- HC Types
- 2V to 6V Operation
- High Noise Immunity: NIL = 30%, NIH = 30% of VCC at VCC = 5V
- HCT Types
- 4.5V to 5.5V Operation
- Direct LSTTL Input Logic Compatibility, VIL = 0.8V (Max), VIH = 2V (Min)
- CMOS Input Compatibility, Il 1µA at VOL, VOH
- TPS3306-18 - 具有电源故障的双路处理器监控电路
- CD4093B - CMOS 四路 2 输入与非施密特触发器
- SN74LV32A-Q1 - 汽车类四路 2 输入正或门
- LM4041D - 可调节精密微功耗并联电压参考,1.0% 精确度
- BQ24113 - 采用 QFN 封装具有 2A FET 的 bqSWITCHER(TM) 同步开关模式锂离子充电器,为 1 节或 2 节系统控制版本
- CD74HC193 - 具有异步复位功能的高速 CMOS 逻辑可预设置的同步 4 位二进制加/减计数器
- LM2757 - 具有输出(停机时)的开关电容器升压稳压器
- CD4093B-MIL - CMOS 四路 2 输入与非施密特触发器
- TLV5637 - 10 位 1us DAC,具有串行输入、双路 DAC、可编程内部参考和稳定时间
- DRV8814 - 具有浪涌电流保护功能的 2.5A 双路刷式直流电机驱动器(PH/EN 控制器)



