PCA9555 - 具有中断输出和配置寄存器的远程 16 位 I2C 和 SMBus I/O 扩展器

PCA9555是TI德州仪器公司的一款I2CIO扩展器产品，PCA9555是具有中断输出和配置寄存器的远程 16 位 I2C 和 SMBus I/O 扩展器，本站介绍了PCA9555的封装应用图解、特点和优点、功能等，并给出了与PCA9555相关的TI元器件型号供参考。

PCA9555 - 具有中断输出和配置寄存器的远程 16 位 I2C 和 SMBus I/O 扩展器 - I2CIO扩展器 - I2C - 德州仪器

产品描述

This 16-bit I/O expander for the two-line bidirectional bus (I2C) is designed for 2.3-V to 5.5-V VCC operation. It provides general-purpose remote I/O expansion for most microcontroller families via the I2C interface [serial clock (SCL), serial data (SDA)].

The PCA9555 consists of two 8-bit Configuration (input or output selection), Input Port, Output Port, and Polarity Inversion (active high or active low operation) registers. At power on, the I/Os are configured as inputs. The system master can enable the I/Os as either inputs or outputs by writing to the I/O configuration bits. The data for each input or output is kept in the corresponding Input or Output register. The polarity of the Input Port register can be inverted with the Polarity Inversion register. All registers can be read by the system master.

The system master can reset the PCA9555 in the event of a timeout or other improper operation by utilizing the power-on reset feature, which puts the registers in their default state and initializes the I2C/SMBus state machine.

The PCA9555 open-drain interrupt (INT) output is activated when any input state differs from its corresponding Input Port register state and is used to indicate to the system master that an input state has changed.

INT can be connected to the interrupt input of a microcontroller. By sending an interrupt signal on this line, the remote I/O can inform the microcontroller if there is incoming data on its ports without having to communicate via the I2C bus. Thus, the PCA9555 can remain a simple slave device.

The device outputs (latched) have high-current drive capability for directly driving LEDs.

Although pin-to-pin and I2C-address is compatible with the PCF8575, software changes are required due to the enhancements.

The PCA9555 is identical to the PCA9535, except for the inclusion of the internal I/O pullup resistor, which pulls the I/O to a default high when configured as an input and undriven.

Three hardware pins (A0, A1, and A2) are used to program and vary the fixed I2C address and allow up to eight devices to share the same I2C bus or SMBus. The fixed I2C address of the PCA9555 is the same as the PCF8575, PCF8575C, and PCF8574, allowing up to eight of these devices in any combination to share the same I2C bus or SMBus.

产品特性

Low Standby-Current Consumption of 1μAMax
I2C to Parallel Port Expander
Open-Drain Active-Low Interrupt Output
5-V Tolerant I/O Ports
Compatible With Most Microcontrollers
400-kHz Fast I2C Bus
Address by Three Hardware Address Pins for Use of up to Eight Devices
Polarity Inversion Register
Latched Outputs With High-Current Drive Capability for Directly Driving LEDs
Latch-Up Performance Exceeds 100mA Per JESD78, ClassII
ESD Protection Exceeds JESD22
- 2000-V Human-Body Model (A114-A)
- 200-V Machine Model (A115-A)
- 1000-V Charged-Device Model (C101)

下面可能是您感兴趣的TI德州仪器公司I2CIO扩展器元器件

TI公司产品现货专家，订购TI公司产品不限最低起订量，TI芯片大陆现货即时发货，香港库存3-5天发货，海外库存7-10天发货

寻找全球TI代理商现货货源 - TI公司（德州仪器）电子元件在线订购