
- SN74ACT240PWLE - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- CD74HC373EG4 - 集成电路(IC) > 逻辑 > 锁存器
- EZ430-RF2500T - 开发板,套件,编程器 > 评估板 > 射频评估和开发套件,板
- TLV2470IDR - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- SN74ALVCH16501DLR - 集成电路(IC) > 逻辑 > 通用总线功能
- SN74ALVC125DR - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- LM49370RLX/NOPB - 集成电路(IC) > 线性 > 放大器 > 音频放大器
- LP38692EVAL - 开发板,套件,编程器 > 评估板 > 线性稳压器评估板
- ADS7822UBG4 - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- TDA4APE6T5AANDRQ1 - 集成电路(IC) > 嵌入式 > 微处理器
- PTB78520WAD - 板安装电源 > 直流转换器
- SRC4382EVM-PDK - 评估和演示板及套件
- LM101AJ - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- OPA336UA/2K5 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TWL6032A1BEYFFT - 集成电路(IC) > 电源管理(PMIC) > 电源管理 - 专用
- OPA2683IDCNT - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- ONET8521TY - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- DS560DF410AMNT - 集成电路(IC) > 接口 > 信号缓冲器、中继器、分离器
- TPS7E8125AQDBVRQ1 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- TL750L05CLPE3 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性



SN54ABT16841 - 具有三态输出的 20 位总线接口 D 类锁存器
SN54ABT16841是TI德州仪器公司的一款D类锁存器产品,SN54ABT16841是具有三态输出的 20 位总线接口 D 类锁存器,本站介绍了SN54ABT16841的封装应用图解、特点和优点、功能等,并给出了与SN54ABT16841相关的TI元器件型号供参考。
SN54ABT16841 - 具有三态输出的 20 位总线接口 D 类锁存器 - D类锁存器 - 触发器/锁存器/寄存器 - 德州仪器
These 20-bit latches feature 3-state outputs designed specifically for driving highly capacitive or relatively low-impedance loads. They are particularly suitable for implementing buffer registers, I/O ports, bidirectional bus drivers, and working registers.
The 'ABT16841 can be used as two 10-bit latches or one 20-bit latch. The 20 transparent D-type latches provide true data at the outputs. While the latch-enable (1LE or 2LE) input is high, the Q outputs of the corresponding 10-bit latch follow the D inputs. When LE is taken low, the Q outputs are latched at the levels set up at the D inputs.
A buffered output-enable (1OE\ or 2OE\) input can be used to place the outputs of the corresponding 10-bit latch in either a normal logic state (high or low logic levels) or a high-impedance state. In the high-impedance state, the outputs neither load nor drive the bus lines significantly.
The output-enable input does not affect the internal operation of the latches. Old data can be retained or new data can be entered while the outputs are in the high-impedance state.
When VCC is between 0 and 2.1 V, the device is in the high-impedance state during power up or power down. However, to ensure the high-impedance state above 2.1 V, OE\ should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
The SN54ABT16841 is characterized for operation over the full military temperature range of -55°C to 125°C. The SN74ABT16841 is characterized for operation from -40°C to 85°C.
- Members of the Texas Instruments WidebusTM Family
- State-of-the-Art EPIC-II BTM BiCMOS Design Significantly Reduces Power Dissipation
- ESD Protection Exceeds 2000 V Per MIL-STD-883, Method 3015; Exceeds 200 V Using Machine Model (C = 200 pF, R = 0)
- Latch-Up Performance Exceeds 500 mA Per JEDEC Standard JESD-17
- Typical VOLP (Output Ground Bounce) < 0.8 V at VCC = 5 V, TA = 25°C
- High-Impedance State During Power Up and Power Down
- Distributed VCC and GND Pin Configuration Minimizes High-Speed Switching Noise
- Flow-Through Architecture Optimizes PCB Layout
- High-Drive Outputs (-32-mA IOH, 64-mA IOL)
- Package Options Include Plastic 300-mil Shrink Small-Outline (DL) Package and 380-mil Fine-Pitch Ceramic Flat (WD) Package Using 25-mil Center-to-Center Spacings
Widebus and EPIC-IIB are trademarks of Texas Instruments Incorporated.
- TPS61060 - 具有白光 LED 亮度控制电源的 15V、400mA 开关,1MHz 升压转换器
- DS91D176 - 100 MHz 单通道 M-LVDS 收发器
- MSP430FR6889 - MSP430FR6889 混合信号微处理器
- TPS75233-Q1 - 汽车类快速瞬态响应稳压器
- TPS3839G12 - 150nA 超低电流、超小型电压监控器
- UCC38501 - BiCMOS PFC/PWM 组合控制器
- BQ24071 - Single-Chip Charge and System Power-Path Managment IC
- SN54ABT16601 - 具有三态输出的 18 位通用总线收发器
- CD74HC21 - 高速 CMOS 逻辑双路 4 输入与门
- LM317L-N - 3 端子可调节稳压器



