

- TPS7A4701RGWT - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- CD74HCT73EG4 - 集成电路(IC) > 逻辑 > 触发器
- CD4093BM96E4 - 集成电路(IC) > 逻辑 > 门和反相器
- 5962-8852001CA - 集成电路(IC) > 逻辑 > 触发器
- TLV2442QDG4 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- SNJ54LVT573FK - 集成电路(IC) > 逻辑 > 锁存器
- MSP430G2855IRHA40T - 集成电路(IC) > 嵌入式 > 微控制器
- LM5101CMA - 集成电路(IC) > 电源管理(PMIC) > 栅极驱动器
- O917A154TRGZTQ1 - 集成电路(IC) > 电源管理(PMIC) > 电源管理 - 专用
- 74FCT162646CTPACT - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- TLC2272IPG4 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- SN74S32D - 集成电路(IC) > 逻辑 > 门和反相器
- TLV74312PDQNR3 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- SN74LS86ANG4 - 集成电路(IC) > 逻辑 > 门和反相器
- SN74ALS644A-1DW - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- LM4132DMFX-4.1 - 集成电路(IC) > 电源管理(PMIC) > 电压基准
- TCA6408AQPWRQ1 - 集成电路(IC) > 接口 > I/O 扩展器
- UCC2813D-5 - 集成电路(IC) > 电源管理(PMIC) > DC-DC 开关控制器
- HPA00721DR - 电源管理IC - PFC(功率因数校正)
- SN74LVC244ARWPR - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器



SN54ABT823 - 具有三态输出的 9 位总线接口触发器
SN54ABT823是TI德州仪器公司的一款D类触发器产品,SN54ABT823是具有三态输出的 9 位总线接口触发器,本站介绍了SN54ABT823的封装应用图解、特点和优点、功能等,并给出了与SN54ABT823相关的TI元器件型号供参考。
SN54ABT823 - 具有三态输出的 9 位总线接口触发器 - D类触发器 - 触发器/锁存器/寄存器 - 德州仪器
These 9-bit flip-flops feature 3-state outputs designed specifically for driving highly capacitive or relatively low-impedance loads. They are particularly suitable for implementing wider buffer registers, I/O ports, bidirectional bus drivers with parity, and working registers.
With the clock-enable (CLKEN\) input low, the nine D-type edge-triggered flip-flops enter data on the low-to-high transitions of the clock. Taking CLKEN\ high disables the clock buffer, thus latching the outputs. Taking the clear (CLR\) input low causes the nine Q outputs to go low, independently of the clock.
A buffered output-enable (OE\) input can be used to place the nine outputs in either a normal logic state (high or low logic level) or a high-impedance state. In the high-impedance state, the outputs neither load nor drive the bus lines significantly. The high-impedance state and increased drive provide the capability to drive bus lines without need for interface or pullup components.
When VCC is between 0 and 2.1 V, the device is in the high-impedance state during power up or power down. However, to ensure the high-impedance state above 2.1 V, OE\ should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
The SN54ABT823 is characterized for operation over the full military temperature range of -55°C to 125°C. The SN74ABT823 is characterized for operation from -40°C to 85°C.
- State-of-the-Art EPIC-II BTM BiCMOS Design Significantly Reduces Power Dissipation
- ESD Protection Exceeds 2000 V Per MIL-STD-883, Method 3015; Exceeds 200 V Using Machine Model (C = 200 pF, R = 0)
- Latch-Up Performance Exceeds 500 mA Per JEDEC Standard JESD-17
- Typical VOLP (Output Ground Bounce) < 1 V at VCC = 5 V, TA = 25°C
- High-Impedance State During Power Up and Power Down
- High-Drive Outputs (-32-mA IOH, 64-mA IOL)
- Buffered Control Inputs to Reduce dc Loading Effects
- Package Options Include Plastic Small-Outline (DW) and Shrink Small-Outline (DB) Packages, Ceramic Chip Carriers (FK) and Flatpacks (W), and Standard Plastic (NT) and Ceramic (JT) DIPs
EPIC-IIB is a trademark of Texas Instruments Incorporated.
- TPS62172-Q1 - 采用 2x2 QFN 封装的 3-17V 0.5A 汽车类降压转换器
- CSD25213W10 - P 通道 NexFET? 功率 MOSFET,CSD25213W10
- SN65HVD05 - 高输出 RS-485 收发器
- CD4015B-MIL - CMOS 双路 4 级静态移位寄存器
- LP2997 - DDR-II 终止稳压器
- DS90UB914Q-Q1 - DS90UB913Q/4Q 10-100MHz 10/12 位 FPD-Link III 串行器/解串器
- DS90UH929-Q1 - DS90UH929-Q1 720p FPD-Link III 串行器
- TX810 - 用于超声波系统的 8 通道可编程 T/R 开关
- SN74LS673 - 具有输出存储寄存器的串行输入移位寄存器
- LM81 - 串行接口 ACPI 兼容微处理器系统硬件监控器



