

- LP2996MRX-NS - 集成电路(IC) > 电源管理(PMIC) > 电源管理 - 专用
- TLV2632IP - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TXU0104BQAR - 集成电路(IC) > 逻辑 > 转换器,电平移位器
- DAC088S085CISQX/NOPB - 集成电路(IC) > 数据采集 > 数模转换器(DAC)
- TMS5700432BPZQQ1 - 集成电路(IC) > 嵌入式 > 微控制器
- MSP430G2212IPW14 - 集成电路(IC) > 嵌入式 > 微控制器
- PTH05010WAST - 板安装电源 > 直流转换器
- MSP430F67481IPZ - 集成电路(IC) > 嵌入式 > 微控制器
- UCC3956N - 集成电路(IC) > 电源管理(PMIC) > 电池充电器
- SN74LVC06AQDRG4Q1 - 集成电路(IC) > 逻辑 > 门和反相器
- TAS5028PAG - 集成电路(IC) > 音频专用
- MAX208CDW - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- SN74LS374NSRG4 - 集成电路(IC) > 逻辑 > 触发器
- AFE1144E - 集成电路(IC) > 数据采集 > 模拟前端(AFE)
- TMCS1126B4AQDVGRQ1 - 传感器,变送器 > 电流传感器
- TLC274ID - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TMP303BDRLR - 传感器,变送器 > 温度传感器 > 温控器 - 固态
- LMC6042IMX - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- DAC8565ICPW - 集成电路(IC) > 数据采集 > 数模转换器(DAC)
- CD4043BPWG4 - 集成电路(IC) > 逻辑 > 锁存器



SN54ACT573 - 具有三态输出的八路 D 类透明锁存器
SN54ACT573是TI德州仪器公司的一款D类锁存器产品,SN54ACT573是具有三态输出的八路 D 类透明锁存器,本站介绍了SN54ACT573的封装应用图解、特点和优点、功能等,并给出了与SN54ACT573相关的TI元器件型号供参考。
SN54ACT573 - 具有三态输出的八路 D 类透明锁存器 - D类锁存器 - 触发器/锁存器/寄存器 - 德州仪器
These 8-bit latches feature 3-state outputs designed specifically for driving highly capacitive or relatively low-impedance loads. The devices are particularly suitable for implementing buffer registers, I/O ports, bidirectional bus drivers, and working registers.
The eight latches are D-type transparent latches. When the latch-enable (LE) input is high, the Q outputs follow the data (D) inputs. When LE is taken low, the Q outputs are latched at the logic levels set up at the D inputs.
A buffered output-enable (OE)\ input can be used to place the eight outputs in either a normal logic state (high or low logic levels) or the high-impedance state. In the high-impedance state, the outputs neither load nor drive the bus lines significantly. The high-impedance state and increased drive provide the capability to drive bus lines in a bus-organized system without need for interface or pullup components.
(OE)\ does not affect the internal operations of the latches. Old data can be retained or new data can be entered while the outputs are in the high-impedance state.
To ensure the high-impedance state during power up or power down, (OE)\ should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
- 4.5-V to 5.5-V VCC Operation
- Inputs Accept Voltages to 5.5 V
- Max tpd of 9.5 ns at 5 V
- Inputs Are TTL-Voltage Compatible
- TPS61025 - 采用 QFN-10 封装的 3.3V 输出 1.5A 开关 96% 效率升压转换器,具有 LDO 降压模式
- ADC12048 - 12 位 + 216 kHz 8 通道采样模数转换器
- CD4060B - CMOS 14 级纹波进位二进制计数器/除法器和振荡器
- DS3695A - 多点 RS485/RS422 收发器
- TL432 - 可调节精密并联稳压器
- SN54HC157-SP - 四路 2 线路至 1 线路数据选择器/多路复用器
- TPS51632 - 用于具有串行控制的 Tegra? CPU 的 3-2-1 相 D-Cap+TM 降压无驱动控制器
- LM113QML-SP - Reference Diode
- LM3644 - 双 1.5A 电流源相机闪光灯 LED 驱动器
- CY74FCT16500T - 具有三态输出的 18 位通用总线收发器



