

- TLE2141CD - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- LM431AIZ - 集成电路(IC) > 电源管理(PMIC) > 电压基准
- SN74HCS240QPWRQ1 - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- OPA337UA - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- 74ACT11032PWG4 - 逻辑 - 栅极和逆变器
- ADS7835EQDGKREP - 数据采集 - 模数转换器(ADC)
- LP5866RKPR - 集成电路(IC) > 电源管理(PMIC) > LED 驱动器
- LM3S808-EQN50-C2T - 集成电路(IC) > 嵌入式 > 微控制器
- REF3312AIDCKT - 集成电路(IC) > 电源管理(PMIC) > 电压基准
- DF1706E/2KG4 - 集成电路(IC) > 音频专用
- LM2575SX-15 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- LMR14050QDPRTQ1 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- DAC5674IPHPR - 集成电路(IC) > 数据采集 > 数模转换器(DAC)
- LP3853ESX-3.3 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- SN65LVDS17DRFTG4 - 集成电路(IC) > 接口 > 信号缓冲器、中继器、分离器
- LM4120AIM5X-1.8 - 集成电路(IC) > 电源管理(PMIC) > 电压基准
- LM20242MHE/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- TPS3305-33D - 集成电路(IC) > 电源管理(PMIC) > 监控器
- CC1150EMK-868 - 开发板,套件,编程器 > 评估板 > 射频评估和开发套件,板
- TL851CN - 射频和无线 > RF 其它 IC 和模块



SN54LS373 - 具有三态输出的八路 D 类透明锁存器
SN54LS373是TI德州仪器公司的一款D类锁存器产品,SN54LS373是具有三态输出的八路 D 类透明锁存器,本站介绍了SN54LS373的封装应用图解、特点和优点、功能等,并给出了与SN54LS373相关的TI元器件型号供参考。
SN54LS373 - 具有三态输出的八路 D 类透明锁存器 - D类锁存器 - 触发器/锁存器/寄存器 - 德州仪器
These 8-bit registers feature 3-state outputs designed specifically for driving highly capacitive or relatively low-impedance loads. The high-impedance 3-state and increased high-logic-level drive provide these registers with the capability of being connected directly to and driving the bus lines in a bus-organized system without need for interface or pullup components. These devices are particularly attractive for implementing buffer registers, I/O ports, bidirectional bus drivers, and working registers.
The eight latches of the LS373 and S373 are transparent D-type latches, meaning that while the enable (C or CLK) input is high, the Q outputs follow the data (D) inputs. When C or CLK is taken low, the output is latched at the level of the data that was set up.
The eight flip-flops of the LS374 and S374 are edge-triggered D-type flip-flops. On the positive transition of the clock, the Q outputs are set to the logic states that were set up at the D inputs.
Schmitt-trigger buffered inputs at the enable/clock lines of the S373 and S374 devices simplify system design as ac and dc noise rejection is improved by typically 400 mV due to the input hysteresis. A buffered output-control (OC) input can be used to place the eight outputs in either a normal logic state (high or low logic levels) or the high-impedance state. In the high-impedance state, the outputs neither load nor drive the bus lines significantly.
OC\ does not affect the internal operation of the latches or flip-flops. That is, the old data can be retained or new data can be entered, even while the outputs are off.
- Choice of Eight Latches or Eight D-Type Flip-Flops in a Single Package
- 3-State Bus-Driving Outputs
- Full Parallel Access for Loading
- Buffered Control Inputs
- Clock-Enable Input Has Hysteresis to Improve Noise Rejection (S373 and S374)
- P-N-P Inputs Reduce DC Loading on Data Lines (S373 and S374)
- TS5A6542 - 具有输入逻辑转换的 0.75Ω SPDT 模拟开关
- CDCM1802 - 具有可编程除法器和 LVPECL I/O + addl LVCMOS 输出的时钟缓冲器
- REG711-5 - 50mA 开关电容 DC/DC 转换器
- DRV612 - 具有可编程固定增益的 DirectPath? 2Vrms 线路驱动器
- UA78M09 - 3 引脚 500mA 固定 9V 正电压稳压器
- SN54ALS30A - 8 输入正与非门
- TL2575HV-15 - 具有输出使能端的 1A 简易步降开关稳压器
- TMS320F28062F - TMS320F28069F、TMS320F2806 8F、TMS320F28062F InstaSPIN-FOC
- TL751M08-Q1 - 汽车类单路输出 LDO、750mA、固定电压 (8.0V)、使能端、60V 负载突降保护
- TPS2561 - 双通道精密可调节限流电源开关



