The SN75LBC031 is a CAN transceiver used as an interface between a CAN controller and the physical bus for high speed applications of up to 500 kBaud. The device provides transmit capability to the differential bus and differential receive capability to the controller. The transmitter outputs (CANH and CANL), feature internal transition regulation to provide controlled symmetry resulting in low EMI emissions. Both transmitter outputs are fully protected against battery short circuits and electrical transients that can occur on the bus lines. In the event of excessive device power dissipation the output drivers are disabled by the thermal shutdown circuitry at a junction temperature of approximately 160°C. The inclusion of an internal pullup resistor on the transmitter input ensures a defined output during power up and protocol controller reset. For normal operation at 500 kBaud the ASC terminal is open or tied to GND. For slower speed operation at 125 kBaud the bus output transition times can be increased to reduce EMI by connecting the ASC terminal to VCC. The receiver includes an integrated filter that suppresses the signal into pulses less than 30 ns wide.

The SN75LBC031 is characterized for operation from -40°C to 85°C. The SN65LBC031 is characterized for operation from -40°C to 125°C. The SN65LBC031Q is characterized for operation over the automotive temperature range of -40°C to 125°C.

• SN75LBC031 Meets Standard ISO/DIS 11898 (up to 500 k Baud)
• Driver Output Capability at 50 mA
• Wide Positive and Negative Input/output Bus Voltage Range
• Bus Outputs Short-Circuit-Protected to Battery Voltage and Ground
• Thermal Shutdown
• Available in Q-Temp Automotive
  • HighRel Automotive Applications
  • Configuration Control/Print Support
  • Qualification to Automotive Standards

• VSP1900 - 8 通道垂直驱动器，用于具有电子快门的 CCD 传感器
• TAS5701 - 20W 立体声数字音频功率放大器（硬件控制）
• SN74AUC2G00 - 双路 2 输入正与非门
• TRF3701 - 0.14GHz 至 1.5GHz 正交调制器
• ADC12D040 - 具有内部/外部参考的双路 12 位、40 MSPS、600 mW A/D 转换器
• TLV2556 - 具有内部参考的 12 位 200KSPS 11 通道低功耗串行 ADC
• SN74BCT8245A - 具有八路总线收发器的 IEEE 标准 1149.1 (JTAG) 边界扫描测试设备
• ADS5440-EP - 增强型产品 13 位 210Msps 模数转换器
• SN65LVDS822 - SN65LVDS822 FLATLINK? LVDS 接收器
• CDCVF2505-Q1 - 具有扩频兼容性的汽车类 PLL 时钟驱动器，用于同步 DRAM 通 用 应用领域。