

- LM4876M/NOPB - 集成电路(IC) > 线性 > 放大器 > 音频放大器
- JM54AC86SDA-RH - 集成电路(IC) > 逻辑 > 门和反相器
- PCM2900BDB - 集成电路(IC) > 接口 > 编解码器
- MSP430FR5887IPM - 集成电路(IC) > 嵌入式 > 微控制器
- LMH6515SQ/NOPB - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- COP8SAA7SLB9 - 嵌入式 - 微控制器
- SN74HC04DBRG4 - 集成电路(IC) > 逻辑 > 门和反相器
- ISO7331CDWR - 隔离器 > 数字隔离器
- TPS62200DBVTG4 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- TMS320LC541PZ1-40 - 集成电路(IC) > 嵌入式 > DSP(数字信号处理器)
- ISO7331FCDWR - 隔离器 > 数字隔离器
- OPA2316ID - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TRF3761-EIRHAT - 集成电路(IC) > 时钟/定时 > 时钟发生器,PLL,频率合成器
- TLC4502CDR - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- LM60CIZ/NOPB - 传感器,变送器 > 温度传感器 > 模拟和数字输出
- TPS5100IPW - 集成电路(IC) > 电源管理(PMIC) > DC-DC 开关控制器
- UCC2801DG4 - 集成电路(IC) > 电源管理(PMIC) > DC-DC 开关控制器
- LM3S5D91-IQC80-A1T - 集成电路(IC) > 嵌入式 > 微控制器
- THVD8000TDDFR - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- ADS5411IPJYG3 - 集成电路(IC) > 数据采集 > 模数转换器(ADC)



SN74ALVC164245 - 具有三态输出的 16 位 2.5V 至 3.3V/3.3V 至 5V 电平转换收发器
SN74ALVC164245是TI德州仪器公司的一款应用特定电压转换产品,SN74ALVC164245是具有三态输出的 16 位 2.5V 至 3.3V/3.3V 至 5V 电平转换收发器,本站介绍了SN74ALVC164245的封装应用图解、特点和优点、功能等,并给出了与SN74ALVC164245相关的TI元器件型号供参考。
SN74ALVC164245 - 具有三态输出的 16 位 2.5V 至 3.3V/3.3V 至 5V 电平转换收发器 - 应用特定电压转换 - 电压电平转换 - 德州仪器
This 16-bit (dual-octal) noninverting bus transceiver contains two separate supply rails. B port has VCCB, which is set to operate at 3.3 V and 5 V. A port has VCCA, which is set to operate at 2.5 V and 3.3 V. This allows for translation from a 2.5-V to a 3.3-V environment, and vice versa, or from a 3.3-V to a 5-V environment, and vice versa.
The SN74ALVC164245 is designed for asynchronous communication between data buses. The control cirucitry (1DIR, 2DIR, 1OE\, and 2OE\) is powered by VCCA.
To ensure the high-impedance state during power up or power down, the output-enable (OE)\ input should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
The logic levels of the direction-control (DIR) input and the output-enable (OE)\ input activate either the B-port outputs or the A-port outputs or place both output ports into the high-impedance mode. The device transmits data from the A bus to the B bus when the B-port outputs are activated, and from the B bus to the A bus when the A-port outputs are activated. The input circuitry on both A and B ports always is active and must have a logic HIGH or LOW level applied to prevent excess ICC and ICCZ.
- Member of the Texas Instruments Widebus Family
- Max tpd of 5.8 ns at 3.3 V
- ±24-mA Output Drive at 3.3 V
- Control Inputs VIH/VIL Levels Are Referenced to VCCA Voltage
- Latch-Up Performance Exceeds 250 mA Per JESD 17
NOTE: New and improved versions of the SN74ALVC164245 are available. The new part numbers are SN74LVC16T245 and SN74LVCH16T245 and should be considered for new designs. Widebus is a trademark of Texas Instruments.
- CD74AC280 - 9 位奇偶校验发生器/校验器
- TPS61162 - 用于智能手机的双通道 WLED 驱动器
- DS90LV048A - 3V LVDS 四路 CMOS 差动线路接收器
- SN65LVDM050-Q1 - 汽车类双路 LVDS 发送器/接收器
- ADS8674 - 14 位、500 kSPS、4 通道和 8 通道、单电源 SAR 模数转换器 (ADC)
- SN65HVD251-Q1 - 汽车类 CAN 收发器
- BQ294524 - 用于 2 节串联和 3 节串联锂离子电池的过压保护
- MSP430F2013-EP - 增强型产品 16 位超低功耗微处理器,2kB 闪存、128B RAM、16 位 Σ-Δ A/D
- SN74GTL2010 - 10 位钳位电压
- TPS54283 - 2A DUAL NON-SYNCHRONOUS CONVERTER



