

- MSP430FR2633IRHBT - 集成电路(IC) > 嵌入式 > 微控制器
- REF7033QFKHT - 集成电路(IC) > 电源管理(PMIC) > 电压基准
- TMAG5273A1QDBVR - 传感器,变送器 > 磁性传感器 > 线性、罗盘(IC)
- TAS5012PFB - 集成电路(IC) > 音频专用
- LM84BIMQAX/NOPB - 传感器,变送器 > 温度传感器 > 模拟和数字输出
- THS4011CDGNRG4 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- BQ24230RGTR - 集成电路(IC) > 电源管理(PMIC) > 电池充电器
- SN74ALVC162334DGVR - 集成电路(IC) > 逻辑 > 通用总线功能
- TPS7B6750QPWPRQ1 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- TS5A23166YZPR - 集成电路(IC) > 接口 > 模拟开关,多路复用器,解复用器
- TPA3220DDWR - 集成电路(IC) > 线性 > 放大器 > 音频放大器
- PT6121C - 直流转换器
- REF3325ATDD1 - 集成电路(IC) > 电源管理(PMIC) > 电压基准
- TMS5703134DPGEQQ1 - 集成电路(IC) > 嵌入式 > 微控制器
- LM4820M-6 - 集成电路(IC) > 线性 > 放大器 > 音频放大器
- DCP020505U/1K - 板安装电源 > 直流转换器
- SN74GTLPH16927VR - 集成电路(IC) > 逻辑 > 转换器,电平移位器
- TPS650945A0RSKT - 集成电路(IC) > 电源管理(PMIC) > 特殊用途稳压器
- LMP2021MAEVAL/NOPB - 开发板,套件,编程器 > 评估板 > 运算放大器评估板
- CD74HC688NSR - 集成电路(IC) > 逻辑 > 比较器



SN74AVC16834 - 具有三态输出的 18 位通用总线驱动器
SN74AVC16834是TI德州仪器公司的一款通用总线驱动器(UBD)产品,SN74AVC16834是具有三态输出的 18 位通用总线驱动器,本站介绍了SN74AVC16834的封装应用图解、特点和优点、功能等,并给出了与SN74AVC16834相关的TI元器件型号供参考。
SN74AVC16834 - 具有三态输出的 18 位通用总线驱动器 - 通用总线驱动器(UBD) - 通用总线功能 - 德州仪器
A Dynamic Output Control (DOC) circuit is implemented, which, during the transition, initially lowers the output impedance to effectively drive the load and, subsequently, raises the impedance to reduce noise. Figure 1 shows typical VOL vs IOL and VOH vs IOH curves to illustrate the output impedance and drive capability of the circuit. At the beginning of the signal transition, the DOC circuit provides a maximum dynamic drive that is equivalent to a high-drive standard-output device. For more information, refer to the TI application reports, AVC Logic Family Technology and Applications, literature number SCEA006, and Dynamic Output Control (DOC) Circuitry Technology and Applications, literature number SCEA009.
This 18-bit universal bus driver is operational at 1.2-V to 3.6-V VCC, but is designed specifically for 1.65-V to 3.6-V VCC operation.
Data flow from A to Y is controlled by the output-enable (OE)\ input. The device operates in the transparent mode when the latch-enable (LE)\ input is low. The A data is latched if the clock (CLK) input is held at a high or low logic level. If LE\ is high, the A data is stored in the latch/flip-flop on the low-to-high transition of CLK. When OE\ is high, the outputs are in the high-impedance state.
To ensure the high-impedance state during power up or power down, OE\ should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
This device is fully specified for partial-power-down applications using Ioff. The Ioff circuitry disables the outputs, preventing damaging current backflow through the device when it is powered down.
- Member of the Texas Instruments Widebus Family
- DOC (Dynamic Output Control) Circuit Dynamically Changes Output Impedance, Resulting in Noise Reduction Without Speed Degradation
- Dynamic Drive Capability Is Equivalent to Standard Outputs With IOH and IOL of ±24 mA at 2.5-V VCC
- Overvoltage-Tolerant Inputs/Outputs Allow Mixed-Voltage-Mode Data Communications
- Ioff Supports Partial-Power-Down Mode Operation
- ESD Protection Exceeds JESD 22
- 2000-V Human-Body Model (A114-A)
- 200-V Machine Model (A115-A)
- Latch-Up Performance Exceeds 100 mA Per JESD 78, Class II
DOC and Widebus are trademarks of Texas Instruments.
- CD54HCT151 - 高速 CMOS 逻辑 8 输入多路复用器
- TPS2818-EP - 增强型产品单路高速 Mosfet 驱动器
- TPS70345 - 双路输出低压降 (LDO) 稳压器
- SN75DP129 - DisplayPort 至 TMDS 转换器
- MSP430G2112 - MSP430G2x52、MSP430G2x12 混合信号微处理器
- DAC3162 - 双通道、10/12 位、500MSPS 数模转换器 (DAC)
- ISO7220A-Q1 - 汽车类双通道 2/0 1Mbps 数字隔离器
- TMP411-Q1 - 具有 N 因数和串联电阻校正的汽车级 ±1°C 远程和本地温度传感器
- ADS1216 - 24 位模数转换器
- SN74AUC2GU04 - 双路反向器闸



