

- TL1963A-25DCQR - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- PT6406D - 板安装电源 > 直流转换器
- SN74ALVC7814-25DLR - 集成电路(IC) > 逻辑 > FIFO 存储器
- TMP75BQDRQ1 - 传感器,变送器 > 温度传感器 > 模拟和数字输出
- CD74HC367MT - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- TLV1117IKTTR - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- TPS65181BRGZR - 集成电路(IC) > 电源管理(PMIC) > 电源管理 - 专用
- LP3985ITL-3.2/NOPB - 电源管理IC - 稳压器 - 线性
- TL022CD - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- DS90LV031BTM/NOPB - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- TCAN1043HDMTTQ1 - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- REG101NA-2.8/3KG4 - 电源管理IC - 稳压器 - 线性
- THS7353PWR - 集成电路(IC) > 线性 > 放大器 > 视频放大器和模块
- TPS43331EVM - 开发板,套件,编程器 > 评估板 > DC/DC 和 AC/DC(离线)SMPS 评估板
- SN74HCT244QPWREP - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- ISO35DWG4 - 隔离器 > 数字隔离器
- TLV431BIDBVTG4 - 集成电路(IC) > 电源管理(PMIC) > 电压基准
- LM2833XMYEVAL - 开发板,套件,编程器 > 评估板 > DC/DC 和 AC/DC(离线)SMPS 评估板
- SN74ALS00ADG4 - 集成电路(IC) > 逻辑 > 门和反相器
- WDVC5510AZAVA2 - 嵌入式 - DSP(数字信号处理器)



SN74AVCAH164245 - 具有可配置电压转换的 16 位双电源总线收发器
SN74AVCAH164245是TI德州仪器公司的一款应用特定电压转换产品,SN74AVCAH164245是具有可配置电压转换的 16 位双电源总线收发器,本站介绍了SN74AVCAH164245的封装应用图解、特点和优点、功能等,并给出了与SN74AVCAH164245相关的TI元器件型号供参考。
SN74AVCAH164245 - 具有可配置电压转换的 16 位双电源总线收发器 - 应用特定电压转换 - 电压电平转换 - 德州仪器
This 16-bit (dual-octal) noninverting bus transceiver uses two separate configurable power-supply rails. The A-port is designed to track VCCA. VCCA accepts any supply voltage from 1.4 V to 3.6 V. The B-port is designed to track VCCB. VCCB accepts any supply voltage from 1.4 V to 3.6 V. This allows for universal low-voltage bidirectional translation between any of the 1.5-V, 1.8-V, 2.5-V, and 3.3-V voltage nodes.
The SN74AVCAH164245 is designed for asynchronous communication between data buses. The device transmits data from the A bus to the B bus or from the B bus to the A bus, depending on the logic level at the direction-control (DIR) input. The output-enable (OE)\ input can be used to disable the outputs so the buses are effectively isolated.
The SN74AVCAH164245 is designed so that the control pins (1DIR, 2DIR, 1OE\, and 2OE\) are supplied by VCCA.
Active bus-hold circuitry is provided to hold unused or floating data inputs at a valid logic level. Use of pullup or pulldown resistors with the bus-hold circuitry is not recommended.
To ensure the high-impedance state during power up or power down, OE\ should be tied to VCCA through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
This device is fully specified for partial-power-down applications using Ioff. The Ioff circuitry disables the outputs, preventing damaging current backflow through the device when it is powered down. If either VCC input is at GND, then both ports are in the high-impedance state.
- Member of the Texas Instruments Widebus Family
- DOC Circuitry Dynamically Changes Output Impedance, Resulting in Noise Reduction Without Speed Degradation
- Dynamic Drive Capability Is Equivalent to Standard Outputs With IOH and IOL of ±24 mA at 2.5-V VCC
- Control Inputs VIH/VIL Levels are Referenced to VCCA Voltage
- If Either VCC Input Is at GND, Both Ports Are in the High-Impedance State
- Overvoltage-Tolerant Inputs/Outputs Allow Mixed-Voltage-Mode Data Communications
- Ioff Supports Partial-Power-Down Mode Operation
- Fully Configurable Dual-Rail Design Allows Each Port to Operate Over the Full 1.4-V to 3.6-V Power-Supply Range
- Bus Hold on Data Inputs Eliminates the Need for External Pullup/ Pulldown Resistors
- Latch-Up Performance Exceeds 100 mA Per JESD 78, Class II
- ESD Protection Exceeds JESD 22
- 2000-V Human-Body Model (A114-A)
- 200-V Machine Model (A115-A)
- 1000-V Charged-Device Model (C101)
DOC and Widebus are trademarks of Texas Instruments.
- LM5104 - 具有自适应延迟的高电压半桥接闸极驱动器
- TAS5103 - 15W 立体声数字放大器功率级
- TPS22963C - 具有控制启动功能的小型、超低 rON 负载开关
- TPS3831E16 - 150nA 超低电流、超小型电压监控器
- TPS65072 - 面向导航系统的单芯片电源管理 IC (PMIC)
- SN65LVDS84A - Flatlink 发送器
- SN54S37 - 四路 2 输入正与非门
- SN74HC02 - 四路 2 输入正与非门
- DS8923A - 三态 RS-422 双路差动线路驱动器和接收器对
- TLC5930 - 12 通道 LED 驱动器



