
- LM75CIMMX-3/NOPB - 传感器,变送器 > 温度传感器 > 模拟和数字输出
- SN75175DR - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- LM3263TMX/NOPB - 集成电路(IC) > 电源管理(PMIC) > 特殊用途稳压器
- LM3880MFX-1AB/NOPB - 集成电路(IC) > 电源管理(PMIC) > 电源控制器,监视器
- DRV8880PWPR - 集成电路(IC) > 电源管理(PMIC) > 电机驱动器,控制器
- SN74ALVCH16820DGGR - 集成电路(IC) > 逻辑 > 触发器
- LMH6570MAX/NOPB - 集成电路(IC) > 接口 > 模拟开关 - 特殊用途
- F28P659SH6PTPQ1 - 集成电路(IC) > 嵌入式 > 微控制器
- PT7671A - 直流转换器
- UC2834QG3 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性稳压器控制器
- LM2587T-5.0 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- SN74LVTH16374DGGR - 集成电路(IC) > 逻辑 > 触发器
- XIO2000AIZZZ - 集成电路(IC) > 接口 > 专用
- LM4040EIM7-2.0/NOPB - 集成电路(IC) > 电源管理(PMIC) > 电压基准
- DLP481RE0FXM - 集成电路(IC) > 专用 IC
- THS4130CDRG4 - 线性器件 - 放大器 - 仪器、运算放大器、缓冲放大器
- THS4222DRG4 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TPS6208818YFPR - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- TSB82AF15TPZTEP - 集成电路(IC) > 接口 > 控制器
- TLV1812DSGR - 集成电路(IC) > 线性 > 比较器



SN74AVCB324245 - 具有可配置电压转换和三态输出的 32 位双电源总线收发器
SN74AVCB324245是TI德州仪器公司的一款应用特定电压转换产品,SN74AVCB324245是具有可配置电压转换和三态输出的 32 位双电源总线收发器,本站介绍了SN74AVCB324245的封装应用图解、特点和优点、功能等,并给出了与SN74AVCB324245相关的TI元器件型号供参考。
SN74AVCB324245 - 具有可配置电压转换和三态输出的 32 位双电源总线收发器 - 应用特定电压转换 - 电压电平转换 - 德州仪器
This 32-bit noninverting bus transceiver uses two separate configurable power-supply rails. The A port is designed to track VCCA. VCCA accepts any supply voltage from 1.4 V to 3.6 V. The B port is designed to track VCCB. VCCB accepts any supply voltage from 1.4 V to 3.6 V. This allows for universal low-voltage bidirectional translation between any of the 1.5-V, 1.8-V, 2.5-V, and 3.3-V voltage nodes.
The SN74AVCB324245 is designed for asynchronous communication between data buses. The device transmits data from the A bus to the B bus or from the B bus to the A bus, depending on the logic level at the direction-control (DIR) input. The output-enable (OE)\ input can be used to disable the outputs so the buses are effectively isolated.
The SN74AVCB324245 is designed so that the control pins (1DIR, 2DIR, 1OE\, and 2OE\) are supplied by VCCB.
To ensure the high-impedance state during power up or power down, OE\ shall be tied to VCCB through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
This device is fully specified for partial-power-down applications using Ioff. The Ioff circuitry disables the outputs, preventing damaging current backflow through the device when it is powered down. If either VCC input is at GND, both ports are in the high-impedance state.
- Member of the Texas Instruments Widebus+ Family
- DOC Circuitry Dynamically Changes Output Impedance, Resulting in Noise Reduction Without Speed Degradation
- Dynamic Drive Capability Is Equivalent to Standard Outputs With IOH and IOL of - ±24 mA at 3-V VCC - ±15 mA at 2.3-V VCC - ±9 mA at 1.65-V VCC - ±6 mA at 1.4-V VCC
- Control Inputs VIH/VIL Levels are Referenced to VCCB Voltage
- If Either VCC Input Is at GND, Both Ports Are in the High-Impedance State
- Inputs/Outputs Can Tolerate Up to 4.6 V, Which Allows Mixed-Voltage-Mode Data Communications
- Ioff Supports Partial-Power-Down Mode Operation
- Fully Configurable Dual-Rail Design Allows Each Port to Operate Over the Full 1.4-V to 3.6-V Power-Supply Range
- Latch-Up Performance Exceeds 100 mA Per JESD 78, Class II
- ESD Protection Exceeds JESD 22 - 2000-V Human-Body Model (A114-A) - 200-V Machine Model (A115-A) - 1000-V Charged-Device Model (C101)
DOC and Widebus+ are trademarks of Texas Instruments.
- SN74ALS841 - 具有三态输出的 10 位总线接口 D 类锁存器
- ISO7420 - 低功耗双通道隔离器
- SN74AUP2G14 - 低功耗双路施密特触发反向器
- BQ24072T - USB 供能的 1.5A 锂离子电池充电器和电源路径管理 IC
- TS5A22364 - 具有负轨功能的 0.65Ω 双路 SPDT 模拟开关
- UCC3801 - 低功耗 BiCMOS 电流模式 PWM
- CD54HCT173 - 具有三态输出的高速 CMOS 逻辑四路 D 类触发器
- LM20123 - 汽车级可选的 2.95-5.5V、3A、电流模式同步降压稳压器
- ADS7816 - 12 位高速微功率采样模数转换器
- SN54F374 - 具有三态输出的八路边沿 D 类触发器



