
- UCC27201ADDAR - 集成电路(IC) > 电源管理(PMIC) > 栅极驱动器
- FPDXSDUR-43USB/NOPB - 评估和演示板及套件
- CD74HCT393ME4 - 集成电路(IC) > 逻辑 > 计数器,除法器
- SN74ACT7811-20PN - 集成电路(IC) > 逻辑 > FIFO 存储器
- TPS6287B10VA0WRZVR - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- TUSB3410RHBR - 集成电路(IC) > 嵌入式 > 应用特定微控制器
- SN74LS00DRE4 - 集成电路(IC) > 逻辑 > 门和反相器
- 5962-8860701JA - 集成电路(IC) > 逻辑 > 移位寄存器
- OPA347SA/250 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- SN74CB3Q3345DGVR - 集成电路(IC) > 逻辑 > 信号开关,多路复用器,解码器
- SN65LVDT33DR - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- OPA2111KPG4 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- UCC5628FQPG4 - 接口 - 信号端接器
- LM2902KDBRG4 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TPS73250DCQR - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- TPS62102DRG4 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- SN65HVD09DGG - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- CD74HC4040NSR - 集成电路(IC) > 逻辑 > 计数器,除法器
- OPA2353UA/2K5 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- INA241A2QDRQ1 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器



SN74AVCBH324245 - 具有可配置电压转换和 3 态输出的 32 位双电源总线收发器
SN74AVCBH324245是TI德州仪器公司的一款应用特定电压转换产品,SN74AVCBH324245是具有可配置电压转换和 3 态输出的 32 位双电源总线收发器,本站介绍了SN74AVCBH324245的封装应用图解、特点和优点、功能等,并给出了与SN74AVCBH324245相关的TI元器件型号供参考。
SN74AVCBH324245 - 具有可配置电压转换和 3 态输出的 32 位双电源总线收发器 - 应用特定电压转换 - 电压电平转换 - 德州仪器
This 32-bit noninverting bus transceiver uses two separate configurable power-supply rails. The A port is designed to track VCCA. VCCA accepts any supply voltage from 1.4 V to 3.6 V. The B port is designed to track VCCB. VCCB accepts any supply voltage from 1.4 V to 3.6 V. This allows for universal low-voltage bidirectional translation between any of the 1.5-V, 1.8-V, 2.5-V, and 3.3-V voltage nodes.
The SN74AVCBH324245 is designed for asynchronous communication between data buses. The device transmits data from the A bus to the B bus or from the B bus to the A bus, depending on the logic level at the direction-control (DIR) input. The output-enable (OE)\ input can be used to disable the outputs, so the buses are effectively isolated.
The SN74AVCBH324245 is designed so that the control pins (1DIR, 2DIR, 1OE\, and 2OE\) are supplied by VCCB.
Active bus-hold circuitry is provided to hold unused or floating data inputs at a valid logic level. Use of pullup or pulldown resistors with the bus-hold circuitry is not recommended.
To ensure the high-impedance state during power up or power down, OE\ should be tied to VCCB through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
This device is fully specified for partial-power-down applications using Ioff. The Ioff circuitry disables the outputs, preventing damaging current backflow through the device when it is powered down. If either VCC input is at GND, both ports are in the high-impedance state.
- Member of the Texas Instruments Widebus+ Family
- DOC Circuitry Dynamically Changes Output Impedance, Resulting in Noise Reduction Without Speed Degradation
- Dynamic Drive Capability Is Equivalent to Standard Outputs With IOH and IOL of
- ±24 mA at 3-V VCC
- ±15 mA at 2.3-V VCC
- ±9 mA at 1.65-V VCC
- ±6 mA at 1.4-V VCC
- Control Inputs VIH/VIL Levels Are Referenced to VCCB Voltage
- If Either VCC Input Is at GND, Both Ports Are in the High-Impedance State
- Inputs/Outputs Can Tolerate Up To 4.6 V, Which Allows Mixed-Voltage-Mode Data Communications
- Ioff Supports Partial-Power-Down Mode Operation
- Fully Configurable Dual-Rail Design Allows Each Port to Operate Over Full 1.4-V to 3.6-V Power-Supply Range
- Bus Hold on Data Inputs Eliminates the Need for External Pullup/Pulldown Resistors
- Latch-Up Performance Exceeds 100 mA Per JESD 78, Class II
- ESD Protection Exceeds JESD 22
- 2000-V Human-Body Model (A114-A)
- 200-V Machine Model (A115-A)
- 1000-V Charged-Device Model (C101)
DOC and Widebus+ are trademarks of Texas Instruments.
- BQ24061 - 具有热调节、CE、6.5V OVP 的单节锂电池充电器
- MSP430F2471 - 16 位超低功耗微控制器,具有 32KB 闪存、4KB RAM、2 个 USCI 和 HW 乘法器
- TPS40090-Q1 - 汽车类 4 通道多相 DC/DC 降压控制器
- CD54HC4052 - 高速 CMOS 逻辑模拟多路复用器/多路解复用器
- DLP4500 - DLP 0.45 WXGA DMD
- TLC320AC02 - 单通道编解码器 - 带宽独立于采样速率
- TPS2065C - 单通道、限流 USB 配电开关
- TLC59284 - 具有开关延迟的 16 通道恒流 LED 驱动器
- DS90UH925AQ-Q1 - 具有 HDCP 的 5 到 85 MHz 24 位彩色 FPD-Link III 串行器
- BQ76930 - bqMAXIMO:用于 5/10/15 系列锂离子和磷酸盐电池的 μC 控制 AFE 系列



