

- LM4128AQ1MF2.0/NOPB - 集成电路(IC) > 电源管理(PMIC) > 电压基准
- SN65LBC180ADG4 - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- SN74LV8T244PWR - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- DAC8552EVM - 开发板,套件,编程器 > 评估板 > 数模转换器(DAC)评估板
- BQ24296MRGET - 集成电路(IC) > 电源管理(PMIC) > 电池充电器
- LP38692MPX-2.5/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- TPS59603QDSGRQ1 - 集成电路(IC) > 电源管理(PMIC) > 电源管理 - 专用
- TPS3899DL01DSERQ1 - 集成电路(IC) > 电源管理(PMIC) > 监控器
- TAS5720LRSMT - 集成电路(IC) > 线性 > 放大器 > 音频放大器
- TLC072AIDG4 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- AMC1311DWV - 集成电路(IC) > 线性 > 放大器 > 特殊用途放大器
- OPA445AU - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- SN74ALS30ADB - 集成电路(IC) > 逻辑 > 门和反相器
- TNETV2685FIDZUT7 - 嵌入式 - DSP(数字信号处理器)
- TCAN1051GVDRQ1 - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- PGA308AIDGSRG4 - 集成电路(IC) > 接口 > 传感器和检测器接口
- SN74AUP1G125DPWR - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- TMDSHV1PHINVKIT - 开发板,套件,编程器 > 评估板 > 评估和演示板及套件
- MSP430F5338IPZ - 集成电路(IC) > 嵌入式 > 微控制器
- LM234Z-6/NOPB - 集成电路(IC) > 电源管理(PMIC) > 电流调节/管理



SN74HC563 - 具有三态输出的八路透明 D 类锁存器
SN74HC563是TI德州仪器公司的一款D类锁存器产品,SN74HC563是具有三态输出的八路透明 D 类锁存器,本站介绍了SN74HC563的封装应用图解、特点和优点、功能等,并给出了与SN74HC563相关的TI元器件型号供参考。
SN74HC563 - 具有三态输出的八路透明 D 类锁存器 - D类锁存器 - 触发器/锁存器/寄存器 - 德州仪器
These 8-bit transparent D-type latches feature 3-state outputs designed specifically for driving highly capacitive or relatively low-impedance loads. They are particularly suitable for implementing buffer registers, I/O ports, bidirectional bus drivers, and working registers.
While the latch-enable (LE) input is high, the Q\ outputs follow the complements of the data (D) inputs. When LE is taken low, the outputs are latched at the inverses of the levels set up at the D inputs.
A buffered output-enable (OE)\ input places the eight outputs in either a normal logic state (high or low logic levels) or the high-impedance state. In the high-impedance state, the outputs neither load nor drive the bus lines significantly. The high-impedance state and increased high logic level provide the capability to drive bus lines without interface or pullup components.
To ensure the high-impedance state during power up or power down, OE\ should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
OE\ does not affect internal operations of the latches. Old data can be retained or new data can be entered while the outputs are in the high-impedance state.
- Wide Operating Voltage Range of 2 V to 6 V
- High-Current 3-State Outputs Drive Bus Lines Directly or Up To 15 LSTTL Loads
- Low Power Consumption, 80-µA Max ICC
- Typical tpd = 21 ns
- ±6-mA Output Drive at 5 V
- Low Input Current of 1 µA Max
- Bus-Structured Pinout
- DRV8804 - 2.0A 单极步进电机驱动器或四螺线管/中继驱动器(串行控制器)
- PCM4202-EP - 118dB SNR 立体声音频 ADC(延长认证有效期)
- SN55110A - 双路线路驱动器
- CD54HCT20 - 高速 CMOS 逻辑双路 4 输入与非门
- UCC27517 - 4A/4A 单通道高速低侧闸极驱动器
- LM74A - 具有 Microwire 和 SPI 接口的 ±3°C 芯片式温度传感器
- SN54LS51 - 与或反向门
- MSP430F47193 - 16 位超低功耗微处理器,具有 120KB 闪存、4KB RAM、3 个 Σ-Δ ADC 和 LCD 驱动器
- SN74AS161 - 同步 4 位二进制计数器
- UC3856 - 改进的电流模式 PWM 控制器



