

- SN74HC251PW - 集成电路(IC) > 逻辑 > 信号开关,多路复用器,解码器
- SN65HVD35D - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- LMR16006YQ3DDCTQ1 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- LP3875ES-ADJ - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- TMX320C6472CZTZ7 - 嵌入式 - DSP(数字信号处理器)
- COP8-EMFA-68N - 开发板编程器配件
- TLV2474AING4 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- BUF01900AIPW - 集成电路(IC) > 线性 > 放大器 > 视频放大器和模块
- INA129UA/2K5E4 - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- SN75DP159RGZR - 集成电路(IC) > 线性 > 视频处理
- TPD1E0B04DPYEVM - 开发板,套件,编程器 > 评估板 > 评估和演示板及套件
- SN74LS652DWR - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- TL750L12CKC - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- PCI4510AZHK - 集成电路(IC) > 专用 IC
- SN74AS4374BN - 集成电路(IC) > 逻辑 > 触发器
- UA78L09ACLPE3 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- TPS3510DR - 集成电路(IC) > 电源管理(PMIC) > 监控器
- TPS62203EVM-211 - 开发板,套件,编程器 > 评估板 > DC/DC 和 AC/DC(离线)SMPS 评估板
- ISO7242ADWR - 隔离器 > 数字隔离器
- LP3855EMPX-ADJ/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性



SN74LV374A-Q1 - 汽车类具有三态输出的八路边沿 D 类触发器
SN74LV374A-Q1是TI德州仪器公司的一款D类触发器产品,SN74LV374A-Q1是汽车类具有三态输出的八路边沿 D 类触发器,本站介绍了SN74LV374A-Q1的封装应用图解、特点和优点、功能等,并给出了与SN74LV374A-Q1相关的TI元器件型号供参考。
SN74LV374A-Q1 - 汽车类具有三态输出的八路边沿 D 类触发器 - D类触发器 - 触发器/锁存器/寄存器 - 德州仪器
The SN74LV374A is an octal edge-triggered D-type flip-flop designed for 2-V to 5.5-V VCC operation.
This device features 3-state outputs designed specifically for driving highly capacitive or relatively low-impedance loads. It is particularly suitable for implementing buffer registers, I/O ports, bidirectional bus drivers, and working registers.
On the positive transition of the clock (CLK) input, the Q outputs are set to the logic levels set up at the data (D) inputs.
A buffered output-enable (OE) input can be used to place the eight outputs in either a normal logic state (high or low logic levels) or high-impedance state. In the high-impedance state, the outputs neither load nor drive the bus lines significantly. The high-impedance state and the increased drive provide the capability to drive bus lines without need for interface or pullup components.
OE does not affect internal operations of the latch. Old data can be retained or new data can be entered while the outputs are in the high-impedance state.
To ensure the high-impedance state during power up or power down, OE\ should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
This device is fully specified for partial-power-down applications using Ioff. The Ioff circuitry disables the outputs, preventing damaging current backflow through the device when it is powered down.
- Qualified for Automotive Applications
- Typical VOLP (Output Ground Bounce) <0.8 V at VCC = 3.3 V, TA = 25°C
- Typical VOHV (Output VOH Undershoot) >2 V at VCC = 3.3 V, TA = 25°C
- Supports Mixed-Mode Signal Operation on All Ports
- Ioff Supports Partial-Power-Down Mode Operation
- ESD Protection Exceeds JESD 22
- 2000-V Human-Body Model (A114-A)
- 200-V Machine Model (A115-A)
- 1000-V Charged-Device Model (C101)
- SN74CB3Q3306A - 双路 FET 2.5V/3.3V 低电压高带宽总线开关
- TPS54972 - 9A 有源总线终端/DDR 内存 DC/DC 转换器
- DS36C278 - 低功耗多点 TIA/EIA-485 收发器
- TPS3838L30-Q1 - 具有 10ms/200ms 可选择延迟时间的汽车类 220nA 监控器
- UCD90160 - 具有 ACPI 支持的 16 轨电源序列发生器
- TPS2490 - 可锁存正高电压功率有限热插拔控制器
- SN65LVDS22 - 双路多路复用 LVDS 中继器
- CD74AC161 - 具有异步复位的同步可预设的二进制计数器]]
- TPS62004-Q1 - 汽车类高效步降低功耗 DC-DC 转换器
- MSP430G2403 - MSP430G2x33、MSP430G2x03 混合信号微处理器



