

- 74CBTK16245DGGRG4 - 逻辑 - 信号开关,多路复用器,解码器
- TPS7B8350QDCYRQ1M3 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- TPS3840DL45DBVR - 集成电路(IC) > 电源管理(PMIC) > 监控器
- PCM56P - 集成电路(IC) > 数据采集 > ADC/DAC - 特殊用途
- TUSB1210BRHBT - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- SN74AS622DW - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- SN74LS165ANSR - 集成电路(IC) > 逻辑 > 移位寄存器
- LM3940ISX-3.3/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- LM1117MPX-3.3/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- LM5168PEVM - 开发板,套件,编程器 > 评估板 > DC/DC 和 AC/DC(离线)SMPS 评估板
- LP38502SDE-ADJ/NOPB - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- SNJ54H11W - 集成电路(IC) > 逻辑 > 门和反相器
- OPA4277UA - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- TLE2024MDWG4 - 线性器件 - 放大器 - 仪器、运算放大器、缓冲放大器
- ADS1178IPAPT - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- LM4816MTX/NOPB - 集成电路(IC) > 线性 > 放大器 > 音频放大器
- TLIN1029AMDRBRQ1 - 集成电路(IC) > 接口 > 驱动器,接收器,收发器
- LMV721M5X - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- SN74AS640NSR - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- CC3100MODBOOST - 开发板,套件,编程器 > 评估板 > 射频评估和开发套件,板



SN74LVTH373 - 具有三态输出的 3.3V ABT 八路透明 D 类锁存器
SN74LVTH373是TI德州仪器公司的一款D类锁存器产品,SN74LVTH373是具有三态输出的 3.3V ABT 八路透明 D 类锁存器,本站介绍了SN74LVTH373的封装应用图解、特点和优点、功能等,并给出了与SN74LVTH373相关的TI元器件型号供参考。
SN74LVTH373 - 具有三态输出的 3.3V ABT 八路透明 D 类锁存器 - D类锁存器 - 触发器/锁存器/寄存器 - 德州仪器
These octal latches are designed specifically for low-voltage (3.3-V) VCC operation, but with the capability to provide a TTL interface to a 5-V system environment.
While the latch-enable (LE) input is high, the Q outputs follow the data (D) inputs. When LE is taken low, the Q outputs are latched at the logic levels set up at the D inputs.
A buffered output-enable (OE)\ input can be used to place the eight outputs in either a normal logic state (high or low logic levels) or the high-impedance state. In the high-impedance state, the outputs neither load nor drive the bus lines significantly. The high-impedance state and increased drive provide the capability to drive bus lines without need for interface or pullup components.
OE\ does not affect the internal operations of the latches. Old data can be retained or new data can be entered while the outputs are in the high-impedance state.
When VCC is between 0 and 1.5 V, the devices are in the high-impedance state during power up or power down. However, to ensure the high-impedance state above 1.5 V, OE\ should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
Active bus-hold circuitry holds unused or undriven inputs at a valid logic state. Use of pullup or pulldown resistors with the bus-hold circuitry is not recommended.
These devices are fully specified for hot-insertion applications using Ioff and power-up 3-state. The Ioff circuitry disables the outputs, preventing damaging current backflow through the devices when they are powered down. The power-up 3-state circuitry places the outputs in the high-impedance state during power up and power down, which prevents driver conflict.
- Support Mixed-Mode Signal Operation (5-V Input and Output Voltages With 3.3-V VCC)
- Typical VOLP (Output Ground Bounce) <0.8 V at VCC = 3.3 V, TA = 25°C
- Support Unregulated Battery Operation Down to 2.7 V
- Ioff and Power-Up 3-State Support Hot Insertion
- Bus Hold on Data Inputs Eliminates the Need for External Pullup/Pulldown Resistors
- Latch-Up Performance Exceeds 500 mA Per JESD 17
- ESD Protection Exceeds JESD 22
- 2000-V Human-Body Model (A114-A)
- 200-V Machine Model (A115-A)
- TPS2378 - High Efficiency IEEE 802.3at PD Controller with Integrated DC/DC
- INA195A-Q1 - 汽车级、-16V 至 +80V、低侧/高侧、高速、电压输出电流分流监控器
- LM2940C - 1A 低压降稳压器
- SN75LVDS051 - 高速差动线路驱动器和接收器
- MSP430F6725A - MSP430F673xA、MSP430F672xA 混合信号微控制器
- TPS54319 - 2.95V 至 6V 输入、3A 同步降压转换器
- CSD17577Q5A - CSD17577Q5A
- TL16C550D - 具有自动流控制的异步通信元件
- SN74AS298A - 具有存储器的四路 2 输入 多路复用器
- TPS2592AL - 5V/12V eFuse with Integrated Blocking FET Driver



